J of All Trades

Пікірлер

@km09. 10 күн бұрын

Just get to the point I ain’t got time for a fucking 20 min long video!!!

@Thumper17559 11 күн бұрын

Excellent video and thank you for this.

@homermunoz5069 24 күн бұрын

Thanks so much for this great video.

@molinodeviento8598 27 күн бұрын

Thanks you dude! I have watched other videos with some hoops and loops jumping. This method is so easy.

@shauntebreveard9155 Ай бұрын

Great job.. Thank you for the tutorial.

@LeviBulger Ай бұрын

An air compressor is kind of a big tool to omit in the tools needed list for many people.

@MG-cd9ek Ай бұрын

I have a retractable pergola which I had installed professionally and it is gorgeous! However it's rough to hang any lighting because obviously, the canopy is retracted.

@christophergeorge8800 Ай бұрын

Your whole lub approach is a dirt magnet. Cleaning is OK. Lub with dry lube with Teflon.

@johnhurley3173 Ай бұрын

Love you video!!!! Can i use this latch on 2 door gate with both doors swinging inward? Thank you

@JamesJones-mg2qp Ай бұрын

How do you lock a latch like that from intruders

@jofalltrades1816 Ай бұрын

The back side of the latch has holes that line up for a padlock. Not ideal but it makes it secure and more difficult to break into.

@Thisaevilworld Ай бұрын

Worked saved us a lot of pain

@JEGHETTO Ай бұрын

Thanks man!

@leurnid Ай бұрын

THIS VID IS A LIFESAVER! A side-note: Removing the faucet is unnecessary if you have a reasonably portable compressor or long enough line. I disconnected the water lines from the valves, and popped the faucet head off and blasted the line out without removing the faucet.

@TCB_MAMA 2 ай бұрын

Anyone have an issue where it’s just not catching to open?

@swes2934 2 ай бұрын

How did you find it with vinyl plank on it? Any clicking? What instructions after putting it down and taping it? Is this suitable for a 1978 house in cold winters? (Edmonton, Alberta)

@jofalltrades1816 2 ай бұрын

Vinyl plank was ok as long as it has a cork/foam/cloth backing on it and the slab is reasonably flat. After it's down and the seams are taped, the flooring can go right over top. If you are installing carpet then I'd recommend fastening down any edges that are floating. I did this in one room that was carpeted. Tapcons and washers (2 per panel edge) along the outside wall where the product was floating.

@swes2934 2 ай бұрын

@@jofalltrades1816 Thanks!

@ryanbramley5290 2 ай бұрын

A JACK OF ALL TRADES IS A MASTER OF NONE ,BUT A MASTER OF NONE IS STILL BETTER THAN A MASTER OF ONE

@lampclay14 2 ай бұрын

Milwaukee hole dozer problem solved

@dglatinx1 2 ай бұрын

I did it and now my socket it's broken

@brianmathew09 2 ай бұрын

Did you really need "music over the sound of the cars engine?

@slade1995 2 ай бұрын

Life Saver

@TomP41734 2 ай бұрын

Thanks my man 👌🏻🙏🏻

@brianfrancis2862 2 ай бұрын

im a penzel guy got fe 360 with flat tapped cam what type oil i need

@marcoking198 2 ай бұрын

how many pound you are

@kylerodgers2045 2 ай бұрын

great video man. Thank you

@j8rtUfh3evz 2 ай бұрын

I'd be worried about the top latch poking my eye out

@identityaesthetics9147 3 ай бұрын

If you have a wave motion this is NOT the problem so this is totally USELESS

@dennisbilt 3 ай бұрын

Oh My Gosh please tell me that "JUST A V6" plate was on a Grand National or a Typhoon!

@user-dt7nc8zl8o 3 ай бұрын

😂 thought it was just me got a real sucker at the minute lol

@steveh3537 4 ай бұрын

God bless you

@richardrobles8159 4 ай бұрын

Would I be able to do this if I don’t have the old key?

@MLR-bi8wo 4 ай бұрын

Thank you for the video

@CMCraftsman 4 ай бұрын

A vapor barrier doesn’t create a thermal break. A thermal break would be exterior insulation or a double stud wall where the studs don’t touch each other. It’s actually never a good idea to put something like plastic on the wall over the insulation. You should be using something vapor open so the wall can dry out when moisture makes its way into the wall around your outlets, your window…. I use Siga Majrex but there are a number of good options on the market to use other than plastic.

@Arckiz 4 ай бұрын

gona try this, thanks! ☺

@johnathoncastro 4 ай бұрын

My shut off valves don't turn at all. They seem stuck. Why would that happen? Do they need to be replaced?

@reginabroughton5917 4 ай бұрын

Can you ask craig winters why does my sun roof on a 23 corsair makes air seeping noises while im driving ? Please.

@elaine1743 4 ай бұрын

Is it possible for these to get wet during a hard rain and trip? We had heavy rain and ours tripped. At least that's what we think happened. Ours is a Square D.

@timo4040 5 ай бұрын

ads ads ads....

@lylemorton8641 5 ай бұрын

Excellent. I’m 70 and insulating a shop. Good tips and really like the one about the cardboard up on the top plate. Have a ways to go yet so all very helpful. I have the pleasure as well of shifting everything from one side to the middle as I go to make room. Subscriber.

@fishwiththesmile6216 5 ай бұрын

thank you

@LA_Broadcast 5 ай бұрын

Thank you!!!

@michaelconiglio1535 5 ай бұрын

Beautiful GN. I wanted to ask a question... do you have a catalytic converter on your GN or a test pipe? Not sure if the high zinc in the motor oil will destroy the catalytic converter. Thanks

@jofalltrades1816 5 ай бұрын

Thanks! I have a test pipe and pypes exhaust. We haven't had to emission test yet.

@TheAllieAndEmmaShow 5 ай бұрын

I installed this latch two days ago. Please note the packaging does NOT include installation directions. The "handle" part of the latch can be installed 2 different ways. Be sure it's in the direction you want before you tighten the lag screws.

@jimdension8074 5 ай бұрын

Excellent presentation

@jofalltrades1816 5 ай бұрын

Cheers!

@cody1995evo 5 ай бұрын

Run this in my fully built Evo x great for super high pressure valve springs

@matthewboatman705 5 ай бұрын

When I use acoustical sealant, I also do a bead of it around the windows and any outlet boxes.

@DG-qo6zb 6 ай бұрын

Would this work well for LVP? Any issues youve come scross?

@MilkyWayGalaxyy 6 ай бұрын

We had a water main break on my block one night and ever since they fixed it, my hot water to my kitchen sink and bathroom sink stopped coming out. Could it be that all that dirt from fixing the main break outside clogged up everyone water lines to their homes? Either way, i really dont want to take out my whole faucet and all the lines, i think i will just take out the hot water line and clean it?

@jofalltrades1816 6 ай бұрын

It doesn't take much to plug the line and after the water is turned back on the water has always looked dirty to me for a bit. You could disconnect the hot line at both sinks and run it into a bucket. The flow would tell you if it is something in the line or debris in the taps. This is straightforward if you have shut off valves at each sink. Otherwise a 2 person job

@MilkyWayGalaxyy 6 ай бұрын

@jofalltrades1816 I took the aerator off my kitchen sink and it was significantly clogged. No wonder I had such a weak flow. I don't understand why I only had cold water getting through though. But as soon as I cleaned it, the water pressure and hot water was back in full force like the first day I installed that faucet!! It will be more difficult to get to the aerator in my bathroom bc I have one of those delta waterfall faucets and not much space to work with since it is 3 inches from the wall. So now I know what the problem is. Everytime they shut off and turn on the water, it creates a "water hammer" and a bunch of dirt and debris gets in the lines. Unfortunately they turn off the water a lot on my block. Thanks for the reply!

@jofalltrades1816 6 ай бұрын

@@MilkyWayGalaxyy it is a pain for sure. Hopefully they make some upgrades to those mains so they can leave the water on for longer periods of time. I've taken aerators off in new builds and had chunks of lumber come out of the shower spout. Good practice when changing or installing anything new! Cheers

@donnadeutsch7125 6 ай бұрын

This is exactly what I need! I had a wooden fence put in around my property and all the latches are falling apart. I didn’t know any better. Going to call someone to put one of these in for me and check my fence come spring! Thank you!!!

@MoAli72 4 ай бұрын

OMG, you had the same idea for your profile pic!

@rslsr56 6 ай бұрын

2nd latch great idea , inice fence you built, nice video, your the perfect neighbor!

@saascends 6 ай бұрын

Thanks for the video! The instructions read terrible for threading the pulley system- I tried to do it myself but couldn't figure out what to do with the second end: I didn't read the instructions very well. This was incredibly helpful. Thanks again.

@GeneralSulla 6 ай бұрын

My wife's 2010 Ford Edge (USA) has one. Just did the maintenance on her balky sunroof. Lithium grreae on the tracks and WD-40 on the mechs and seals after cleaning. Works just fine now.

Ең жақсы KZbin

Пікірлер