Because you're trying to fool people on the internet and you're dropping the tape measure down to the floor and not showing people that you're measuring to the floor on the second one. And it's very obvious when you start to move the tape measure at the very end me. This here is what you call one of them internet pranks
@weknow7622 сағат бұрын
Cuz it rolled away from your table
@ItsMeBT2322 сағат бұрын
Easily explained, this guy is an idiot. He's probably a MAGA supporter.
@robertmurphy656623 сағат бұрын
Seriously? Good god our country is fucked!
@eddieberntsen578823 сағат бұрын
The tabletop is the variable
@kariko07Күн бұрын
You telling me that this confused you? I think you need a refund on that tape measure.
@ifish4728Күн бұрын
You added distance to the top and bottom measurements.
@michaelcox8255Күн бұрын
U are moving the outside points further apart, it’s not that confusing
@JustinBeckett-cy5doКүн бұрын
I used to have a racetrack in my backyard i drove my gokart
@Verdigris.Күн бұрын
Measure from the floor to the top of the top can and it will be
@nickrowley6615Күн бұрын
Wowowow if the tops becomes higher and the bottom becomes lower you are obviously increased the distance
@eyesonwashington1Күн бұрын
You got the measurements wrong, notice when the can is vertical on the ground and the part that the tape touches, when you flip it around, you’d then only measure to the BOTTOM of the can on the table, not the top, because that’s not the measurement you started with. Look where the tape measure reads at the bottom of the can and you’ll see it is the same 28 and 1/2”.
@leetori1Күн бұрын
Same guy thinks the world is flat
@ProduxnКүн бұрын
Hey I just wanted to say I seen you yesterday at Farmington my brother just bought his first car we have been working on them for a while but just started racing so I was wondering if you had any tips I don’t know if you seen him or not it’s a orange b mode with no number or sponsors also been loving the videos
@OldNo7GarageКүн бұрын
First of all, thanks for watching and being a fan! Second, my advice is whatever chassis it is, stick to their initial setup to get going and tune from there.
@ProduxnКүн бұрын
@@OldNo7Garage cool thanks for the tips good luck this year
@jugghead-1975Күн бұрын
Center lines...think of it as if you could rotate the cans through the floor...half can roughly different
@hueyvan2007Күн бұрын
Cos you're a dumb *ss. Cos you are measuring two different or uneven measurements. Of course it would be different.
@magnusandersson6858Күн бұрын
Ahh the roof of that bulding is upside down Thats why :)
@lruffin944Күн бұрын
Easy, pezy. "When the distance between the cans was first measured, you measured from the TOP of the can on the floor to the TOP SIDE of the can on the table. When the position of the cans were switched, they were measured from the TOP SIDE of the can on the floor, to the TOP of the can on the table. That's where you picked up the additional inches. SOLUTION: In order to get the same measurement the second time, the measurement should have been taken from the FLOOR to the TOP of the can on the table."
@moejoe6587Күн бұрын
Dummy!
@shawnanderson9855Күн бұрын
Good job kid for your first win buddy
@BasedHawaiianКүн бұрын
Tell me you shouldn't own a tape measure without telling me you shouldn't own a tape measure.
@larrynorem2639Күн бұрын
Did you get another chucky for your car
@marcelpa24Күн бұрын
Very easy, you are changing the distance of the cans by inverting them, making them farther away with the second setup. Assuming 7cm of height for the can upright and 2 cm on its side, and assuming a height for the table of 10 cm, you go from 7 to 12= 5cm, second setup would be from 2-17=15 cm. 😮
@davidconway565Күн бұрын
I have neither the time , nor the crayons to explain this to you.
@abelortegajr6681Күн бұрын
When to can is standing on the floor. The start point of the measure tape is higher, and since the top can is laying down it’s closer to the floor. So shorter distance. And when it’s the other way, the can laying on the floor. Start point is lower, and the standing can on the table is higher on top of the table. Lol crazy 🤯🤯🤯.
@cvpawieКүн бұрын
You're measuring the whole length of the can on the second measurement
@deenell9039Күн бұрын
The starting point on the bottom changes the length no matter what the top point does.
@MaydaythepooperКүн бұрын
The height of a can is more than the thickness of from side to side by a couple of inches hence 39 inve 28
@cosseychannelКүн бұрын
Subtract the height of the can
@TonyaFenderКүн бұрын
If you cant figure it out you dont have enough brain capacity to do much.
@victorcastaneda5441Күн бұрын
This just reinforces my belief that TikTok is full of ediots (cant use "foul" lang.)
@djinnntoxicКүн бұрын
People who don't pay attention to points of origin have no business doing math or geometry. It's so obvious.
@ohmimprovement5767Күн бұрын
If you deduct 3" from the top its less than deducting 3" from below? Them are the last 2 beers of the 20 pack he just drank lol
@delroysmiths303Күн бұрын
It's shorter because they've removed the alcohol.
@davidgarciaisabeles-fc9toКүн бұрын
What in the fluff!
@goatcheesefromunda5293Күн бұрын
There is no fixing stupid
@user-kf5xc7pc4rКүн бұрын
Can anybody explain the random red ball that rolls in to the picture?
@user-rx7rd1en3yКүн бұрын
The reason for the 4 inch difference is because the can on the ground you are going down with being that from the can to the ground went from 4 inches to 2 inches (give or take) from the ground. The can on the plywood is going from 2 inches from the plywood to the top of it being 4 inches standing the can upright (give or take). If you take the 2 inches from the ground can (going downward) and the 2 inches from the can on the plywood (going upward) will make the 4 inch difference. Make sense? Nice betting trick though! 😄
@jozefmlynaric8930Күн бұрын
😂😂😂
@terryburgettburgett965Күн бұрын
Hey Tim I put a deposit in the good luck bank for you
@foothillfoo57612 күн бұрын
Think he drank too much of that nasty crap!!!Where's Billy beer?
@briansehovski98542 күн бұрын
The can is taller than it is wide (diameter of round can)
@thespearodiver2 күн бұрын
STUPID IS AS STUPID DOES. 😂
@lastlivingcraftsman62602 күн бұрын
Because you're raising the high point and lowering the low point
@arynschelkun58112 күн бұрын
Do it with pop cans... Those cans are drunk. Lol. Leave the tape measure stationary and you'll see what's going on.
@kaylawohlbrandt99342 күн бұрын
My little boys do quarter midget racing and my middle child keeps winning his heat races and in his main he got third place and young youngest got second place
@KallMeKris22 күн бұрын
28" 1/4
@wayneburton1012 күн бұрын
Don’t let this guy work on your house. He’s stupid. Doesn’t know how measuring works.
@Kartsandvlog60452 күн бұрын
He actually doing good staying up and not spinning out only thing he needs to work on is giving it more throttle
@santiagodelgado57942 күн бұрын
The way this season is going....please don't go to the dome.