= observation: = for OUTSIDE installation = your GROUND Wire should be "SOLID" AWG-6 Bare Copper not Not NOT Stranded wire ... again in my observation & IMHO ... COOP ...

= another SUGGESTION = instead of aiming your MAIN +POSITIVE+ & Main -NEGATIVE- cables down into you conduit --- where it will direct WATER into your Underground RUN why not install a "WEATHERHEAD" and run your wiring UP through a weather-tight connector Above your Combiner-Box & include a "DRIP-LOOP" below the Combiner-Box installation ? ... just a suggestion ... COOP

= since you are utilizing STRANDED Copper WIRING might I suggest you install FERRULES on the ENDS before INSTALLATION > ... COOP ...

= my 6-String ECO-WORTHY Combiner-Box came equipped with 15-amp line Fuses (which matched my "PV" Panel requirements ) & a single 125-Amp Circuit Breaker to Disconnect my "PV" Panels from my Underground Conduit "DC" Cables to my Power-House ... 100' away ... COOP ...

= I utilized an ECO-WORTHY 4-String COMBINER-BOX for several years then Upgraded to an ECO-WORTHY 6-String Combiner-Box when I increased my Ground-Mount ARRAYS to 36-PV-Panels ... they BOTH performed perfectly & Included a SPD Device for SURGES the ONLY feature I regret NOT having is a BACK-FLOW device on each string as the MUCH older Combiner-Boxes incorporated ... Thanks COOP the WiSeNhEiMeR from Richmond, INDIANA ...

??? what - in - the - HELL is a 12-volt "PV" Panel ??? just CURIOUS as I see this 12-Volt reference quite often & NEVER understood it ??? ... COOP ...

I bought a manual hydraulic fitting crimper off temu. .. love it

If the original mounting hardware was enough to hold that panel on the mini with the added weight.... Then this was a really great idea! Good thinking Sir!

Thanks for the info. Great job. I will order the solar controller !

Nice

Works perfectly, and though the inverter efficiency lower at 88% not bad for a pure since wave inverter that are selling for under $200.00

I have the same BMW with heating. When using heat it still allows some charging even when set at 0*c and have tried it at 3*c. (As soon as the heater is unplugged It shuts off...) My heater uses 3 amp, and about 2 amps are going into the battery.... it seems if I crank up the charging it will trip and stop charging.... seems a bit weird, but I have to do more testing.... Bms with heat doesn't seem to have temperature user adjusted settings... on at 0*c and off at 15*c...

Interesting to know if these newer cells can handle a little more cold. That would be great.

yep you got the other app I use for my cheap 140.00 DOLLAR 100AH LIFEPO4 FROM AMAZON AND IT WORKS GREAT

only issue I'm having is I cant hear you I have my valume all the way up ohh shit now I can 13.15 minutes in the valume got louder so thanks for that

im seeing allot of JBD BMS in all these battery from the cheapest to not the cheapest lol way to go JBD

Kevin, When I was 12 years old in 1968 I was doing small engine repair with the help of my father. A friend of my father, Frank Carbajal, brought a REO De Luxe Flying Cloud Rotary mower. The engine was seized up. When I took it apart, I found the same sludge in the oil base just like the last engine in this video. The connecting rod bearing was severely damaged and the crankshaft journal was severely scored. Amazingly, my uncle found a NOS crankshaft and connecting rod at an old lawnmower shop in San Antonio, TX. I replaced the bad parts, reassembled the engine and the engine ran like a spotted ape. I took the completed lawnmower back to Frank Carbajal. I cranked it up and mowed a little bit of grass to show him how well it worked. I instructed him to change the oil on a regular basis to avoid problems again. He asked how much I owed him and I said $15.00. He replied FIFTEEN DOLLARS as if I was ripping him off. He asked if I would buy it for $15. Without hesitation, I said YES, DEFINITELY. He said okay, okay and paid me the $15. My father was impressed with my immediate response. In retrospect, I wish he would have sold me that lawnmower. My father and I were so impressed with that REO engine that he installed a REO Model 404E engine on his 1896 Easterwood Homer replica buggy car. It fit perfectly under the buggy seat because of the slant cylinder. After all these years of faithful service it needs new rings and a valve job to restore its original 1 1/4 hp. I have been looking for a REO Model 221 engine for the 1 3/4 hp. 20 years of searching has not yielded one. Thanks for posting this video and reminding me of my first encounter with a REO engine!

It most likely did that because you were trying to charge two batteries at the same time. Aka exceeded the maximum charge amount so to speak. So it played it safe by slightly under charging

Man tyat heat gun way bigger than the pictures lead me to believe

Thailand 😊

Nice viido

Thanks for the video. I just unboxed the one I got. The thimble explanation was helpful 😊. Can you post the details on that power strip? I hadn’t seen one with the built in meter.

Thanks for this review, and its give me a reason to try Pow Relab.

How tall are your mounting posts from the ground?

Ok. I see. A pre drilled piece of angle iron X4?

Loooove this!!! I'd like to see you describe the adjustable braces. What are they made of? How are they made?

I have 4 Redodo 12.8V 100Ah batteries and the app shows all 4 but will only connect to one battery at a time. Unsure what other brands offer but I'm slightly disappointed in this.

thanks good video and good demo!

You have a link or something for those round power meters with the green display?

Thanks for sharing

Excellent on the spacing calculations! The days get longer starting tomorrow.

Wow you've got alot of snow there.

You spaced the panels perfectly.

I need to learn more about the solar charging

Awesome sheetmetal work!

You should demand that POWMR file a claim with the shipper and reimburse you for your time repairing this inverter.

Are you using 2 charge controllers with your PowMr inverter?

I know some will scoff at the less expensive Solar products. But here's the deal, coming from a background in power systems stuff of a different variety, but same thing applies here. The masses will buy the cheap stuff, the mass produced clones, the money that the pioneers put into R&D you are paying back to them when you buy their 3 times as expensive products that do the exact same thing. Eventually the pioneers die off, and have to reinvent themselves, usually that means they come back as a "cheap" product with a Legacy Nameplate. So this cheap stuff is the future. Get used to it, because if the money is going there instead of the big Legacy Name companies, the cheap stuff will just get better and better without getting much more expensive, if anymore at all, as it conquers the market. Laugh if you want, doesn't happen overnight, but eventually it does happen, every time. Think of Maytag, from the best, to the same as the rest.

good job

I like your sign " Children left unattended must have a very large allowance.

the EG4 12000XP is only $2,499

why did you only get a 5 kw inverter?

Thanks for the review. Hard to find and real reviews on these low frequency powmr units... Some say the standby and low power usage is inefficient. But doesn't seem to bad from your other videos

Would it be a good idea to run a shield under the drive motors? if so would it just pack dirt in them? My H12 order should arrive next week.

So the air flows the wrong way?

You might be able to get rid of the sound when you push the buttons by disabling the alarm. That's the way it is on our MPPTs.

MUST BE NICE NOT TO HAVE TO WORK AND STILL HAVE PLENTY OF MONEY TO WAIST ON THING YOU REALLY DONT NEED UNLESS YOUR MAKING THIS FOR YOUR KIDS THEN I GET IT BUT IM SURE THEY WILL SELL ALL YOUR SHIT ONCE YOUR DEAD ANYWAYS SO IM GLADE YOUR WASTING YOUR TIME AND MONEY JUST FOR YOUR KIDS TO SELL IT ALL SOON LOL WHAT A MORON

I have one of the smaller mppt converters running a bank of slas and have been quite happy with it.

Wow that's a very nice shop made box, nicely labelled and paint :)

As a Solar Tech I like hearing when a Company steps up to the plate..and responds to the situation in a positive manner.. Thanks for sharing.. Maybe you can have a followup video. Appreicate the Sharing.