😮 Welllllllll…. Slap My Azz and Call Me Meryl!!? I was trying everything and twisting myself in all sorts of knots, trying to figure out how I was going to make the replacement valve and seal the guy at the big box store assured me would work!!? 😂 Thank You Sir, and Hug Them Babies!!!🤗🥰😜
@ldshelts3 күн бұрын
What if you do have a leak in the end?
@theXchange3 күн бұрын
Depends on where the leak is coming from. Whatever the point of leakage, something is either over tightened or too loose.
@janew36374 күн бұрын
Thank you so much!!! Single mom of 3 here and you saved the day!🎉
@CarlosGarcia-ls4hn4 күн бұрын
I would add that even if the fill hose comes out of the top of the flush valve, it will continue to fill the tank, and the float ball will also rise and proceed to shut off the water from the fill valve when it reaches its proper height. I don't see how this would cause an issue, as long as the hose does not squirt water out of the tank.
@Paul-e3l6m6 күн бұрын
Very good video, actually one of the better ones I've watched for this problem.👍👍👍
@shamelesschic94917 күн бұрын
A sincere question: Why not snake the drain after pulling out the horizontal rod? Isn't that quicker/easier?
@theXchange6 күн бұрын
In this case, there was a lot of gunk build up from the kids washing slime off their hands and into the drain. That glue hardens and for me, I didn’t want to flush that deeper into the plumbing
@CharlotteNollette8 күн бұрын
That design f/ the water supply & flush valve nuts area are a bugger! Bad on Kohler.
@DannoDemo9 күн бұрын
Honestly the best, most helpful video - even in 2024! I have a similar model with the same parts/setup and I found this video randomly. It's all accurate, from parts, ease to replace, and what to look out for in the process. All in all it took me about 30 minutes and my - older - dishwasher doesn't squeal at all anymore. Cheers and thanks! (My kiddo also helped me out 😅)
@theXchange7 күн бұрын
Cheers!!
@vincentducusin514610 күн бұрын
I got this same rear view mirror but for my 2024 rav4 xse hybrid. May I know if this is a digital rear view mirror where you can see it up close? Thank you.
@theXchange7 күн бұрын
Mine does not have the back up camera show in the mirror.
@shawnwebb526110 күн бұрын
So you only hand tighten the nuts on the bottom when securing the tank to the bowl? Yeesh, I way over tightened... no wonder I have a leak.
@theXchange10 күн бұрын
Yes. Overtightening can stretch the rubber washers to the point where they no longer form a proper seal to prevent the leaking. Also, over doing it risks cracking the porcelain.
@electricfootballhero134915 күн бұрын
I used mine yesterday, and it definitely works, but after driving for 25 minutes to charge up the battery, then leaving it overnight, the car won't start again today. Time for a new battery?
@theXchange14 күн бұрын
Maybe. You can take it to a local Auto Parts store and they will test your battery for free. If you have a Costco in your area, I would buy your battery from there. You'll save a lot of money, and last I checked, made by Interstate, one of the best batteries out there.
@joseluishernandezharrell777318 күн бұрын
Thanks
@ShotDemEntertainment18 күн бұрын
Love this video but why you put two notes on the toilet bowl when you are screwing it down that will make the ball to crack too much nuts on it it just need one nut and washer to tighten it on the back
@lamolre23 күн бұрын
Excellent job explaining this Kris. I appreciate it. I'm ready to follow your instructions to take care of a slow drainage in my kitchen sink.
@pav197428 күн бұрын
I just bought this kit and it now comes with 3 bolts and 2 tools to loosen and tighten all of the nuts.
@theXchange28 күн бұрын
Nice
@samanthamariАй бұрын
Thank you guys
@CarterArcher-c8tАй бұрын
Lopez Jason Robinson Jeffrey Robinson William
@TheSkyIsFalling_222Ай бұрын
Hi! My Mansfield keep losing about an inch of water behind the bowl… what could be causing this? It fills to the right level when flushed, but I can hear it losing water and It doesn’t appear to be draining into the toilet bowl.
@adelshahsherzai4145Ай бұрын
It worked on my grand highlander and Lexus nx 350 2024 but with the 30 second method. The description was so helpful tnx a lot ! 🙂
@theXchangeАй бұрын
no problem!
@valentinam.3730Ай бұрын
Thanks for the video, very useful for me!!
@KemoHairАй бұрын
Thank you so much❤
@juanzepeda8690Ай бұрын
How to know what replacement part to buy ?
@theXchangeАй бұрын
You can look it up based on the brand of toilet you have. There may be a marking or stamp on the inside of the toilet bowl indicating a model. There are also universal parts that fit multiples of toilet types. Consult the documentation of the universals for fitment to yours.
@annonymous92602 ай бұрын
Only issue is some instructions say to put bolt, rubber washer, then rubber washer, metal washer, nut under tank then finally metal washer, nut. Gives extra protection for water leaks from tank. wish my kit came with extra rubber washers for extra protection.
@theXchangeАй бұрын
Using rubbers for protection is generally always a good idea.
@aywannory44112 ай бұрын
"Can you please tell me the diameter of the circular whole inside the box? Is it 5.08 cm, which equals 2 inches?"
@theXchange2 ай бұрын
I haven’t the slightest off the top of my head.
@wagonwheeldc2 ай бұрын
Nice video. Had to unclog a kitchen sink and couldnt believe the scum.
@theXchange2 ай бұрын
Yea. It’s pretty nasty 🤮
@phillipk.brodie96622 ай бұрын
This video was very helpful. I tried doing this years ago and it took forever. I couldn't get the tank level. After watching this, I think I can handle it next time. The son/cameraman was a great touch. 🙂
@theXchange2 ай бұрын
Thanks!!
@TheUniverseHasMyBack2 ай бұрын
Thank you so much, is had the same problem.... Damn pasta lol... This was so helpful🙂
@bronston812 ай бұрын
If you gotta keep jumping your batteries, do you need a new battery?
@theXchange2 ай бұрын
Eventually, we ended up getting a new one. Problem was that the battery tested good until finally, it didn’t. Plus, with young kids, we often found doors ajar and lights on in the van so at first, causation was hard to determine.
@lonthrall56132 ай бұрын
Excellent instruction! Thank you!
@theXchange2 ай бұрын
You’re welcome!
@Realsmano2 ай бұрын
Kidly rply ik pen se kitna lg loose ho skta ha
@radbond12 ай бұрын
The original hexnut is completely different from the one that comes with the replacement. The toilet gasket is supposed to fit over the hexnut and the tank is then lowered into the toilet. The gasket is NOT to be placed onto the toilet and the tank lowered onto it. It is impossible to fit the gasket over the new hexnut since the new hexnut is not circular like the original. You MUST use the original hexnut and fit the new gasket over it. Otherwise, when the toilet is flushed, you'll get water coming out from under the tank. As you may have noticed, Kris reused the original hexnut without explanation.
@SueEllenLawton2 ай бұрын
Did you have an issue with the tank wobbling as it sits atop that giant tank-to-bowl gasket?
@theXchange2 ай бұрын
It’ll wobble until the tank to bowl kit is installed
@thallyfromhalliewisco26563 ай бұрын
Can you not just replace the broken cap?
@th-sp2og3 ай бұрын
Thank you this video helped a lot
@NissimChudnoff3 ай бұрын
Thanks for the great video - one of the few that also showed the problem, vs. only repairs after the fact. Loved the helper repeating your instructions :) Cheers - and thanks for saving us from an expensive service call!
@theXchange3 ай бұрын
I’m glad the video helped!! I couldn’t have done it without my helper :)
@SonicOrbStudios3 ай бұрын
Tip, flip those channel locks so they tighten as you turn
@theXchange3 ай бұрын
Thanks!!
@nightrangerrules9383 ай бұрын
Kris, thanks a bunch for making this video and it was very helpful. My fill valve was loud and figured my 10 year old toilet needed to be rejuvenated. I received a rebuild kit from Mansfield but no instructions just the parts. The replacement was on spot with your video and got no leaks when finished🚽
@theXchange3 ай бұрын
That’s great! Thanks for the comment!
@robertlouisburns3 ай бұрын
The jumpstart button blinks but then shuts off. Ideas? Is the battery ok but something else bad?
@theXchange3 ай бұрын
The troubleshooting docs states: The HALO BOLT is not sufficiently charged to jumpstart the vehicle. -or- The HALO BOLT detects that it is connected to a vehicle battery that does not require a jump start. This could indicate that the vehicle battery or othercomponent is faulty. I haven’t personally experienced the described behavior to otherwise give a better idea.
@robertlouisburns3 ай бұрын
Thank you for the answer.
@theXchange3 ай бұрын
@robertlouisburns sure thing. I wish I had something more definitive for you!
@newnameauto3 ай бұрын
Thanks
@EVATUBE13 ай бұрын
Thank you for this tutorial. Just tr is rd and nothing happens when i press the jump start button. I only have 2 bars. Im charging it up now and will try again. Hopefully it works 🤞. Rain is coming and my windows are stuck down ☹️
@theXchange3 ай бұрын
I hope it works out for ya!!
@WhiteDoberman3 ай бұрын
P trap is always the first place to start if you're going into the pipes.
@Awalk054 ай бұрын
That supply line coupler looks cross threaded/ crooked other than that this was. A great how to
@theXchange4 ай бұрын
Your eyes 👀 do not deceive you. :). I fixed it off camera once I realized it
@Awalk054 ай бұрын
@@theXchange my flush valve is sticking it snapped the flush lever it’s very hard to flush. Will attempt this project tomorrow to replace flush and fill valve along with necessary hardware
@Speedmark14834 ай бұрын
Thank you for making this video and taking us step-by-step through the process. My drain instantly clogged when an open bag of loose leaf tea fell into the sink and I thought it could easily be flushed down the disposal. The hex key method and plunger method didn’t unclog my drain, so I was thinking that I was going to have to call a plumber. But then I came across your video! After following your steps, I had my drain unclogged in less than a half hour, start to finish. All the credit goes to you!! I can’t imagine how much money I saved from calling a plumber when this was such a simple process. Thank you again, and keep up the great work!
@theXchange4 ай бұрын
Awesome!! I’m glad it worked out for you!!
@MrAmesj2 ай бұрын
125.00 for the first hout
@kevokeefe50674 ай бұрын
Thank you! This video made it possible for me to fix instead of replace.
@donkesterson97084 ай бұрын
Found your video which helped me figure out how to fix my same problem. I bought the part from amzn. The part arrived in a couple of days and before I could swap it we ran the dishwasher again which didn't whistle. I ran it a couple more times with no whistle before putting the part up and will replace if it ever whistles again. My guess is that while investigating I moved the flexible metal clad hose under the washer several times which may have cleared some blockage (just a guess at this point). Appreciate your video greatly though.
@scvvm4 ай бұрын
i love my halo , ive used it for friends and myself , works amazing and an extra security measure, i keep mine in glovebox fully charged🤙🏼
@theXchange4 ай бұрын
Same! All these years later, we have one in each car!
@Rodoman25 ай бұрын
Thanks. 👍
@whyzzman5 ай бұрын
Thanks. Just picked mine up and don't feel like reading through the manual yet...lol