ZETOR 8011 Crystal💪TUR5 |4K| real sound | manure |

[@bl4565]

Nice it runs good. the sound from working in the manure is really Nice.. Can it runs at really slow idle this tractor best Regards J

[@tomahawkkkk]

Thank you very much💚It's a good machine. Please subscribe, there will be more videos with this and other tractors..

[@bl4565]

Now you say it sounds very nice below 500 rpm. So I hope you will tell me how many minutes you have had it at very low rpm and how far did you get it down. 300 rpm?

[@bl4565]

Believe me I worked on a farm a few years ago. I was there for 1 month.. Every day the ursus c385 stood and chugged, with about 300 350 rpm. for about 30 minutes every single day.. It was very worn at the stop/gas handle.. That's why it dropped to about 300 350 rpm.. 3 years later I was visiting the farm. There it stood and did the same and apparently was no longer worn in the engine.. Only the stop handle.. It will probably flash on the charger and generator and battery light.. But the oil pressure is high enough since there is no load in neutral where it stands still in the terrain.. Such an engine has a gear oil pump. it can create pressure all the way down to 150 rpm.. But the engine can't go that slow without stalling... So try it if you like the sound how long have you tried and heard the sound?? and how many rpm did you have it down to?? 300 350?? Kind regards JB

[@tomahawkkkk]

Thank you for the interesting experience. Ursus C385 is the same tractor. I will definitely try it too. The only problem, as you say, will be the low battery charging current. In this video, I could have it around 450 rpm at idle. When I go somewhere with this tractor again, I will try 300 rpm and film it for you.

[@bl4565]

Hope you will tell me how low you have tryed and how many minutes it stays and struggle at idle.. 🙂I know you have tryed that before. hehe..🙂 How do you think it will sound at 300 rpm.. And what do you think the tractor will do physically. I mean rock, jump or something?

[@colmanlong1032]

Super video,what year is your tractor.

[@tomahawkkkk]

Thank you🙂 1976. Do you have Crystal too?

[@bl4565]

Nice i will looks forward to see more videoes thanks a lot.. Can this 8011 runs at idle at 300 350 400 Obr/min.. It sounds sweet at that Idle.. Please tell me Best Regards J.

[@tomahawkkkk]

I would say that around 500 rpm and above is ideal for the engine. Below 500 it sounds very nice, but the lubrication pressure is lower. I think the engine is not designed for such low rpm.

[@bl4565]

Hey again i will not get you angry my friend.. Nr 1 Questions I think you have tryed it a little bit before while you write this.. Below 500 it sounds very nice Therefor i asked you Hope you will tell me how low you have tryed and how many minutes it stays and struggle at idle.. when you tryed that. 🙂I know you have tryed that before. hehe..🙂while you write Below 500 it sounds very nice Nr 2 Question I think you can tell me that, before you try to make the video How do you think it will sound at 300 rpm.. And what do you think the tractor will do physically. I mean rock, jump or something?

[@bl4565]

I prommis you it will not hurt the engine.. only if you work hard in gear with a plough on the field at 300 Obr/min.. But tell me how low you have tryed and how many minutes it stays and struggle at idle.. I know you have tryed that. hehe.. If you will made the video for me. Then show your hand on the stop handle when you adjusted it down to the slowest Idle and run it there for some minutes.... Thanks a lot regards J. you can cut of the heat blower and light on the tractor and it will be current enough to start it....

[@tomahawkkkk]

Yes, I'll try it👍 I just don't know exactly when..