Orn Run

Delfina Mountains

“Ashfault…ashfault…ashfault…”

Can this be used for the sides of concrete steps

What if u have a painted wall

Thank you for sharing, very helpful and informative.

Can this mixture be applied to a painted surface

The broom finish always leaves a lot of snots with these products. Is any other finish possible?

le maçon qui a construit le mur avais bu ce jour la ?

A trick to make parge look Professional is using a sponge. Trowel it on domt have to be perfect just get the thickness close. Let it cure a bit and use a wet sponge going in circles with very little pressure to take out any imperfections.

The pronunciation of potable is a pet peeve of mine. It's pronounced po-table, not pot-able. It's derived from the latin word po which means by mouth. It means drinkable water. It has nothing to do with putting water in a pot.

I assume the tube-form is necessary if you have a sloppy hole, like if you are reusing a hole where you've dug/pulled a previous post. It's interesting that the quikrete guys suggest the same thing in pictures, but nobody (else) actually demonstrates or discusses when or why you would use a tube-form.

You sure need a lot of stuff.

Dries too fast.

Ну она оказалась права. Бездарность вылез на сцену 😂 и помоготь не пришлось.

Hi. I can't seem to find Parging Mix here in the US. Is Sakrete Surface Bong Mix the same?

ASHphalt?? That drove me nuts!

My pot hole is 7.61cm deep😢, guess I can't do it in a single application.

What about the edges

I saw a video with top bond to fill in pitted areas. What is the difference between the 2 products? And do they dry different colors?

I live in the USA. I can't find Parging mix. Does it go by another name?

Je suis maçon de carrière et ce video n'est pas bon. Aller voir ailleur. Beaucoups d'erreurs. C'est literallement le pire vidéo de pose que j'ai vu fait par une compagnie.

Can this product be colored?

Do you require a bonding agent >

would this work on a seawall that will eventually be underwater?

Quien vend de este material

Il y a rien de droit 🤣

Faut remplir de béton le mur

Lots of misses, overlooks, and not so great tips. Has to be the weakest of all i've watched so far... nice job Sakrete Canada!

doit mettre une membrane impermeable qui entoure le 4x4 qui a un contact directe le beton car il va pourrir

Pretty lonely looking wall...

lebron jamesss

merci pour la video ,elle est simple et complete

sir I have a floor of about 3000 feet and thousands of holes a quarter deep and three inches in diameter what cement can I use to cover the holes and that it does not dry too quickly to be able to work. Thank you

Can parging be done over painted walls or does paint need to be removed before application?

Better off just getting some hot mix , this stuff is garbage

Excellent video from a top notch company

Tu wenque rak I have no doubt about the the problem that has happened with that type in my heart

Is wire needed under the concrete spread ?

how many minutes of position 2 concrete parts before it starts to dry?

Now that patch looked like ass.. great promo video..

Is this product available in the US? Everything I see appears to be north of civilization

What is the difference between Sakrete in the US vs Canada? The video says to "add water to product". Every how-to video in the US says never add water to product first. it is always "add product to water". This includes a US version of the Sakrete Top n Bond.

Got it! 1. Start with a freshly poured concrete slab with a nice, clean, broom-finish surface as shown. 2. Take an air chisel to the slab to spall the surface. 3. Buy some Sakrete and mix up thick to fill the spalling you just performed. 4. Mix it thinner to cover it all. I'll remember to buy some if I ever decide to do that. For everyone's immediate concern, which product do we use to resurface a garage floor that has been there for a few decades, with cars parking on it, dripping oil and antifreeze over that time, with actual spalling caused by ice freezing, with the obligatory crack, and that we can park cars on again and not have it flake off leaving it worse off?

Omg, I wanted to throw up watching who ever was applying and finish sponging the parged wall.

does this work safely on manufactured stone to remove concrete dust and hazing?

I used a gas powered earth auger to help dig the holes fir deck footings. Was using an electric drill with a mixing paddle but the drill would get very hot. I made an adapter using a pipe coupler, a nipple and a fitting to allow me to fasten the mixing paddle to the gas auger powerhead!

I have first coat of parge, I used Type S mortar mix, can this go over that ?

Comment acheter ce produit en France ?

Awesome!