Yamaha Phazer

[@YammiePro]

Looks way better now! I pull the clutch and take the whole oil injection unit off, gear can stay on the crank, homemade torque arm will keep that motor from hopping around lol

[@phazerworld6300]

There’s a loose bolt on the clutch side motor mount and will pull the motor to tighten it, no big deal

[@phazerworld6300]

I'm working on pulling the pump all the way off, I have the motor out so I'll fix that looses bolt at the same time, new video coming on a phazer motor swap

[@phazerworld6300]

Well now this motor is going in a new sled I got, all that work for nothing?

[@doubleridermt.8924]

I have the same year sled just rebuilt the carbs starts and idles fine but won't rev past three k rpms any ideas

[@phazerworld6300]

Smells like gas? Check to make sure the rubber plugs are good and in the right holes, check plugs too

[@phazerworld6300]

rubber plugs in wrong holes

[@doubleridermt.8924]

Thanks for the advice got it rippin

[@phazerworld6300]

@@doubleridermt.8924 That’s just great!

[@yunlew4606]

what fuel/oil ratio did you run after bypassing the oil injection ?

[@phazerworld6300]

50:1. It keep an eye on the plugs, also we don’t ride WOT out here it’s more on and off, if you pin it a lot go more oil