4 ай бұрын
Пікірлер
@Iconicdean997 14 күн бұрын
hey i loved the video thanks for the help and keep up the videos
@garagecraze 10 күн бұрын
Thank you. I am sure when I get time in the winter I will have some more videos
@jimmyrosa2030 3 ай бұрын
great videos on this. Were you able to figure out why the new pistons and rings didn't work?
@garagecraze 3 ай бұрын
Thank you, I know they did not work because the ring somehow got caught under the locating pin. I am guessing that I must have installed it wrong or the motor got to hot from the wrong size jet.
@wolfschwurack9991 3 ай бұрын
Thx for sharing I'm just in the process of rebuilding my sportsman 90. This will be very helpful
@garagecraze 3 ай бұрын
Good Luck, I hope this helps make the process a little easier.
@proudpatriot6536 4 ай бұрын
Thanks for this video! Having issue with oiler, it's dumping so much oil its locking up engine and starter not able to turn over. Gonna replace oiler n cables etc. May do a big bore kit. Appreciate you Sir!
@garagecraze 4 ай бұрын
Thank you, If I had your problem I would just delete the oil system and mix my gas.
@NyLBeatz91 4 ай бұрын
Ok so I have the same engine is it 4 stroke or 2 stroke
@garagecraze 4 ай бұрын
2 stroke
@donjuan2158 4 ай бұрын
What did you use to seal the 2 halves of the crank case? Never mind you show us later in the video 😊
@garagecraze 4 ай бұрын
Permatex Motoseal :) Thank you for watching
@MrDew83 5 ай бұрын
Isn’t the crank nut a left hand thread on the belt side?
@celicablues 5 ай бұрын
Also, i appreciate you sharing the knowledge. Thanks for uploading
@celicablues 5 ай бұрын
Maybe i missed this in the video, so sorry in advance. Why was the stock jet not large enough?
@celicablues 5 ай бұрын
I did the exact same thing, fuck that snap ring behind the pump gear. Im deleting mine anyway, mixed gas for me.
@garagecraze 5 ай бұрын
Ya I jacked mine up too. Luckily I had an extra laying around. I also was going to delete the oil pump but decided not to do the delete.
@AndyDuboskySaysFuckThePolice 5 ай бұрын
Nice work
@AndyDuboskySaysFuckThePolice 5 ай бұрын
So you would recommend getting the crank shaft in before installing the new seals? I am looking forward to video number three
@garagecraze 5 ай бұрын
Yes correct, i would install the crankshaft and bearings and the case halves... then after everything is back to room temp install the crank seals.... I tried installing the seals before doing the crank and the case halves and it just would not work that way... but if the crank or the bearings are not bad i would not split the case. Can change the seals without going that far.
@jaredricardoguillentorres9884 5 ай бұрын
can you tell me wht is the number of crancksseal ?