Thanks for the great video . Is there a vent on the back of it ? ( I need to dry mine out ) cheers Baly
@gftgrill5 күн бұрын
No vents. You could remove the LED modules/controllers to open air holes.
@MrGTAVForLife8 күн бұрын
I notice my headlight was flickering then just died completely. So i assumed dead bulb so I got a new one installed but it didnt work. Then checked fuses and relays and still nothing. Could it be the ballast or the assembly ?
@joecamel257610 күн бұрын
Update: I have repaired the DRL... one of the 3 LED modules was burnt... and thus was affecting the full DRL and made it shut down after 1-2 mins... went to a an auto electrician and changed all 3 LED modules... price was about 300 EUR/330 USD.
@cemanyu101610 күн бұрын
Where can I buy a partial broken parts so that I can reassemble it as whole?
@alexmanson176210 күн бұрын
Sadly LED's are not made to last forever. If it fails, it will be costly to replace the entire unit.
@Abbbod20410 күн бұрын
Can you sell me the main projector if it is healthy
@mikejose12 күн бұрын
Does anyone know of a similar video tearing down the same model cx5 tail light?
@ericm567215 күн бұрын
Thank you for putting this up. Very helpful. Can you identify the fan unit? I am currently trying to locate that defective part on my F Pace headlight.
@juttaschierge365915 күн бұрын
👍👍👍👍awesome video, thank you so much for this work!!!
@jordanrg36515 күн бұрын
Yo bro quick question, do you know by any chance if a 2017 headlight could fit on a 20’ q50?
@-ahmed309116 күн бұрын
What is the type of the led that comes inside the OEM headlights? please so we can buy something like it because its very cool and powerful
@Ben_Z3318 күн бұрын
This system is temperamental from my experience recently did an RGB Retro fit to one of these AFS headlight systems on an 2014 infinity Q50s we did not disconnect or bypass ANY systems in the headlights we even left the OEM DRLs plugged in and safely put inside of the back on the headlight casing as the RGB DRL system runs off an 12 volt supply off the battery system yet now when the headlights get turned on it gives an AFS warning for the Right hand side of the headlight. No idea what it could be
@Migspamp18 күн бұрын
This is different
@free32200124 күн бұрын
One time coverage with the final u.v. and one direction. Follow the instructions.
@arcoverdetony26 күн бұрын
Dude you suck try the oven @270 for screen mins
@ParthPatel-zy4pg29 күн бұрын
what did you use to cut off the lens cover???
@sytharnia1717Ай бұрын
so you want to remove it "assuming you want to clean the inside) and you break it? sorry but this video is basically worthless because you screwed up the job
@mohdnasirsalleh5056Ай бұрын
Expensive car poor wiring
@AlchidemiАй бұрын
Thank you so much for this!
@cesartrevino8251Ай бұрын
My right low beam stopped working, everything else works, I already changed fuse #15 DRL 10A and still not working, my last hope is a specific relay although I don’t know which one… I don’t want to believe that the whole head light is going to waste just because of low beam, my Honda accord touring is too new for this miss function.
@maurice6507Ай бұрын
Can show how you cut off the lens please ?
@tomwu6978Ай бұрын
is the outside shell easily replaceable, i have cracked my headlights and want to replace the shell but im scared it would be hard to take apart
@kmfizАй бұрын
What app to use with this? I can’t get it to pair with my phone.
@yesmate78Ай бұрын
Crap advice.
@alyssapowers1816Ай бұрын
Where is this headlight assembly? I cannot find the headlight for my car
@10jmsoccerАй бұрын
Can you do a 2019 + Mazda 3?
@BreakBreadOrFakeDeadPodc-jk5xpАй бұрын
Can you put it back together?
@massimilianonicosia402Ай бұрын
Hey, do u know the size of projector? Or the size of the projector’s cover? Thanks
@patbingham9689Ай бұрын
I followed the directions to a “T” and saw very little benefit. I will say that my lenses were not nearly as discolored as some I’ve seen prior to treatment.
@OldCaliboyАй бұрын
My high and low outter ring light isn't working on the left side. I bought a new one and I have the same problem. Is there a fuse or a software issue? The blinkers work fine.
@gftgrillАй бұрын
I'm not sure if there is one, as far as I know they use electronic fuses that auto reset. I know the Model 3 had a recall on the trunk wire harness for a similar issue: www.tesla.com/support/model-3-trunk-lid-harness-retrofit It's possible that you got a faulty replacement light. You would need to test the lamp independently from the car and/or verify with a multimeter that the socket is getting power.
@OldCaliboyАй бұрын
@@gftgrill thanks for the reply.
@clarence-fw7wrАй бұрын
Another reason not to buy a Nissan.
@barrybena1336Ай бұрын
“These lights are not interchangeable.” This comment did not age well.
@guilhermo12Ай бұрын
On FX 3 Disc 2023 bikes the Duotrap does not hold properly, moving even with the correct tightening of the screw. You have the same issue?
@mateuszyko9570Ай бұрын
Is it possible to adapt the reflector (twist the light beam) to make it asymmetric?
@tuanvo1982Ай бұрын
Do you need to bake it in oven before remove the lens?
@kylejanik6895Ай бұрын
I like how you just skipped the hardest part, removing the lens pretty much anyone knows how to take a screw out of a hole
@Kr0n3kLeАй бұрын
How the f do you get to the clip holding in the clutch line under the brake booster? Anyone chime in with a tip lol
@emadsulemany9834Ай бұрын
Is there a way to disesmble the lens and put it back on? There seems to be a small plastic bit lodged behind the glass in mine.
@AntonioZabala-pm2vt2 ай бұрын
Buenas noches soy de Bolivia quiero saber cómo reparar modulo bi led Mazda cx 5
@timothyarmstrong78382 ай бұрын
Why would you not show the first part??.? That was a bone head move
@shingi19752 ай бұрын
Would appreciated it if you could do a 2023-24 rav4 headlight disassembly
@ahmedelagamy50662 ай бұрын
Can u buy the housing only for that headlight?
@osvaldolopez14182 ай бұрын
My head light went out how can I switch the led on it or what do I do sence it has no fuse for it
@MrRuslanCC2 ай бұрын
Hello, what is the cooler size and voltage? I need to replace mine (
@erjonjoni14342 ай бұрын
Question. 1st- step. The removal of lens’s. You verbally said “cutting off , disconnecting lens from the light ” is that permanently glued? How do you do that. I am asking because i need to clean the inside has dust buildup. Thank you
@hasib79192 ай бұрын
How did you remove the lens? By just cutting it?
@thenameisnigel2 ай бұрын
Great video. I can’t seem to find the video on the disassembly of the full headlight
@orlandoardila94122 ай бұрын
Hi. Excellent video, thank you! How do you activate the high mode daytime running light vs the low mode? Lower or higher voltage at the same wire? Thank you!
@Hzq_ali2 ай бұрын
Anyone else not having the lens coating drying even after 24hrs?
@alexmoli45372 ай бұрын
Does anyone know if someone can replace the leds inside