Valdosta gazebo fan - Allan + Roth / Harbor Breeze and install

[@jvideosearch111]

What panel do you have hanging up? Can you do an update on the electrical

[@Cerabris]

It’s no longer under the Allen + Roth brand, it’s now a Harbor Breeze

[@sentient_pancake]

hey this is random but i’m trying to pull the cage off one of these (where i work) in order to clean the cage/blades. i can’t figure out how it comes apart though. i’ve tried googling but can’t find anything about it. i’ve removed the screws around the outside but i’m afraid to yank on the cage or force the knob… any advice?

[@BGRFamily]

Hey there - I had to go take a look just to see, and it doesn't look super straight forward and there are no instructions in the manual either. Best I can see is that you remove the screw holding the metal band that wraps around the two cage parts - I haven't tried it yet, but it looks like this would then allow you to pull down on the lower part of the cage to separate the upper part of the cage from the lower part and band. But I do also see that there are spaced clips that are screwed into the band every few inches, if those clips are too tight, you might not be able to pull the two sides apart easily. That would then likely require loosening the screws for each those clips. But, that is just and educated guess, unfortunately. Hope it helps...and good luck!

[@jackcrotty7461]

I have same fan you have. I did unscrewed the band and unscrewed 8 screws off around the cages... still I unable to open the bottom cage at all because the dial low/med/high is probably glued on. Crazy!!!

[@tavorismark2082]

He mentions around 5:30 -5:31 in video how to clean!

[@jamesbourke3844]

The fan control knob pops off with a flathead screw driver and will go back on.