Жыл бұрын
Жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
2 жыл бұрын
Пікірлер
@BittnerBuddenbrock 2 күн бұрын
Thank you for this amazing video - love your RRC From Amman, Jordan
@endakhudson Күн бұрын
Thanks Amman!
@DouglasOdhiambo 4 күн бұрын
I've just watched this whole series in one go. I was glued. You're an inspiration, man! If you ever do come to Africa, drive through Kenya and leave us some knowledge.
@endakhudson 3 күн бұрын
Thank you brother, appreciate it🙏🏾. I plan to roadtrip this back home to Ethiopia eventually so absolutely🤙🏾
@one1shot1shaun 6 күн бұрын
What's he fuel usage like on the motor ?
@turf63 7 күн бұрын
Endak. Absolutely love the build. I’m planning to source an rrc two door after I finish up the bulkhead work I have going on on my 88” 64 iia. I saw the sound deadening material in the front wheel wells and on the inner rear quarter before the skin went on. Is it possible this stuff becomes a moisture trap long term? I suppose it went over fully painted and prepped surfaces so maybe it’s not an issue? Just curious about your thought process on the balance of quiet and solid vs potential future rust mitigation. Love your work man.
@endakhudson 6 күн бұрын
Thanks mate! Prevent the water coming into the vehicle in the first place and you wont have an issue. main reason front wells rot is largely because leaking AC Evaporator drain hose, door seals or leaking windshield seal. if you routinely check all that, there shouldn't be any rust forming. Ofcourse if a car is stripped, treated and painted then the process will be further hindered.
@turf63 6 күн бұрын
Love your attention to detail. It’s so enviable. Keep it up
@crf637 7 күн бұрын
Love it!
@azpaquin 7 күн бұрын
As a former rover classic owner.. this is an insane build
@endakhudson 6 күн бұрын
Thanks mate!
@dennismbera7907 8 күн бұрын
That power🔥🔥🔥really hope the brakes match, without the supercharger are you a 4.5 litre?
@endakhudson 6 күн бұрын
6 pot callipers on 14 inch rotors should pull it up just fine. Its a 6.2L
@AlexLindley-u5f 8 күн бұрын
Do please shorten and Cut the Tail Pipes off at 45 Degrees !!!. Angle out to the side is POLITE Blunt straight out the rear is RUDE
@AlexLindley-u5f 8 күн бұрын
Fantastic Builds !!
@AlexLindley-u5f 8 күн бұрын
Could be the Big Tyres /Off Set Rims that screwed the Diff ! On the Trans American Expedition Darien Gap Crossing waay back in 72- 2 RR's had Diff Issusues due to Swamp Tires fitted. Though it looks Well with those fitted !! Ashcroft Transmissions might have a H/D Diff conversion
@ultimatemenace 9 күн бұрын
Thats sounds awesome
@pleasehandlewithextremecare 9 күн бұрын
What an absolute dream machine.
@PaulGarnett-sl8ej 9 күн бұрын
That is beautiful
@BigAlbert45 9 күн бұрын
Awesome content!❤
@jdenmark1287 9 күн бұрын
Just stoked you are doing such a great job at keeping some classic Land Rovers on the road and for tastefully restomod ding !
@igus2157 8 күн бұрын
Stoked for sure!! I'm in!
@endakhudson 6 күн бұрын
Thank you Sir, appreciate that!
@Coordinator61 9 күн бұрын
I like your skills but not these huge engines and oversized wheels. Your own 2 door tdi is perfect.
@endakhudson 6 күн бұрын
Thanks mate, I guess thats the beauty of diversity of taste!
@julianenglar 10 күн бұрын
that is one cool looking range rover
@tuningemporium 10 күн бұрын
great video, great build, what radiator are you using?
@endakhudson 6 күн бұрын
Thanks mate, its a custom radiator to the vehicle.
@ronniewallia5279 10 күн бұрын
I own 2 range rover classics and this is the most beautiful range restoration up to date….. great work hudson team🫡🫡🫡🫡🫡🫡🫡must say mine def goin back to garage after seeing this video……thanks😂😂😂
@endakhudson 6 күн бұрын
Thanks Ronnie! nah nonsense, keep yours out of the garage and out exploring!
@TheNorthernExplorer 10 күн бұрын
Great to see how far this has come. Your videos have made me see that this is my dream job also. And that sound at the end 😍 I love the whine of the supercharger
@endakhudson 6 күн бұрын
Love to hear that, chase after it!
@paulrowley71 10 күн бұрын
Sounds sweeet!
@swank1975 10 күн бұрын
Awesome!!!
@Surfingboye 10 күн бұрын
The way you keep your workspace clean and tidy is something I admire. Great video, could watch these for hours.
@endakhudson 6 күн бұрын
Thanks mate, appreciate it
@TheTripleDubya 10 күн бұрын
Back in the late eighties, there was a certain dealer in WA, who used to rip out the original motors and store them in a special storage area and then fit them with Donovan 350s, it was an awesome time of excess and the players were having fun. The dealer must have done this for ten to fifteen customers.
@endakhudson 10 күн бұрын
WA in the 80's was where it was at then!
@MisterJDee 10 күн бұрын
I drove a RRC with an LS swap and honestly… time it felt like the RR lost its soul. Maybe it makes sense in a Toyota, but not in a RRC
@TheTripleDubya 10 күн бұрын
Standard they were serene and a bit of fun but with an LS they were far better, the diehard purists used to get “Vitesse” motors but the guys that wanted maximum bang for their buck went for the LS, it was all good.
@endakhudson 10 күн бұрын
As i always say, if you're a purist at heart LS isnt for you. but if you want something bulletproof that can cope with some punishment and some, They're a fantastic alternative.
@MisterJDee 10 күн бұрын
@@endakhudson oh, yeah, no no, I’m not a purist at all. I love LS engines generally, which is why I was curious. I was surprised that I didn’t quite enjoy the combination of RR and LS as much as I thought I would. But you are correct… for cheap, reliable power, the LS cannot be beat
@vincentpoole7588 10 күн бұрын
E/H. "It's Alive" like the Frankenstein ! ! Watching the Dakar 2025 Ultimate T1 class cars with outputs of say 340Hp, and this Rangie has double is insane. If you can't doubt him, crown him ? ? V.
@endakhudson 10 күн бұрын
Thanks Vincent, we'll one day build a Dakar spec RRC. Be pretty cool to see a highly modified RR belting across the dunes.
@MKMTA 10 күн бұрын
It is looking Mint. Cannot wait to see it on the road 🤠
@endakhudson 10 күн бұрын
Thanks mate, you and i both!
@ColinGarner-h1t 10 күн бұрын
Is this fantastic Range Rover for you or a customer . 😊
@endakhudson 10 күн бұрын
This one's a consigned build!
@contributor7219 10 күн бұрын
Congratulations on getting to the stage of firing the engine for the first time. A really spectacular build that's sure to impress the person who commissioned it, as well as others who are privileged enough to see it.
@endakhudson 10 күн бұрын
Thanks mate! the owner loves his cars and will certainly be driving it around!
@ilbelvaramirez3495 10 күн бұрын
very clean end nice build, i hope you dont use rover axles
@endakhudson 10 күн бұрын
Thanks mate, drivetrain is all uprated to handle the power.
@rangieman 10 күн бұрын
Well done what a mile stone , It is always a Great Feeling when you turn that key that first time and she fires right up , Good work mate .
@endakhudson 10 күн бұрын
Thanks mate! Nerve racking but always a good feeling!
@andreteelen6266 10 күн бұрын
great work !
@endakhudson 10 күн бұрын
Thanks Andre🙏🏾
@davidblackburn6569 10 күн бұрын
love this build its a credit to your skills
@endakhudson 10 күн бұрын
Thanks David 🙏🏾
@blacktristan40 10 күн бұрын
It's been a while but well worth the wait for that postively evil supercharged goodness. Well done!!!!
@endakhudson 10 күн бұрын
Thanks mate🙏🏾, I’ll hopefully get a bit more consistent this year with the uploads.
@bobsmith2298 10 күн бұрын
😍
@donnelleeustache4549 13 күн бұрын
Nice...real nice i have a 1/60 scale model just like it...2dr also
@ronniewallia5279 14 күн бұрын
How much for that dash?
@endakhudson 12 күн бұрын
Hi Ronnie, These are not for sale. Available only on commissioned builds.
@Thepigfromthepot 28 күн бұрын
Hahaha I've worked on that Ute and the range rover next to it
@Thepigfromthepot 28 күн бұрын
How did he not notice the body lift ?
@endakhudson 23 күн бұрын
He did. Body lift was engineered previously in NSW where I had it engineered so he was happy with that.
@duffy-photography Ай бұрын
Class film - so so good!!
@michaelnugara1 Ай бұрын
Looking forward to the build. Good pick up
@RovingBeyond Ай бұрын
epic adventure mate
@TheNorthernExplorer Ай бұрын
Loving the channel! What you are doing is my dream, I’d love a shop like that 👍
@TheNorthernExplorer Ай бұрын
Great job! That snorkel looks spot on!
@TheNorthernExplorer Ай бұрын
I do like those gull wings, I’m looking to fit some to my d1
@TheNorthernExplorer Ай бұрын
new shed will come in very handy
@TheNorthernExplorer Ай бұрын
Fantastic work! id love to do this to my disco, I may just get the space and time to one day. loving the videos
@TheNorthernExplorer Ай бұрын
This is something i always said id love to do to my disco! great work
@TheNorthernExplorer Ай бұрын
great stuff! thats the beauty of the old landies they can be fixed at the side of the road and they nearly always get you home. did you find out the cause of overheating?
@WesleyClouden Ай бұрын
hemp fiber is great also