Polaris Predator 90 Complete Engine Rebuild (Part 2 - Case Half Assembly)

Working on getting my daughter a four wheeler she can ride and enjoy this upcoming summer. This will be a three part video on how I took the motor apart and put it back together.
The following video shows activities performed in controlled environments by knowledgeable persons. Personal injury or property damage may result in attempt to re-create or duplicate what is performed in the video. Garagecraze (or persons shown in this video and any contributor) are not liable for any injury or damage. All Garagecraze videos are for entertainment purposes only. If you want to make your own repairs, be sure to purchase and follow manufacture service manuals. Garagecraze (or persons shown in this video and any contributor) make no representation about the sufficiency of any safety precautions and equipment used in this video.

[@donjuan2158]

What did you use to seal the 2 halves of the crank case? Never mind you show us later in the video 😊

[@garagecraze]

Permatex Motoseal :) Thank you for watching

[@AndyDuboskySaysFuckThePolice]

So you would recommend getting the crank shaft in before installing the new seals? I am looking forward to video number three

[@garagecraze]

Yes correct, i would install the crankshaft and bearings and the case halves... then after everything is back to room temp install the crank seals.... I tried installing the seals before doing the crank and the case halves and it just would not work that way... but if the crank or the bearings are not bad i would not split the case. Can change the seals without going that far.

[@NyLBeatz91]

Ok so I have the same engine is it 4 stroke or 2 stroke

[@garagecraze]

2 stroke