Gee…thank you so much how you showed how you took the bulb out-gotta ♥️ it!!

I would have never figured that out. I’ll be trying the belt hack tomorrow. Thank you!

Thank you!! I have 2 bulds to replace, one on each side. This makes me feel confident I can do it on my own!! 😊

the lights that you showed that you got from amazon , can those go in any of the other break light or reverse light or signal light ? or are they each different bulbs than what you showed ?

Me looking at him not turning the power off while talking about it 🤣🤣 until he did, thank you for the video! It was very helpful!

thank you

I used a dog leash - worked like a charm! None of the other videos had that little trick. THANK YOU!

Thank you! Genius! Word of caution though, the only thing holding the tail light up after it's released will be the wiring, so be prepared to catch it and don't let it get too far away from the car. It may be best to do it towards your chest. It only needs to move an inch or so to be released from the clip and pins. You don't need to rip on the strap, just a sharp tug. The entire process took about two minutes. I was dreading the prying against the paint and pulling, so I put some strips of painters tape down where I used the pry tool to make a gap.

Thanks for the video. I have watched others, but all I could see was the back of the hand of the installer. Your video showed, very well, where the bulb is located and how to remove it.

Wanted to know what the brake fluid should look like.

Just replaced mine... alot more plastic in the way than i thought there would be

So dark can't see the light so no I can't see the divit

My alarm keeps going on when I open my doors and start the car. How can I stop that from happening? Need help

Where do I locate the transmission fluid dipstick ???

Why are you saying 2 brake lights and not mentioning the running light?

How the heck did u get your hand up there

Did you not have to pull off any of the plastic pieces underneath? My 2016 is all covered up....

Little trick someone told me that I do is put little dielectric grease where bulb slides into socket and where whole assembly goes into lens , may help you when you have to take it apart next time😅

This is a better video than another I tried. The band, I used a strong piece of cloth and pulling straight back towards the bumper, is key. Thanks.

Help me please, how can I get to change bulbs on car number plate?

Notice he called the socket "a plug". That's all I need to know to tell me this guy doesn't know what he is doing.

It doesn’t help to explain how to get the old bulb out

Thanks 🙏 😊

Skin can absorb

Thanks so much you just saved me about $47! The dealer wants $50 to change brake light. I bought the Sylvania 7443 last year for about $6/2 bulbs ($3 a bulb) from Amazon on my Legacy which was a lot easier to change out--access from inside trunk. This time my Forester needed a little more elbow grease. Your trick of using the belt was excellent which I didnt have, so I sub for a flat 1" wide rope (pajama's cord). And tape a flathead screwdriver with electrical tape. After removing the 2 screws using Philips which was easy, I pried the plastic casing with the flathead as you showed slightly, finnessed the rope in and popped that case out, changed the bulb etc all done in 20 minutes for an absolute novice and non-handy person like me, the satisfaction was enormous. Big thanks to you!!

Thanks for the help!

The camera angle is the worst on KZbin

I know it’s an old video, but wondering how you drained the oil out of the filter canister. Did it drain or do you have to pump it out? Thanks!

Thanks for the step by step video

What kind of cancer? I've never herad of that before. I work on bicycles a lot. probably should start wearing gloves more often. But please let me know which cancer it is

In the meantime.helmet great tune.😊😊😊

Thank you for the explanation and the belt trick

Sounds like a good and exciting plan. I have the same Jackery and fan, they work great. Just found your channel and subbed. I'm looking at tips for my 4Runner camp setup traveling places too. Enjoy!!

Did you remember to replace all the fog light fluid you leaked out?

Excited for your adventure. Will watch your travels and curious to see how your gadgets work. All the best to you!

Wishing you all the best! Safe travels!!!!

I see you’re going through Little Rock. If you were going through East Texas you could crash a night here. Best of luck and adventures to you man!

Dude this my first time, wife got a forester and damn that's handy little tip..good job, haven't started cus my beer not empty yet but I will!

Right side would I put a new blue hydrogen headlight in my car I got the same same

I use 0w40 and ignore the manufacturer in the USA. Subaru is okay with 0w20, 5w30, and 5w40 outside of North America. 0w40 wasn't out yet when these where made and covers them all.

Just changed it in our 2018 Crosstrek Limited. If anyone was wondering, the bulb is an H16. Don't install an H11. An H11 might get too hot and start melting the plastic.

Nice! Thank-you.

10/10 video

Grest no b.s. video. Thx for keeping it short w/o a ton of theory and “i love this bcz…”. Good tip w a belt too😊

Tanks for the answer. I also found some kind of flat plastic spoon in the kitchen. With a piece of rope and a piece of cloth it will work. I'm just imitating how you did it in the video. Many thanks again

Thank you for so calmly show me how to change the light bulb. I have a 2013 Forester, would that be about the same? And is the clamp also in approximately the same place?

Would of been nice to show us how to change the oil filter

The ones i bought are h11 but dont fit ? Im not sure if theyre too fat lol but how wide were yours

The belt strap idea is absolutely genius!

I wish all cars had oil filters on top like the Subaru 😂