Safest way to use ramps is to jack the front end and slide the ramps under if you have means of a jack!

The ramps didn't break. I'll trust them unless I see rust/holes.

Hello.. I have a 2019 Audi Q8. So, you plug it in? and use your phone to turn off?

Mine do this to some extent. Put rubber pads under them, thats what i do. Use your brain

Ramps can help you lift the car but they can't think for you. Don't use them on smooth concrete dummy. P s. When I was a child I would put the water hose on the smooth concrete of my dad's carport and use it as a slip and slide.

FIX

It's plastic on concrete, obviously it's going to slide. There's ways to fix that.

lol 3/4 ton van with the ass hanging out on the apron on smooth concrete. If you can figure out the problem, you don't belong in a shop.

This was pretty funny! The effort😅 stupid lectronic throttle

The modern ramps are horrible. I had a set I purchased in the 1980's that were far more rugged and never slipped (and also weighed about 3 times the current metal ramps). I gave that set to I believe my brother over 30 years ago for his use. Recently I'm looking at getting another set of ramps. I would only go with "Race Ramps" now (which are not cheap; are solid foam, and don't slide). There are several ramp review videos on the internet and they show all the problems. Putting a wet cloth (or towel) under ramps does eliminate the ramps from sliding; but other modern features tend to be minimal compared to the ramps of the 1980's.

跟着朋友一块交易USDT因为点事闹掰了 她给了我个OKX钱包的码 pride pole obtain together second when future mask review nature potato bulb 说让我把剩下的USDT提出来 这是什么啊 怎么搞啊 求各位告知下

I have used a welcome mat under the back end of each ramp. Front wheel drive cars are easier to drive up onto the ramps.

My battery cover won't budge :(

How often are you going to be working on rear wheel drive vehicles anyway? 😂

Love a guy who puts his sexy socked feet on the top of his desk.

You can also just unplug the parking brake and apply 12v dc to manually retract it. This is how I've been doing it.

There’s plastic adapters (actually made for low clearance vehicles)that go over these that facilitate going over them..

Forgot to turn the radio off. Can’t hear what you’re saying.

If I hear my ramp slipping I stop, not keep going forward like a dummy

What mods did you do to the car?

And you guy are supposed to be mechanics?

Thats what i was saying 🤣😲

Thanks I forgot how.

By ur self it sucks… take ur foot and press against the ramp as he’s coming on. Should be fine. Or you might run over ur foot.

Where can I buy it with my reg

I hear Spanish. I think that's the main problem here not the ramp themselves.

Lay a sheet of cardboard down under the ramps

I've owned Hondas most of my life. Bought an Atlas to try something different. Every Honda I've owned has a point in the center just in front of the wheels where you could lift the whole front end up in one go. I wish VW had something similar. I guess they really want you to bring it into the shop for tire rotations, etc.

i see that the point of risk is behind the steering wheel

I installed a 7" off road bar in the middle of the bottom grill and couldn't figure out how to tap into the Hi beam via fuse box while using an relay. Then I came across this site and helped me complete it. I guess I'm stuck with extra switch, but I'll get use to it...

10% rule. YOU HAVE TO BE 10% SMARTER THAN WHAT YOU'RE WORKING WITH.

More of this

So prior to installing the adapter, which point did you use with the jack lift. I see that the jack stands are in the pinch weld.

To all that have wonderful solutions tonl this dilemma, understand that these are sold to DIY and many teens first learning to fix their cars. Without a proper instruction or a built in solution or ready to be used as is, this is a disaster waiting to happen and I am sure there have been plenty. This is a design failure and should have been redesigned or given proper instructions to not use on smooth surfaces.

An important point to add is that you need to change the display first to energy monitor. Otherwise this wont work

Intelligence ramped down

click bait

FORD E-VAN MENTIONED

I push my ramps under tires a bit, before driving up the ramps...

I use to put a thick rubber mat under so It doesn't slide but if your tires are a bit damp a front wheel drive vehicle won't be able to go up either. I made some laminated ramps with 2x10 wood off cuts years ago and been using them ever since. My old corolla front end won't clear the meal ramps

Lipstick on a pig bro. Dont bring attention to your shameful car

A rubber mat would help & not continuing when you hear the ramps sliding 😞🤔🤨

Make them out of wood by stacking different length deck boards. Cheaper, stronger and won’t slide around.

They were just doing it to show us

These are not to be driven up on! Hoist the vehicle then use the ramps.

Yeah going up and down ramps suck. I have jacked up the car before and put them under the tires instead.

The cold starts NEVER get old.

I have canon i-sensys MF4450 when trying to print the paper comes up empty it says Format/réglage incorr. Cassette 1 Régl. PC:A4 What can I do to fix this Cassette 1 Régl. PC:A4

I have ramps just like those. They work best on front wheel drive cars. I like the idea of using rubber mats.

Put it on a section of carpet