So my windows don’t work, I jumped out the window relay and the windows work. Does this mean my GEM is bad ?

Bro. How do you do a "how to" video and you don't even show HOW you removed the block.

This is such a good video!! Thanks for posting it! There is almost no info on this version of the E46 door actuator and outside handle. BMW completely changed the design in 09/2000 and as a result most videos are about the newer version. My only question is can't the window mechanism stay in while you pull the actuator out?

Dear lord get to the repair already!

Expansion Tank (Lower) Coolant water Pipe Hose ???

Whats this hose called My Guy ?

I bought a patriot safe with the same dimensions and the lock I had was the same. I had to get a replacement and this safe was identical the istall was so simple thanks to your video I’m am super grateful and appreciate you for uploading the video. Much appreciated

CAUTION: Red and White are wrong order for a SpeedQueen. At a minimum this vid is less than helpful.

Why does the chain have to be snug tight?

Great video, thank you!

Thanks for the assembly instructions 👊🏼

Good music

Thanks for bailing me out....rookie mistake, no photo.

KZbin try to give me the right car challenge impossible

where are the vanos solenoids located on a 2018 X3??

I got yellow and gray wires only. Is yellow hot and gray neutral? Yellow with black wire and gray with blue wire? White wires get tided together only?

Thank for posting the video Dr. Shankopotamus! I have a question about the electronic module, if I decide to install the module at a later date, do I have to remove the bumper, tail lights all over again for future installation?

I never get tired of this one. Classic!

Thank you for the fix and the DIY my Man !

What size socket did you use christ you suck at this

Just pull up the tab and the wire will pop right out is the funniest joke I've heard in my life........

Skipped the reinstallation of the new components.

Best commercial ever! 🐊🏌️‍♂️⛳️🦅🇺🇲

Awesomeness

These videos do not need your radio playing while you talk!

This spider is really in the way!

What to do if this brand cigar cutter is no longer sharp?

Did I miss where you removed and replaced the oil filter?

Thank You, nice job

Any suggestions on a Cannon gun sfe that seems to be unlocking the handle turns but safe won't open something inside seems to be jammed. It may be overfull blocking mechanism.

thanks so much for posting this, like many of the others, i couldn't figure out how to open this to clean all the accumulated dust out of it-all clean now-yay!

“Couldn’t” or “could not care less”

Aside from the three size 20 torx screws mounting the gem case to the fuse block, are there any other fasteners? Do i need to open the GEM and unscrew anything, i cant get the GEM to separate from the fuse block, dont want to force it. Nothing wrong with my GEM, except for what's wrong with all of them. I have a 2001, and the stupid buzzer when im listening to the radio and have doors open is annoying. The black wire with a pink tracer on the ignition switch is already been cut buy a previous owner. But when you turn the ignition to ACC with a door open it's buzzing. I'm going to reverse engineer the Buzzer circuit in the GEM. And disable it for the ignition, but keep the headlight buzzer. Or i might mount a buzzer on/off switch in the headlight/dome light assembly. if I'm not mistaken the buzzer is on the bottom of the gem circuit board. (After i got the fuse block and gem out, I realized, it would have been way faster to just add a new power switch on the dash and run a 12v wire to the radio so i can listen to it with doors open and ignition off.)

Thanks for the help o/

Yak yak like a girl.

Why not just send it back? Doesn't this cutter have a lifetime warranty?

Video is still helpful! Our bathroom walls were getting so wet when taking a hot shower; ok I was the only one causing that because I take stupidly long and dangerously hot showers. Anyway! It was smothered in dust, so I took it off (thanks to your video for showing me how), cleaned it, and am hoping that helps. If not, now I know how to replace it!

Did you end up posting the front end replacement video? I would very much like to see it.

Always clean the breechface up side down to prevent solvent and debris from entering the firing pin channel. Around 80% of videos on cleaning and lubrication of firearms are incorrect!

Question;What happens if I just replace that safety positive cable ,but not fix the blowout airbag(crash in my car),?,Ther is no possibility of that safety positive cable blowout again?.Thanks in advance for your response.

Question;What happens if I just replace that safety positive cable ,but not fix the blowout airbag(crash in my car),?,Ther is no possibility of that safety positive cable blowout again?.Thanks in advance for your response.

Just what I needed, thank you!

I was watching until I saw Crocs.

Nice video - I've had some issues with my keypad here and there - having to enter the combo multiple times, having it stick and not open - that kind of thing. It's nice to know that if things start to get worse, I can do a DIY fix - the SG keypads are actually fairly reasonably priced.

Hahahahaha..."Why don’t you try reading the rules Shankapotomus?" I'm stealing this for the Pickleball courts!

After years of using a different brand chainsaw exclusively, I was taken aback at how different the Husqvarna was. One of the better tutorials I've seen; concise, thorough, and linear. Thank you.

0:02-0:08: Is it really because his 401(k) is tanking, or is he just unable to accept the fact that he lost to a baby?

is the process the same on a Beretta?

Some years ago a movie theatre played an e-trade spot of about 5 of these baby commercials in a row. The audience was in stitches- this was one of the spots. Immediately followed by the "Coming Attractions". Ohhhh....the Boos were being shouted out from every corner. And a great collective groan could be heard. These do look good on the big screen. I hope that baby made bank during his short career.

Iit has batteries and it locked itself and I cannot unlock it how can I need help