This just saved my bacon! I took out the trans thinking it would be easy to get back in, but I wouldn’t have been able to put the forks right without your help. Thanks for the tips
@thetwostrokerebuilder Жыл бұрын
Awesome 👍 thanks for watching 👊
@thetwostrokerebuilder Жыл бұрын
Watch my transmission inspection ones I'd recommend before putting back together 🔧🔧
@levierickson43687 ай бұрын
You made it look easy. Thanks
@mrw10548 ай бұрын
Great vid.very helpful thank you!
@chadrides9142 жыл бұрын
Good job. I’m getting my ass kicked on my 250x trans
@dr00andrewАй бұрын
why did they go with the pins and forks being as one and not sliding through like virtually every other 2 stroke gearbox including my 02 yz 125? I got humbled real quick trying to put my trans back together. it is HARD lol
@thetwostrokerebuilderАй бұрын
@@dr00andrew not positive but I think it was because the fourstroke then was like that. In 99' yz250 got that style trans. They went back to old style on fourstrokes not long after that but Twostrokes the same still now. It works good tho lol when it's not slipping 😆😆 I got to where I'd just change the 3 gears and fork every time I did rebuild on my race bikes. Because I went threw few when switching to yam from Kawasaki back in 05 06ish
@thetwostrokerebuilderАй бұрын
One time I had to replace 7 gears and 2 forks and they add up lol . That time 2nd and 4th were slipping which is rare. Usually 3rd
@thetwostrokerebuilderАй бұрын
@@dr00andrew but ya haha can be pita . The way I do in video sometimes I nail it in few seconds other times takes couple tries 😀 I've done a shit load tho lol
@dr00andrewАй бұрын
@@thetwostrokerebuilder haha i usually cross my fingers and hope the transmission is all good. I always bring it to someone for a second opinion and have them replace the gears if necessary
@thebigboomgaming15055 ай бұрын
i put my transmission in but it wont shift more than 3 times up or down and i only have 1-3 sometimes 3 doesnt even work, does the drum have to be in a certain way?
@thetwostrokerebuilder5 ай бұрын
When it's together or just in a half? They don't shift good apart. Will when together tho.
@thetwostrokerebuilder5 ай бұрын
Only goes together one way. Even together gotta spin shaft to get it to shift.
@thebigboomgaming15055 ай бұрын
fully together, its in the cases and doesnt want to shift more than twice @@thetwostrokerebuilder
@thebigboomgaming15055 ай бұрын
when i took the old transmission out it shifted trough all of them with no issue@@thetwostrokerebuilder
@thetwostrokerebuilder5 ай бұрын
@@thebigboomgaming1505 spins freely? Sometimes gotta whack the shaft I bit with mallot cause gets up tight against bearing and binds. Other than that it's pretty simple trans long as you got clips and trust washers all in where go. If shifted fine before it should be fine. But I mean you should definitely be able to shift threw the gears even if it's a bitch. Worse case split back apart and start over