Thank you for this you just helped me save my brother 300 on his jeep I did the work parts ran me 50 bucks and the dealer ship wanted little over 300 to fix it for a spark plug and a ignition coil
@EvanGustafson-f7p10 күн бұрын
How long did it last?
@jefferson888889 күн бұрын
I just had to repack more of the high temp putty in last month. It held up surprisingly well!
@joeanderson985214 күн бұрын
👍👍
@flubbajubb495823 күн бұрын
“No pop? Just open it anyway” the most useless piece of advice I’ve ever seen
@miguelvallejo149627 күн бұрын
No bueno on this one lol
@dda1943Ай бұрын
Thankkkkkk u so much from a mom helping her son. We did it together
@jefferson88888Ай бұрын
Awesome!
@Brent6437Ай бұрын
Thanks brother. You showed it great.
@cella3rogersАй бұрын
Thanks for the update
@frankimaserati1395Ай бұрын
Thank you thank you thank you I was thinking it was a fuel pump issue. I’ve been driving for two months without changing the embarrassment when the Grand Prix would shut off at a red light I had to rev rev each crank this was super simple thank you again
@therealjeeposaurusАй бұрын
Thanks for making these videos. They helped me decide to buy an escape with a bad put for a good deal.
@victorhoyt4352Ай бұрын
What years does this apply to for a jeep compass? Thank you!
@jefferson88888Ай бұрын
I believe the valve cover is the same for years 2007 -2017 for Compass's with the 2.4L engine
@victorhoyt4352Ай бұрын
Thank you very much for the speedy reply!! Great video 👍
@masterneo892 ай бұрын
just in time for my replacing the gasket, guess what the center two spark plugs are soaked in oil - because of the failed center gasket, geez !
@mahinda1052 ай бұрын
Great video. All important info was there.👍👍👍👍👍
@wmineard2 ай бұрын
Just a question: Do the bolts not need to be torqued?
@danielyoungblood85253 ай бұрын
I have the 2.4 l & my new gasket sticks out a bit on the driver side, is that normal? It seems to be the same case in the video. But I just wanna be certain.
@jefferson888883 ай бұрын
The gasket is a bit exposed on the drivers side after instal. Without a picture of your installation I can not be sure if your installation is correct, but as long as there is no oil leakage you should be fine. It should be pretty obvious if the gasket rolled out of the valve cover groove during instal.
@UnderTheRadar19763 ай бұрын
I got the throw away argon bottle and it takes the little tube but my welder has the larger pipe ffs
@rogeliopadilla14323 ай бұрын
Thanks for the instructions. Tomorrow I worked on my mazda.
@kyndlefyree4 ай бұрын
not expecting a reply but what size is it? 3.1a? my current one is 3.4a and doesn’t fit but i wanna make sure im putting in the right size
@mandobizar4 ай бұрын
Did you have to re-program the throttle body with VIDA?
@jefferson888884 ай бұрын
No, just swapped out the trottle body units and drove it. I beleive it just relearns on it's own through driving.
@user-cs6go9vv9v4 ай бұрын
DO NOT PUT ANTISEIZE ON SPARK PLUG THREADS OR ANY OTHER LUBRICANT. PERIOD.
@cadeeb4 ай бұрын
Very useful thanks.
@richardjohnson95664 ай бұрын
Nice video, but for all of you first timers out there, he failed to show cleaning around the timing cover fits around the timing cover. This area has to be cleaned and a small amount of form-a gasket on both sides of valve cover or you will have a LEAK. Too bad it took you a couple of hours to do what you thought was a really good job, to end up pulling it back apart to apply about a 1/2 of sealant. Hope this helps!
@jdakel76055 ай бұрын
Thank you for this! Such a great helpful video. Saved me thousands.
@JBWITRON5 ай бұрын
I just bought a 06 XC70 and the engine turns on and it seems like it wants to stall. I replaced the MAF, changed the spark plugs now my next thing would be fuel filter then Throttle body. Thanks for the video on how to replace it.
@ton3215 ай бұрын
Nice job, you are easy to follow and makes for a great demonstration, very easy to understand every step of the way.
@randomfixes5 ай бұрын
Brilliant! Thanks for sharing.
@bengilandoe76526 ай бұрын
Will the evap make your car stall or cut off when it’s goin out ??
@ethan-_-84335 ай бұрын
Does it stall out when idling or coming to a stop?
@EruajNoj6 ай бұрын
What if when you replace the fuse and it keeps shorting out the fuse
@jefferson888886 ай бұрын
I would then remove the lighter assembly (install a new fuse without operating the lighter) and use a test light to confirm you have 12v coming to the two wires at the back of the assembly. If you do, your lighter assembly is bad and you need to replace it.
@zzphantom6 ай бұрын
Just had a 2017 MX-5 start throwing this code today, which was very cold. I'm hoping it fixes itself when things warm up.
@TheGreatDaneish6 ай бұрын
I ended up here for the same reason, 2019 CX-3
@zzphantom6 ай бұрын
@@TheGreatDaneish sure enough, 40 degrees warmer today and no airbag light. I hope you have the same luck.
@squirttv696 ай бұрын
Good video showed to the old man were gonna tackle this today. Should we use any sealent on the gasket or just torque it real good? Have one of our spark plugs getting oil in its hole just one plug figured this it.
@jefferson888886 ай бұрын
Thanks for checking out my channel! The only place you could but a dab of RTV is where the head meets the timing cover (both sides and just a dab). I didn't do this and had no leaks but it is good practice none the less. Other than that, no sealant is needed.
@johnsmith-dm2tq7 ай бұрын
i have had an impossibl;e time trying to figure out the differance betweeen awd and 4wd when is comes to escapes. mine says 4wd but doesn't have a 4wd light/ shifter/ switch/ anything. you know where i can find info on this? i need a transmission, they are all 6f35's but some shifters have p.n.d.r.L. and some p.n.d.r.1.2. so i am sure the linkage must be different. perhaps i am overthinking it.
@arturolermasanchez13337 ай бұрын
Muchas Gracias por los subtítulos en español
@user-qm1ri7fg7h7 ай бұрын
After putting a new cluster must I program it to match the immobilizer; Because I have heard that if you don't , the oil and battery lights might be turning on without reason .
@jefferson888887 ай бұрын
Not on the 1998 MK3, the new cluster operated perfectly and had no issues.
@user-qm1ri7fg7h6 ай бұрын
@jefferson88888 In my seat ibiza 6k I had the simple 1.4 8v non mfa cluster , I plugged in a cluster with mfa from a 2.0 cupra abf ibiza and when I drove the oil pressure light was constantly flashing and the buzzer was sounding loud also the handbrake light was on all the time
@reneerose19067 ай бұрын
Thanks for such a detailed video! I need this repair in my Mazda and may try it myself. What is the version of the drill you are using?
@jefferson888887 ай бұрын
Hi Renee, thank you for checking out my channel! you can do all of this with just hand tools (a good socket set and misc), you do not need expensive electric ratchets and impacts and such. But to answer your question, I like my simple 1/4" drive Dewalt impact. Good luck with getting it done!
@alfredrevis18768 ай бұрын
My 2007 Grand Prix gt would start but would fall dead if I didn't press the gas. My buddy unplugged the purge valve and started it right up. I went and had it checked and it gave me the P0443 code. My question is would this make the car fall dead after it warms up? Thanks for any advice.
@jefferson888888 ай бұрын
Yes it could. Replace the purge valve (they are cheap) and clear the codes.
@talknicetux3158 ай бұрын
Thanks this really helped after hours of searching for fixes that had nothing to do with my problem this one did the trick
@OmarPonce928 ай бұрын
What do I do if the cover is stuck?
@jefferson888888 ай бұрын
Make sure ALL of the fasterners holding the cover down have been removed. Once confirmed, wiggle and bump the sides of the cover with your palm - it should come off. The old gasket over time sometimes forms a pretty tight bond between the cover and the engine head.
@goochi55448 ай бұрын
Great tutorial man.
@michaelr.williams81769 ай бұрын
You can put a paper gasket. On the stud bolt befor. Tighten down lug nut. It keeps from the lug nut from seasoning up. Keeps the rust separated. Fro the wheel. And lug nut
@winstonchaychel9 ай бұрын
Thank you for the clear view of everything and detailed explanation. Some videos bring out the "car dad" in me wondering why people cant hold the flashlight in the right spot, kinda deal 😂
@nunistarot56279 ай бұрын
U the fucking bestttttt
@twitchkillgod29859 ай бұрын
Thanks very helpful for the diyers at home
@macchiatostalinkatravels10 ай бұрын
What were the symptoms of the failure of the transfer case?? Or ptu ? On the ford escape?
@sethduffey953810 ай бұрын
Thx
@habanero149011 ай бұрын
Thank u very much
@jefferson8888811 ай бұрын
You're welcome and thanks for checking out my channel!
@ohsoloco511311 ай бұрын
Interesting to see inside of one. Hopefully the PTU on my Taurus doesn't fail, I changed the gear oil in it at 45,000 miles. It was black. Planning to do it at least every 30,000 miles from here on out.
@jefferson8888811 ай бұрын
Good plan! It's all just gears and bearings so maintaining good clean lubrication should make it last a long time. Thanks for checking out my channel!
@John336NLT11 ай бұрын
Thanks for making this video. I need to change the gasket on my '15 Patriot
@Three3Nill11 ай бұрын
do not put anything on the threads of spark plugs. ever. dont care what your dad taught ya.. its wrong.
@3m0k1ng11 ай бұрын
Thank you for this information!!
@jefferson8888811 ай бұрын
Glad it was helpful!
@patrickmcnamara58467 ай бұрын
Do you recommend replacing coils and affected plug at the same time?