Took me longer to undo the clip trying not to break it than the whole job lol thank you sir

My auto fill picture fills up, but the water dispenser on the front of the door doesn’t work. What’s going on there?

Thank you so much for this, I was able to repair mine and it came apart so easily. I had to leave mine open to run a cycle (washer) to find a leak. Turns out the leak was an earplug that fell into the bleach/softener pan and covered the drain that goes into the basket. Easy fix, and easy teardown thanks to you.

Wow, your video is so interesting. Thank brother

What would you recommend if the lights are no longer coming on at all? I've checked the breaker, even kept it off for 5 minutes.

Amazing! I managed to (temporarily? 😅 time will tell) fix my broken button panel on the handle by following the first 90 seconds worth of disassembly instructions :D Thankfully there's a little bit of give in those wires, so the two of mine that were broken (white and green) have been stripped, re-soldered together and heat shrunk in place. Wish me luck!

Mine doesn't seem to want to finish a load only had it 3 yrs been doing it for over a yr

We just installed the same ice maker in the same refrigerator. Where the water line connects to the blue piece, it keeps leaking. We've replaced the ferrule and it still leaks. Why?

Should have done timestamps with locations of the parts you were removing

Hi your video is very helpful, I'm getting code .20 but all tests show everything is operating correctly. What is code 20? Thank you great video.

Thanks I need the manual

Thank you so very much for this video, sir!

I just bough the same dryer from a lady but doesn’t heat up I am so sad 😢

Can someone tell me whats going on with my washer? It goes to balance the load but thats all it does, no agitate, no spins, it straight just balances the load the entire cycle.

I just got one of these and I was surprised about a couple of things. First the water turns on and off during fill. Second, filling stops if you open the lid. Does anyone know why it's like this? The start/stop is irritating but basically harmless but the lid switch stopping the fill really sucks since you can't rinse your detergent cup. 🫤

Thanks for this video! Clear and concise!

You’re awesome! Thank you so much. Cleared my dryer door open code. Works perfectly.

I am having a problem w my dryer but is blinking 15 red and 1 green. The error code is due to a ventilation blocked error. It says that the air flow duct is clogged or blocked and to remove debris and clean and check one way vent operation

What was the dimensions of the plywood used to raise the oven. You said 1/2 inch but I noticed to strips on the bottom that would have made it have a greater than 1/2 inch width. Was this done to give space for heat?

Who The Hell Has A 7mm Nut Driver?! AND WHY ARE THESE IN SO G-D TIGHT?!

most useful video of the year! thank you!!!!

I have this same unit only 2yrs old and have a 93 code (9 red, 3 green) on the dryer and from what I've found said control panel board on the dryer side. Replaced with new one and still have the same code no change. So I guess now I have to replace the more expensive main board and hopefully that will fix???

Where is the water level knob located??

El equipo no prende

An excellent instruction video. The ignition device is obviously an expendable part. The replacement was so, so easy to do. Some of the screws were thumb screws, designed for easy removal without a tool. The small hex head screws were easy out and back in. There was no binding whatsoever. And, the igniter part that I ordered had the connections that matched the connections inside the range, no cutting of wires, or using wire nuts was necessary. The whole job was 5 minutes max, including the test on and off.

I get. .2

Pitcher on refrigerator leaks and is a known manufacturing/design issue with Samsung. They supposedly redesigned a pitcher that does not leak, but refuse provide me with a replacement. Also replacement part was quoted as $157.99

Two small screws are the only thing holding it in place? I’m trying to remove mine now.

Great teaching video. My washing cycle won't stop. When the timer is 45 min it won't go down, I have to unplug from the outlet, wait 5 minutes, and complete the load with rinse and spin, so the timer is 12 minutes, but it literally takes 20 to 30 minutes for a 12 minute cycle.

I personally will never even attempt an r600a sealed system repair using anything but lokring. I'm doing a compressor swap on an r600 Frigidaire today.

How do I take this fridge out of demo mode. Please help

I have code. 14 on my frididaire , model ffbd2420Uboa , it says the micro switch in the bottom? Of drain or under the unit? I've clean filter & drain area,pulled plug and reset, still no go. On restart , drain runs for a couple minutes ,while blinking 14 then it stops ,and the 14 stops blinking and just stays on, what's ure take on this problem, thanks

Saan po shop nyo?

Hey there was wondering jow to take tje adjatator out a pair of panties got stuck n it won't even spin now

Great tutorial on troubleshooting dishwasher. I am having trouble with mine not draining water. I ran water service test mode and when it came to test 7 to drain, the drain did not kick on and drain it. Before while under power fail the pump came on when tapping Top Rack. I’m thinking pump needs replaced. Any advice?

mine has an error code E4

Well done. Great video.

The worse part of purchasing washer & dryer is finding service once something goes wrong after purchase.

I just need to know how to get the top bins in. They dont want to insert more than 2-3 millimeters. Does it just require brute force?

Sweet Lord, someone please see this comment! If you KNOW that it overflowed due to someone not placing it back accurately, DO NOT go through all these steps!!!!!! There's a little rubber cap on the bottom of the tray that the pitcher sits on. It's a drain spout. Just flip it open with a cup/bowl under to catch the water. Replug and move on with life. I have ZERO appliance repair experience and an hr later of going through all of these steps and putting them back again, THAT could've been my fix! Thanks for the video though! 😅

i having 5 red 3 green what is that error?

My spinning is extremely loud in this washer is it normal?

I came here hoping they would show me how to remove the unit from the base Styrofoam but they didn't which seems pretty crucial

Thanks, very useful. Question: my cooktop gets warm after I use the oven for a while. Is it ok for me to insulate the oven from the cooktop with some insulation material?

Has anyone ran into 15 red blinks and 1 green? If so what do I do

Can we talk about how easily this meat head pulled that impeller and basket out of there?

Kudos wish you'd do engine rebuild it's like the bob Ross of ac diy

too fast

If your handle display stops working, there is a good chance the wires in the lower left hinge have been worn through (1:11). There are multiple reports of this, and it can be fixed if you are modestly handy.

Would this work on all models?