You Must Calibrate Your CNC for BEST Performance!

[@newsfan77]

Would using a larger travel distance, give you more accurate calculation? Say move 500mm

[@PawPawsWorkShop]

Yes the larger the distance the better.

[@ericeinsmann5559]

Very useful! I need to dust off my Proverxl and expand it.. Thanks!

[@PawPawsWorkShop]

Absolutely, dust it off and get carving. But, don’t stop your pen turning.

[@ericeinsmann5559]

@@PawPawsWorkShop I haven't started pen turning yet.. I just got the material to make the new lathe cart..

[@catfisherboy]

Iwas about ready to throw away my XE pro, until I re calibrated my 'Z' axes It was plunging into the workspace so far it would stop the machine before I could hit the Emergency----I hads been serching for weeks for a solution. I hope the first thing everyone would do, is check the calibration and all 3 axes, a wored to the wise thanks for all your great videos

[@PawPawsWorkShop]

If I may ask, how did it out of calibration?

[@asda5303]

I recently watched ur video on how to do this on ur xcarve in Easel, i have a longmill and use Easel but use gsender as my post processor. Will the calbration steps done in easel correct my machine if I use gsender?

[@PawPawsWorkShop]

Yes, the calibration process is the same