Is the error code in Xentry P000277? thank you

Please explain

man i've been chasing these issues for weeks now. 2017 g63. Coolant hose to turbo blew off, engine overheated to 260, melted numerous gaskets, damaged water pump, oil filter housing, what a mess. Thanks for the video.

Any extra power needed to the sub or does it sound fine as you have it?

Thank you!

Hello! My check engine light is on and runs rough rpm jumps for a few minutes and then it goes away is it possible that I could have the same problem

Hey VM, I got the same issue on my 2017. Man, it's a tight fit from what I see. How did you get to it? Did you remove the two hoses first (That were not connected to the Aux pump), then slide the grommet off in order to get to the screw points on the hose clamps in order to remove the Aux pump out? I will probably replace the two hoses. It's the Aux pump that is causing the leaks, but while I'm down there I will attempt to replace the hoses if not too difficult. It seems whatever you had as issues on your AMG, I am having as well. But I still love my G63. Thanks for all that you do. 😊

Thanks for posting this ViperMike. I'm interested in replacing the sub in my new 2025 3X truck. If you had to do it over again, would you replace the enclosure all together, or just put an amp on your existing setup?

Thank you Sir. 👍

Why don't you try Kris at VM Autohaus in Burnaby.. Kris is awesome.

Thanks soooo much!!!! Getting my 3X pick up in few days!!!!!!

This was so helpful! I'm so green to the EV world- really appreciate the step-by-step!

🎉🎉🎉🎉🎉

My g63 need you repair would you please tell me address

did you end up doing the mirrors? wanted to attempt them tomorrow

Thanks for sharing this and what an awesome car by the way just be careful because I believe A-to-Z recalled those first generation adapters for faulty disconnects. FYI.

Thank you for taking the time to document this process! Much Appreciated. used code REWARDS20 and got 45dollars off the $225gm adaptor!

Thanks!

Hi sir when i change the main battery the car do i need to program it or not..thanks..😊

Thanks for sharing! Got my 2024 Hummer EV SUT setup and ready to go. :)

During the Service A maintenance, the Mercedes mechanic told me that there is a little leakage of oil at the oil filter housing from my 2013 GL 63. I already bought the plunger for the M157 engine (part no. A 278 180 04 38 for 10$). Because of the minimum leakage and my minimum use of the car I will do nothing at the moment. Any idea how many hours it cost to replace?

how do you manually open the valve? Also when did Mercedes start using valve control on their exhaust? I have a 2012 and I dont know if I have one.

thanks for this, but also it's infuriating that for what we pay for these EVs this isn't just included by default. especially for how cheap the parts are, and that they're just plug n play

Hi. Can you tell me where exactly the oil was leaking from? I have this problem in a Mercedes CLS 63 AMG with the same engine, from what I noticed the oil is probably leaking from the round cap and it can be replaced without dismantling the whole thing. I think the entire base of the oil filter is good and the problem is only in this round cap

Thank's sir Hpy nice day

Hey @ViperMike! Awesome videos! It looks like you are located in BC. Are you a mechanic? I have a 2015 G63 that needs some work. Let me know if that's possible to meet or chat about the issues I have. Thank you once again for the videos!

Thanks ! Mercedes wanted me to pay 1100€ for a new pump + installation.

Maybe you could help: I got missfire on cyl 5, replaced the injector 2 times - nothing. The injector works for a few rotates when engine is idling and then shuts off. Got weird value at o2 sensor upstream of cat 6.62 something like that and does not go down. Changed the o2 sensor and still have the same values. Saw some oil in the connector, cleaned it and also nothing changed. So I'am thinking what could it be.

How did you like the aldans ?

Check your o2 sensors

When you had this issue was you running rich ( burning a lot of fuel / getting bad mpg)

Love your videos on the G Wagon! Watching from here in Sydney Australia .

That will not seal properly, also good job messing up your truck

Walmart subwoofer in a 100k truck this is stupid af

Bet this was a waste of money and obvious you don't know sh*t about car audio

Do you feel as if these helped reducing some of the road splatter on the side of the truck?

Hi ViperMike, nice tool you use. Can you share the type/model of the launch x431? Want to buy the same model. Thanks

How are the pop n bangs from downshift, do those get louder?

What is a conductor plate? Isn’t it a ecu??

What a super in-depth video. I appreciate how you show all the details smooth or not.

Excellent video!!! I am doin this job but I had my conductor plate sent out for cloning... When I get it back will I have to do the adaptations? Also I purchased a Foxwell NT710 scanner for Benz. will this ba able to do the cloning sequence or adaptations / gear learning etc? Also I think but correct me if im wrong... the second load of TF at temp should be pumped in with car running? then fill till it pours out and cap off when it's just a trickle?

As someone that's owned a Viper coupe, convertible, and Targa (RT10). I can say they've all got their pros and cons. The coupes are more beautiful, but nothing beats cruising toppless.

Is white smoke a sign of some kind of breakdown? I want to buy an X, but it smokes just like that

Hi , did you have to remove the radiator / fan to handle this task ?

man thats a really badass setup, looks great.

Whered youbuy the downpipes? Theyre sold out

I’ve been waiting for in depth gen 3-4 viper videos like these for a long time!

Great video. Very interested if the result was good. Want to do this myself.

You should check when the speaker is at full excursion if any part of the dampener or even the cone hits the floor

Taking delivery of my 3x in the coming days. Did you notice a big difference in sound? How about the rest of the speakers? I think I will have a custom box built. How many subs come from the factory? Looking forward to more videos!! Thank You!!