Z Fold Card with a Pop Up Center

This beautiful card is stunning yet quite simple to make. All the sizes for cutting the card stock and DSP can be found below. The video gives you all the directions along with some helpful tips to easily make this card yourself. Enjoy!
Stamp Sets: Flowering Tulips; Peaceful Moments (Words);
Cardstock:
White - 5 ½” x 8 ½” scored 2 ⅛” & 4 ¼”; 2 pcs. 1 ¾” x 1 ¾”; Label; 1” x 4” scored at 1”. 2”, 3” (mechanism); 5 ¼” x 4” (back);
Evergreen - 2 pcs. 1 ⅞” x 1 ⅞”; 3” x 3”; 5 ⅜’ X 4 ⅛” (back);
DSP - 4 pcs. 2” x 5 ⅜”; 4” x 4”;
Inks: Highland Heather; Evening Evergreen;
Accessories: 2 Gems; Wink of Stella; Ovals Punch (Label); Liquid Glue; Dimensionals;
Instructions:
Adhere the 4 DSP pieces to the front and back of the Z fold.
Mark the 4” DSP square on all for sides at 2” and then trim off the4 corners. This now turns your square into a diamond. Save the cut-off triangles!
Adhere the 4 triangles on the inside of the card as shown.
Fold the 1” x 4” mechanism on the score lines. Fold it on the 2: score line and add liquid glue to the back of the 3-4” section only. Place it in the center of the card right against the fold and close the card so it adheres.
Open the card and add glue to the 1-2’ section and close the card in place. Let it dry for a minute.
Now when you open the card you see the mechanism as a popped up square. Place the Evergreen 3” x 3” square as a diamond in the center of the mechanism against the card fold and close the card. Flip the card over and draw a pencil line where the diamond overlaps the card. Remove it and cut the overlap away. The trimmed side of the diamond will be against the fold!
Making sure that your DSP diamond is facing correctly, adhere it to the Evergreen diamond and trim away the overlap.Now you can adhere this altered diamond on top of the mechanism making sure it fits evenly over the larger white diamond of the inside of the card.
Stamp the 2 small white squares with the tulips so they will be diamond shaped. Use Wink of Stella on the tulip heads to make them sparkle.
Adhere them to the Evergreen squares and adhere only the left half of each diamond to the card front matching the points to the edge of the DSP on the Z Fold.
Stamp the sentiment on the scalloped oval label and adhere it to the Pop Up diamond at the far right so it will show when the card is closed. Add a couple of gems as desired.
Stamp the Tulip again on the white CS for the back of the card, adhere this piece to the Evergreen CS and then to the card.
Thanks for watching my video. Here is all my info:
Link to my FB Page: / inkspiredcreationslk
Link to my Store: lenakiers.stampinup.net

[@janetgerstein1644]

Thank you for your great card. Thank you also to Frenchie.