it's rare for them to come apart that easy, normally it's a fight and a half.
@crownvicca11 ай бұрын
I ended up putting steel pulleys on mine cause I got fed up with plastic bs.
@MatthijsvanDoesburg Жыл бұрын
Thanks :)
@BmwAlfa123 Жыл бұрын
Why not use plastic tools that don't scratch???
@thechronic555 Жыл бұрын
I really dislike youtube for removing the dislike count.
@dixiemae5042 Жыл бұрын
2nd 👊🏻💪🏻
@AngelGarcia-hu7fe Жыл бұрын
Alguien Sabe de algún taller para reparar. En California de preferencia en el condado de Ventura CALIFORNIA ó los ÁNGELES CALIFORNIA AY PORFAVOR
@SAABguyMD2 жыл бұрын
I hope mine come apart that easily! I found brand new lenses for a hundred bucks, polishing only works so many times. Thank you for the video!
@noodle3722 жыл бұрын
I really want somw Trident gum now
@murielleritz12852 жыл бұрын
Bonjour moi je n'arrive pas à. Enlevé la vitre de les phare...
@simonsvoboda97332 жыл бұрын
Thank you, helped a lot
@UberGeek3 жыл бұрын
I wish my lens would come out so easily! Mine has sticky seal that is super difficult to get this apart. I will try a heat gun. Thanks for the tip.
@charlesmacias14898 ай бұрын
Mine too it breaks ang i need a new fucking entire headlights
@SamAbraham3 жыл бұрын
Cutting that outer lip makes all the difference. After messing with heat and cutting in different ways, I just damaged the housing. Now I’m going to make a detailed video on what you’re doing here, thanks for uploading this!
@mrnoone7377 Жыл бұрын
link? thanks
@rsporsche Жыл бұрын
I'd also like to know if you made the video, I need to do this myself.
@IncognitoX83 жыл бұрын
Imagine thinking that it would be a good idea, to have radio blasting on max volume during this video........................
@adambomb7892 жыл бұрын
I was hoping he at least got some money from Trident
@mrkrinkle83234 жыл бұрын
Where you trying to trash the light?
@mirzha0012 жыл бұрын
There a permanent glue that don't loosen with heat
@mrkrinkle83234 жыл бұрын
I'm so confused right now
@rogercarballeda16674 жыл бұрын
European specs from 2000 to 2003 can't be open. Are epoxi glue.
@grete61003 ай бұрын
Really?
@rogercarballeda16673 ай бұрын
@@grete6100 yes It is. You need cut It if u wan to open it. Actually it's not epoxy is polyuretane glue like windshield
@grete61003 ай бұрын
@@rogercarballeda1667 okay, thank you for answering 4 years later
@MHD_855 жыл бұрын
Hello how did you do that how I opened the lens cap? I tried with a 2000W hot air gun and it didn't work I'm so sad I want to change these pieces
@wheatonna5 жыл бұрын
Why I'm here: I replaced my adjusters using the ship-in-a-bottle no-cut method. One of the adjusting screws was stuck and needed lubrication. A few drops of oil made their way to the inside of the lens, and that was all she wrote. Lots of time, isopropyl alcohol, and ingenuity weren't enough to get the lens clean. A hard job, wasted. Thanks for this! I was going to use my Dremel rotary but you had a better idea.
@cadufx96735 жыл бұрын
the sound of the iPhone 4 is as loud as on iPod touch when connected to a stereo? For my iPod touch 4, it has more power than the Iphone 5s, when plugged into a stereo sound.
@anymoose5 жыл бұрын
good idea to not open the hood so we can actually hear it
@hassanqasim865 жыл бұрын
😂😂😂😂😂😂😂😂
@alexm5945 жыл бұрын
great. thank you
@alexm5945 жыл бұрын
great video! Question. what material is the graphics on? and does it replace the top sheet of the ski?
@hungryforspeed5 жыл бұрын
It's actual top sheet material that I had custom dye-sublimation printed by a custom ski/board shop. I forget their name, but if you Google it you may find someone offering a similar service
@seanwilks77125 жыл бұрын
Not going to mention or show the epoxy they used to seal the lights. This videos shows him taking aftermarket ones off.
@hungryforspeed5 жыл бұрын
No these are factory lights. Ones produced before mid-2002 have bakeable sealant, not the permanent type
@Alpejohn5 жыл бұрын
You did not tell people that there is a screw at the edge of the turn signal side.. Someone is gonna break it open..
@heavyseven884 жыл бұрын
Ooh that sounds awesome, thanks, my car 1/97 m54 e39 5spd
@maxwellbrown25845 жыл бұрын
Ran into this same BS on my 540i
@tariks61675 жыл бұрын
how the bixenon gets activated?
@tariks61675 жыл бұрын
Do the projectors by the time become weaker? Or it is the balast?
@112285art6 жыл бұрын
@ hungryforspeed thanks for the insight. I figured it would be the bearing, Im looking to source another diff from my local part yard soon. I may use a 740i for a donor if i cant find a 540. My next question is I have a manual vehicle Dose it matter if the donor is auto or manual?
@TheTorkerman6 жыл бұрын
Awesome job!!
@112285art6 жыл бұрын
hey guys I have a e39 540I and im currently dealing with the same challenge. Is this due to a bad input seal or is it the bearing?
@hungryforspeed6 жыл бұрын
112285art this was a bad bearing on diff input shaft. If there is play, the bearing is bad.
@radu1976666 жыл бұрын
I have a 2002 manual 530i. What I thought it was a release/throw-out bearing noise it proved to be a driving shaft/differential play as when I release or even when pressing the clutch there's noise underneath going towards the back of the car. My mechanic noticed a play in the driveshaft - once he rotates with the hand the drive shaft underneath he noticed the same play in the differential. He said that it's normal for a used car and my play is very minimal. However my car has only 122k so it is bad because the old owner didn't know how to change the gears releasing the clutch too quickly. I am looking now to buy a new differential - 2.93 gear ratio like the original or even 3.15 woud probably be OK - WITHOUT ANY PLAY. Is it possible to find such one ? Rebuilding a differential would be way too expensive - 700 CAN$ - I understand.
@hungryforspeed6 жыл бұрын
radu197666 stick with the same ratio otherwise your cruise control will not work on a manual trans car. Some backlash is normal in the diff. This side to side play is not ok though! I wouldn't replace your diff just because of some gear backlash.
@radu1976666 жыл бұрын
Thank you for the inputs. I wouldn't care too much about loosing the cruise control. I do 95% highway with my E39 as that's my weekend highway cruiser. I am more concerned about the fuel economy as the car will eat 7.5 or 8l/100km with a new 3.15 or 3.46 gear ratio diff and not 7l/100km as it's doing now -. however it will be much more peppy. The problem is that the backlash is pissing me off and will be there for all the time. I daily drive a TOYOTA YARIS manual as well , shifting is smooth and no strange noises with the car having 170k on it. When driving 2005-2007 ACCORD i4 or V6 or ACURA TSX shifting was also smooth with no differential clunking at all. I understand that those lighter FWD cars are different. I have chased for 2-3 years a low mileage good condition 528i or 530i - manual - and after I got this one I feel confused and frustrated. Engine sound good, fuel economy is great, no leaking at all, no oil consumption but shifting is frustrating with that clunking. You have to release the clutch really really smooth and rev it more in order not too have that clunk. I like the clutch - soft, self-adjustable clutch - I wish though the depressing to be smoother and not too sudden . I still think I will change the differential but it's risky : a manual 525i or 530i with 2.93 or 3.15 are most tempting but how can I be sure they will be better - basically perfect - than mine ? The auto 525i and 530i have 3.46 gear ratio ... can trust a diff on an auto car much more but gear ratio is a bit too high for my tastes !
@hdanielle41646 жыл бұрын
Great work bro
@flx64706 жыл бұрын
Very good job! Skis look awesome, so much better than the first pair i built :-)
@tubata1116 жыл бұрын
Mine's are 2002 onward do i know how to open them.
@SPCkernel6 жыл бұрын
Good stuff. So you do clearly listen to a quieter engine?
@Rudolf2k6 жыл бұрын
Did you install a new front or did you glue the old one back together? If new, where from?
@stephenprice33576 жыл бұрын
why put this useless video up?
@maureenregan34947 жыл бұрын
bastards. I just moved here and can't get over how many speed traps there are. I saw 3 in a 2 mile radius last week on #111.
@vosedon7 жыл бұрын
Wow you guys are animals...What was the smoke?
@iMars4787 жыл бұрын
😱
@loooofeeee7 жыл бұрын
did you solve it ? I have the same problem right now ..
@hungryforspeed7 жыл бұрын
HuSaM H. I had the manufacturer send me a new unit, the cutoff shield was not moving into place perfectly every time.
@iammoetic20547 жыл бұрын
my cousins diff has same issue but we're swapping out the diff will the wheels still move? because he is having trouble with it moving things
@kzoomin7 жыл бұрын
All I learned from this video is Trident gum, Hyundai pushing peoples buttons, bring your own phone for unlimited data, when feeling bad go to walgreens.
@sotemot7 жыл бұрын
Can you make a video detailing adjustment of the headlights while hooked up to a battery? What kind of connector do you use to hook up the headlight?
@Tuner15027 жыл бұрын
Schlamper...bei ausbau ales abgebrochen
@Tvoe_BrO8 жыл бұрын
so good вообще зашибись
@eitanmizrahy98408 жыл бұрын
The radio in the back round is anoine
@Petlover100008 жыл бұрын
This video is useless.
@danikasuomi8 жыл бұрын
So, the lenses are just that easy to remove with a screwdriver? No glue? I have to replace just the lenses (or clean/polish them). Thanks!