Just a note, less screws on the exterior wall means less wall strength both in pressure from inside out and from lateral force. A smooth surface looks nice but unless its a wall of fiberglass, it weaker than screwed at the vertical supports. A wall with less screws will tend to buckle and warp over time as that aluminum is subjected to temps and road movement.
@MrSmurf4592 ай бұрын
This is actually one of the better videos that basically dumbs down all the trailer terminology that I once didn’t know!
@OffroadCpl6 ай бұрын
My experience with Darkhorse, rv door latch already replaced and cheap plastic door holder broke in light wind.
@drbwhit9 ай бұрын
Hey brother in all sincerity I know nothing about trailers but have a side-by-side and 3 motorcycles I am planning on hauling to Arizona from Michigan and your video was a huuuge help and I feel much more confident shopping for a trailer. I really appreciate you big time thank you.
@howeequipment9 ай бұрын
We’re located in Jackson, MI. Would love to help you get one!
@McCamerCoach Жыл бұрын
Thankyou. I’m looking for a half ton pullable. Was initially looking at 7x14 V nose. I live in a area of Canada where roads can get rough. Multiple use. Hauling lumber. Furniture etc storage in winter. Use as a portable shelter Couple of questions…what type of suspension should I look at? Torsion or spring. Tandem axels I think is a must. 12 foot V nose adequate? Reason is…I’m looking at lumber. For some reason 14 foot 2x4 is cheaper than 12 foot. Go figure I hope it would fit in on some sort of angle I’ve heard mention of extended hitches for backing up Steel frame? Thanks
@thecitiots7 күн бұрын
I would also ask about how its wired, i have an RC trailer and spent my spring taking off interior panels and cutting out a bag of those garbage crimp connectors and adding grounds. Dont get a wood floor get extruded aluminum also i wouldn't bother with a steel frame if you are in the rust belt.
@McCamerCoach10 ай бұрын
Wall height. Does a 6 foot wall mean I’m jumped over all the time when when wearing my helmet and work boots?
@aaronhorton453 Жыл бұрын
Solid information! Clear and excellent points. Thank you 🍻
@PaulMooneyOutdoors2 ай бұрын
I went to look at dark horse today, fully expecting to pull away with one. Very unimpressed by the fit and finish and I did not buy one. I will be looking at other brands.
@natasunknow24011 ай бұрын
At 3:25 mark u show the floor of the 8.5wide what material is that? Idk if its the video but it doesn't look like plywood.. also with the screwless exterior what actually hold the aluminum to the trailer? My other question when you show the undercarriage of the steel trailer what are the cross members made from? I knew its steel but is it C-Channel or I-beam? The very last trailer u show is the inside OSB? Again idk if its the video picture on my phone but it doesn't look like plywood...
@stubby112210 ай бұрын
I asked the same questions about the OSB (especially being used on the floor) but it seems they don't want to answer that question.
@natasunknow24010 ай бұрын
@stubby1122 I thought it was OSB but I figured maybe it was just my eyes because they have plywood on the walls... I guess that's why people should always read the standard features of every trailer they're looking at... I've also noticed trailer companies selling a 16ft but it's a 14ft box with a 2ft v-nose & there telling people it's a true 16ft trailer... it seems like alot of these companies have some kinda gimmick...
@jeffreyguay25910 ай бұрын
More than likely, some sort of stable deck or drymax. Actually, it lasts longer than standard plywood.
@stubby112210 ай бұрын
@@jeffreyguay259 But not as long as if it were undercoated.
@waheedtahan2428 Жыл бұрын
I'll be sure to buy Dark Horse next time I buy a trailer. Your insight was valuable I learned a lot from your video thank you. are you based out of the midwest?
@howeequipment Жыл бұрын
Yes, and we delivery across the Midwest! Thanks for watching.
@waheedtahan2428 Жыл бұрын
@@howeequipment It was a learning experience thanks again.
@stubby112210 ай бұрын
Why are they using OSB on the floors? and 2, Why isn't the underside of the OSB on the floors coated?
@OffroadCpl6 ай бұрын
Osb is actually stronger, I do with they would coat the bottom.
@mazecentric41246 ай бұрын
Undercoating the bottom will trap interior moisture. The floor will rot quickly if snow, water, etc gets inside. Same reason rv's aren't undercoated.
@stubby11226 ай бұрын
@@mazecentric4124 Undercoating doesn't allow moisture getting in in the first place.
@mazecentric41245 ай бұрын
It doesn't from moisture from above...you'd need to undercoat every single side and edge of the board..that adds a lot of weight. And.. it doesn't bind well. It's just not needed and a waste of money..unless you only paint the top. No one undercoat wood..for a reason. :)
@mazecentric41245 ай бұрын
@@stubby1122 The moisture issue comes from inside the RV..not outside. Humidity in the RV. This is what makes it so hard for people to wrap their brains around. lol. The RV's people undercoat..are in the scrap heaps. If you have a cargo trailer...coat the inside..leave the bottom (outside). And great protection. Wood panelling..is not metal..and undercoating..is meant for metal only..for a reason.
@mycomputer8710 ай бұрын
I bought a 7' x 16' cargo trailer for $9500.00 including sales tax. Now I get a personal property tax bill for $600.00 from the County, that's more than what it cost to tag my 2017 truck. Something is wrong.
@chrispaulus449110 ай бұрын
What state or province are you in?
@sadie100235 ай бұрын
Never heard of that. It’s a trailer not even RV living space. You better check that
@taoisttiger47028 күн бұрын
This sounds suspiciously like California behavior
@JV-wq6xb Жыл бұрын
Great information! Thank you
@benjamindavis41303 ай бұрын
That exposed wood underneath doesn’t look right. Is that normal?
@akustaka3 ай бұрын
On cheaper trailers, yes it is completely normal. It's typically made of a kiln dried and chemically treated OBS board or plywood that is weather resistant, but not proof. So if WILL rot out eventually, it's a very common problem on the cheaper trailers and people rectify it by spraying either a foam covering or a liner like flex-seal. Though keep in mind this will make the trailer breathe less and you will require more topside ventilation or the interior wood (inner walls that are typically not weather treated to cut costs) can start to mildew and mold.
@benjamindavis41303 ай бұрын
@@akustaka Great info, thanks 👍
@Joyross88810 ай бұрын
Excellent information
@howeequipment10 ай бұрын
Glad it was helpful!
@Jeepers19845 ай бұрын
What about polycore?
@HemiLyfeStyle919 Жыл бұрын
Not sure if you know but on my headphones, your audio is only coming out my right side speaker not both, Not sure if you knew what happened at editing
@09applejacks8 ай бұрын
Thanks!!
@finestgrowth Жыл бұрын
Very helpful!
@alexboone261 Жыл бұрын
Help me pick
@alexboone261 Жыл бұрын
Do you build gaming trailers
@finestgrowth Жыл бұрын
@@alexboone261 ?
@howeequipment Жыл бұрын
Glad it was helpful!
@1GulFF3 ай бұрын
Can’t hear u proper from music
@MR-yp7mu10 ай бұрын
I wouldn’t want a welded aluminum trailer. Also these welds don’t look very professional.
@nomansland48119 ай бұрын
I don’t know why they leave exposed wood underneath.