Just want to stop back in and say thank you. I helped a neighbor get a 2006 vstar 650 back on the road thanks to your video. The bike was a bit of a basket case when I started but this was the last piece. The bike would idle perfectly but as soon as you applied throttle it would bog and die. It shows as a lean condition and a carb issue. That motor, like some others, does require a specific vacuum range for the main fuel circuit to function properly. A lot of good is going to come from this simple video and getting this bike running. Thank you!
@bamaboysmith27232 жыл бұрын
Thx brother, glad i could help!!! It seems to have helped lots of folks out of a jam. If not for my old 1st car, 1984 fiero, that would not run with the intake cover off i never would have figured it out. Thx again!!!
@djpmnyc Жыл бұрын
Thank YOU SO MuCH FOR THIS VIDEO, just got my carbs back from the shop, was running bad.. hooked up the air intakes, good as new!! You’re an angel 😇
@bamaboysmith2723 Жыл бұрын
Glad I could help!!
@peterosinski84 Жыл бұрын
Thank you for your video. Such a simple issue causes a bigger problem.
@vincentbutton59264 жыл бұрын
It looks like this was my problem also. Running smooth again. I'll take it for a longer spin just to make sure. Thank you!!
@bamaboysmith27234 жыл бұрын
Glad it helped you my friend
@ronerie2 жыл бұрын
Thanks for the tip !!! Ill put that in my mental toolbox !!! I had read about cracks in the boots below the carbs, and also rubbing spit, on the boots sealing lips when re-installing the carbs so they slip in easier and the spit dries out so the carbs don't vibrate loose which is another problem, if you lube with oil or the like. I will definitely remember this tip because like the rest it is so simple it is easily missed. Too easy to over think some problems ! Bet you gave yourself a big ole pat on the back when you resolved this issue !!! Yee Haaa, lets Ride !!! Thanks Again !!!!!
@bamaboysmith27232 жыл бұрын
Lol...yes i did!!!! Hope this will help in the future, and stay safe brother...
@jasonwhite7226 Жыл бұрын
Thank you so much ol boy!
@christianfoster84002 жыл бұрын
Awesome video! I just got a 2005 V-star 650 and was researching anything potential problems in the future.
@bamaboysmith27232 жыл бұрын
This one about drove me nuts!! Lol...hope this helps my friend
@jamesconner34372 жыл бұрын
This is what makes carbureted engines "interesting" let's say. There are so many places for vacuum leaks and blocked carburetor air/gas holes . You might spend 5 minutes , or maybe 5 hours chasing the problem.
@boricuaarecibo92593 жыл бұрын
I'm going to try that now I don't care that it's 9:40 pm on a Tuesday
@bamaboysmith27233 жыл бұрын
Let me know how it turns out my friend
@louiegomez59452 жыл бұрын
thanks man, i'm having the same issue. defiantly gonna try this
@jamesmartinez1773 жыл бұрын
This shit literally happened to me right now while i was about to sell it. Limped it back home with choke wide open and tightened the aircleaner hose back up n what do u know. Back to running like a top..... Lost out on a sale. Guess it was a sign not to get rid of her
@bamaboysmith27233 жыл бұрын
I'm glad it fixed it. I have had so many people thanking me for the finding of this issue. I almost gave up and took her in.. glad you found it!!
@philspaseo23772 жыл бұрын
I have a 07 vstar. Carbs rebuilt. Fuel filter is flowing gas through the lines. Air filter seems okay. Would not accelerate past 60mph, if I give it full throttle in gear the bike would not accelerate past 60mph and it would start to die down/bog out. It sounded like a large exhaust leak(like there was no seal in the front headers) at full open throttle down the highway, the difference between half throttle and full throttle is huge. Idles fine and giving it full throttle during idle wouldn’t make the noise as it would if it was in gear. Obvious lean condition, front pipe headers are turning blue, motor running really hot, battery not holding a charge if key was in off for more than a minute, wasting more gas than usual, small but noticeable ticking noise.
@bamaboysmith27232 жыл бұрын
So I think it's what you said. The bike running lean, could also be a a intake leak. I would double check the air box though. Sucking in unfiltered air, even a small amount will cause this. This will also cause a lean condition.
@bamaboysmith27232 жыл бұрын
Did this tip fix it ?
@reesemcneal4 жыл бұрын
Thank you so much this is exactly what my bike is doing and for the life of me I couldn’t figure it out
@bamaboysmith27234 жыл бұрын
Did it fix it
@reesemcneal4 жыл бұрын
BAMA BOY SMITH I’m going to find out tomorrow it’s late and cold as shit right now
@bamaboysmith27234 жыл бұрын
@@reesemcneal it will be the fix...just make sure the big clamp is tight..u will know immediate also
@reesemcneal4 жыл бұрын
BAMA BOY SMITH I have one question when at idle did it run beautiful? I had the carbs rebuilt a couple weeks ago. However it just has no acceleration only a slow climb through the gears. In neutral it runs through the RPMs perfectly
@bamaboysmith27234 жыл бұрын
@@reesemcneal that could be a jet issue..but try the air box..is it leaking gas
@robertpelletier91082 жыл бұрын
I needed this video thanks 🙏
@bamaboysmith27232 жыл бұрын
Glad I could help
@edwardholland3402 жыл бұрын
Thanks for your help
@sageoliver32553 жыл бұрын
Wow! Great idea...another video talked about that too...his screws had wallowed out on a 98 and was breaking the seal I’ll try that tomorrow! Great video!
@bamaboysmith27233 жыл бұрын
Thank you
@Joshua403 ай бұрын
dude.... you just saved my ass.
@rickpursley3 жыл бұрын
Hey there, great video's. I have a 2000 vstar 650 that had been sitting for a while. Had the carbs cleaned and it will run but, I haven't gotten it out on the road yet. I noticed that the choke cable did not work, ordered a new one and installed but it doesn't move. I checked the connections back to the carbs and it doesn't move. Wondering it has glazed up from sitting and it that is the case is there a way to get them to release short of taking the carbs out? Appreciate your help.
@bamaboysmith27233 жыл бұрын
Make sure all the parts connecting and line running to the choke are connected correctly. Mine did this once and it loose where the tension bracket is
@calebmeeker83363 жыл бұрын
If anything use some wd-40 and check and see if your enrichmener is fucked
@Beeskness2 жыл бұрын
Did you end up fixing the issue?
@unstoppableking3235Ай бұрын
i have a 1999 yahmaha vstar 650cc classic and everything when i start it and its idling once i lean to the left the engine shuts off
@bamaboysmith2723Ай бұрын
@@unstoppableking3235 again I would make sure the air intakes are sealed well and even check the fuel lines to make sure one is not being pinched. Could also be a float in the cabs getting stuck when you lean it over
@crankbrothersvlog30268 күн бұрын
im having problem with my vstar... if it reach half trottle it boggs out. is that same problem with yours?
@bamaboysmith27238 күн бұрын
@@crankbrothersvlog3026 yes if the air box is not sealed wright it will cause this for sure. It’s that or the carbs. More than likely the air box though
@KennyG2333 жыл бұрын
change the 2 main jets from a # 90 to a #92.5 and it will stop being so lean
@bamaboysmith27233 жыл бұрын
I sold the bike, but it was just the air box not being correctly put back on. It lost vacuum and would not pull enough air to mix correctly with fuel. Once I put it back on the correct way it ran fine
@warrenalbert93364 жыл бұрын
What is that horrible noise when you give it the gas. Sounds like the starter is caught and being forced to turn over when you give it the rpms.
@bamaboysmith27234 жыл бұрын
Thats really cold weather and a cold engine. You obviously dont have this model
@warrenalbert93364 жыл бұрын
@@bamaboysmith2723 I dont know what you have, I have a 2007 650 V star
@bamaboysmith27234 жыл бұрын
@@warrenalbert9336 it's a 2000 model. Just bad sound I think with my phone...
@boricuaarecibo92593 жыл бұрын
My problem with my 99 vstar it won't idle it stalls I have to keep giving it throttle
@bamaboysmith27233 жыл бұрын
Make sure your idle screw is not turned down to low. MAKE SURE YOUR ADJUSTING THE CORRECT SCREW...dont mess with the carb sync screws..also your smallest jet could have crap in it. Run some seafoam thru her, after checking the intake housing as I explained.
@philspaseo23772 жыл бұрын
Where are these screws? Are these suppose to be tight all the way through?
@kilowatttheorignal4 жыл бұрын
Well mine isn't overflowing fuel it isn't getting enough its still getting in the carb but its not enough
@bamaboysmith27234 жыл бұрын
I would still check the seal. I'm not sure. I think mine was flooding one time and starving for fuel the next. Fixing the breather box cured it.
@bamaboysmith27234 жыл бұрын
I would also check your fuel filter. Could have trash in it
@kilowatttheorignal4 жыл бұрын
@@bamaboysmith2723 i am going to check the filter because sense it was sitting the fuel line dissolved a bit and it was gunked up
@bamaboysmith27234 жыл бұрын
@@kilowatttheorignal also even small amounts of rust can clog up the jets. If you take the side off the cards be care not to strip the bolt heads. I went ahead and just got more from my local hardware store. I think they are 5mm. Cleaning the jets is easy. Just do not turn the card sync knob in the middle. It will cause one carb to use more or less fuel than the other. Simple job on these bikes to clean the jets though..
@kilowatttheorignal4 жыл бұрын
@@bamaboysmith2723 i already took the carb apart yesterday there was alge but luckily no rust yet so I cleaned it up and if the carbs get out of sync I have a carburetor sync tool pain its a pain tho