what oil is used for rotary valve?

I have same problem they told me stator rusted over. The thing is mine ran fine agter the flood last year pulled them.put this year one started up the pther didnt both went thru same thing for got drainplugs... i wana know anything i can do b4 i drop 900 on new stator parts and labor 350 parts labor rest sound a bit high when i already paid the shop 3k to rebuild both prior to flood

Hi Phillips , I have 1994 spx two of them actually and when I start to drive it doesn’t give me power only after he got up and high Turing it starts to be fast , shat can cuz this issue? I already rebuilt the carbonator but still act the same. Thanks for you help and great video.

Bro where in Washington are you? I'm in spanaway

hog wash...Mikuni oil pumps are solid! the problem is lack of maintenance to keep then operating as designed. Line dry crack and people do NOT review them. I'm sorry but I do not agree with this video at all. I'd never run premix and after 20yrs I've not had an oil pump failure.

Appreciate your time to explain I’m new to seadoo and this answers a lot

Where did you get all your parts from?

Hi, do you still have this 2003 seadoo? I have one but it’s nit running. It has a bad ECU…

Thanks for uploading this video!

Unless your boat is completely water free on the inside, I plan on changing my solenoid and starter and battery every year; they're like consumables for me The joy of owning an old a55 stand up jet skis

The stop but just grounds the coils to stop spark but I would disconnect it to see if it's constant ground

Btw FYI: the Rotary Valve void with the in and outs doesn’t circulate, it has no pump, the RV shaft just sits in a bath of oil, which needs to be changed every so often.

What lubes the rotary valve plate?

Did yours come with the rotary valve? Or did you buy that extra?

i just honed a 717 and put new pistons and rings but i only got 95 pounds of compression should it be higher to run?

Idk about 50 mph I have 2 of them also

i think this problem you got you need another jest ski

Wahoo!

Hello ,do you think that the rotary valve can be replaced by flapers, adapting them?

$ 20 fix

Let me know if that did anything for you sorry if it didn't

The little red button that you were talking about pushing while you hit the start button needs to be pulled out that is a safety so that when you wreck or fall off of your jet ski you have a cord attached to your hand that is a safety key that goes on the red button pulls it out when you fall off so it kills the jet ski so the jet ski doesn't end up on the other side of the lake while you're swimming trying to get it it kills it so basically that button needs to be pulled out not in

That's not from heat that is from using the incorrect oil because that gear is saturated in oil and it's actually a pretty good design because it keeps it from destroying the engine if you suck something up into the jet pump if you use the right Sea-Doo oil to lubricate the soft brass against the hard steel they last a very long time

I had an issue with no spark on my 96 waveventure 1100. Replaced the CDI still no spark. Replaced the stator and started right up.

Thanks for your videos I have 1100 wave raider I have to replace the starter and I also have the yellow rotary engines nice to be more educated on them

I have air coming back threw the carbs, I checked timing a few times with the rotory valve adjustment tool

Bro que era el problema yo tengo ese mismo problema

Great videos man, appreciate that you're still working on this "dinosour Technology" and willing to share your input.

bump

Can you send me a link to where I can buy the thru hull fitting you used and a boot? Thanks!!

Where can I find this part? I have a 1992 Seadoo GTS.

Do you have a link for the hose and the metal attachment to replace the pre existing plastic piece?

HEY SOUMY! I have a 1996 Yamaha Wave Raider 1100! Useully runs great! But it stalled twice on me out there....installed new Start/Stop Switch Box & new Starter Solenoid! When I jump the Solenoid terminals it cranks over fine! Nothing when I hit the Green Start Button!!! There in No Power to the White Start/Stop Connector comming from the CDI Box!!! Any idea's?

From my experience all I did was to wiggle the battery cables until the check engine light when away

I have no power to the connector that plugs into the start stop box connecter what do you think it could be?

Great explanation on what those oil hoses do

So what is the proper way to do a premix on this model seadoo?

No wonder the pump won’t come off you epoxied it on 😂

if the battery is running discharged what is the cause

I just ordered a Timber X ... My concern is a few guys at my local club have had issues with their Timber's main gear, complaining it's a known weak spot. Since I have not yet received or assembled the plane, I was wondering if you might have a recommendation of how to strengthen this area , during the build and before I take it out to the field. Also, the field I fly from offers the choice of a very rough asphalt pad with a lot of cracks or an area of longish rough grass. Also I am a somewhat beginner pilot and would appricate any advise you can offer when I maiden it.... Thanks ....

You said FIXED... what part of that did you not mean 😂 😂... And no the engine should NOT stop when you hold the stop and start button down, that will only kill power to ur coils.

Amazing. Thank you. Any suggestion for a good and affordable water seal for the engine housing? Thanks a lot. I’m getting water in my housing, seals old

Do you have temp problems?

Pour liquid latex inside no more loss of air

Love this video! Here's one more Miami Spa you should highlight for your next video: @ ! It's Called Melanated Beauty Spa and it's amazing. I had a great experience myself and my skin feels flawless.

How fast do these go

What’s the power bill increase? By keeping this thing running all the time?

Got a part number for the solenoid?

Excellent tutorial. Thank you!

If you haven't sunk a jet ski, then you're probably NOT having as much fun....lol...Classic!!