EVAP system leak detection and how I built a smoker

I'll show how I hook up my smoker to the 2000 BMW 328Ci. Also, how I built a fairly cheap, easy to use smoker.
These are MOST of the parts you will need. You also need some clear hose to fit your barb size, screws and nuts to attach the power through the can and into the wick, plastic/rubber insulator between screws/nuts and can wall.
BUILD THIS AT YOUR OWN RISK. I AM NOT RESPONSIBLE FOR ANY INJURY TO YOU OR YOUR PROPERTY. UNDERSTAND CURRENT, WATTAGE AND POWER BEFORE YOU ATTEMPT THIS BUILD…FLASHPOINT FOR MINERAL SPIRITS IS ONLY ABOUT 100 DEGREES. DO THIS WRONG AND YOU COULD KILL YOURSELF! (IF YOU DON’T KNOW WHAT A FLASH POINT IS…DON’T BUILD THIS!)
Empty Gallon Size Paint Can with Lid and Handlewww.amazon.com...
Mr. Heater Propane Low Pressure Regulatorwww.amazon.com...
Nichrome 80-100' - 22 Gauge Wire - 100ft - 0.65mm - 0.025in (mine was 50’)www.amazon.com...
Lamplight Replacement Cotton Flat Wick - 3/4", 3 Count (Pack of 1),White (or Similar)
Schumacher WM-12 Cable Connector for Battery Chargers and Maintainers - With Quick-Connect Ring Terminal , Blackwww.amazon.com...
CERRXIAN 3.2FT 12V 14AWG Alligator Crocodile Clip to SAE Connector Quick Release Quick Disconnect Car Solar Power Charging Extension Cable,Black & Redwww.amazon.com...
2 Pack Brass Hose Fitting, Adapter, 3/8" Barb x 1/4" NPT Male Pipewww.amazon.com...