Zenith CH750 STOL Build Log - Finishing Right Wing

I put the last sets of rivets in on the right wing before I set it aside and start on the pilot side. You can get a good look at how I installed the strut attach brackets and rivet on the top skin.
Please like this video and subscribe to keep getting more.
Check out my Website:
www.Dustyshangar.com
Support my patreon and help me finish building here:
/ dustyshangar

[@rottenrick1969]

Dusty, your videos have been a great help to me while I'm building my 750 as well. It's an older kit so what you have done is very useful to me. What are you torquing down your bolts to on the bolts? Seems I remember AN3 are 25-30 inch pounds ? I didn't see any torque specs on my plans anywhere but did see some on the Zenith builders page. Just want to make sure as I'm used to torquing tighter than this on other stuff.

[@dustybodine5221]

Glad you find them helpful. Torque specs can be found in the zenith construction standards manual. I think it’s saved in the online builders page that you need a password to access. Page 32 lists torque specs for AN hardware. AN3 is listed as 20-25 in-lbs plus the driving torque. I have been using 8 in-lbs for driving torque so I’m driving everything to 30 in-lbs. The driving torque is essentially the friction from the nylon nut. It can vary from nut to nut; especially if you reuse a nut so keep an eye on it.