I don’t even like that tape on my slides but I have no choice!

Can I use my tankless water heater with only my 200 watt solar power panels?

Not only did you explain this very well, and with great camera work, but you covered all of it too. I have a 2016 F.R. Rockwell Signature 8289WS 5th Wheel, and was very unsure of how the valve worked. It has the underbelly covering, so I couldn't see the valve to begin with. Online I saw the external gate which this one had, I am going to get that too. But I don't like the idea of getting under the RV in dirt either.. It has a long pull rod out the side at the bottom, not exactly like the one in this video. So, I will have to investigate to find whether it has a cable, or direct as some show. But at least I have an idea of what to expect. And for that I am grateful for this video, and thank you. I just don't know what to search for to find the new valve. I will keep trying.

E6 code 😭🤦🏻‍♀️🤦🏻‍♀️🤦🏻‍♀️🤦🏻‍♀️🤦🏻‍♀️

I need help the head of my anode rod broke off and I can't get the rod out now any suggestions?

Great video, thank you. Enjoyed it. Everything explained so well.

So what’s your opinion when resealing a roof with let’s say “Rubber Roof” you clean & prime then use eternabond then seal the entire roof with 4 coats of Rubber Roof.I used eternabond & used dicor along the sides of the tape to prevent any leaks but then as mentioned I used the primer & 4 coats of Rubber Roof encapsulating everything.Your thoughts???

Yea, not recommending this channel, I'm a paid KZbin watcher (watch/listen while working on reports lol) I spent a month researching this and will be going with eternabond and then Henry's tropicool. It should out live me

Thanks for posting this..The instructions from lippert are really poor. The 3 1/2 inches your talking about is from the top of fascia or slide itself? Thanks again Larkn5

I'll never use this brand until they take the dumb ass URL off the product.

For safe measure is it OK to dump in a half a gallon or more inside the washing machine before drain cycle?

Will a bad thermal fuse also affect the furnace?

To bad the don't provide updates to the units, not 100 percent reliable. I get something else on my next camper.

A kitchen vacuum sealer food packer workers the best for packing bearing, heads up your wife will be pissed!😂

Well done video. I haven't done this in over 40 years (my father was a mechanic I would help him repack the bearings on our cars back in the day). I'll be doing this over the winter on my camper, so a great refresher on how to do it. Thanks!

Total BS Have tried this method and the water heater will still keep getting hotter and hotter and the manufacturer even stated that is normal. Set mine at 95 and it will climb to 137 and lite you up

Thank you, as an apprentice, I find these high quality videos invaluable as I learn the trade

Dude I just fixed my water heater due to your video! Awesome, the thermal cut of switch was bad. I bypassed and the heater worked.

Thoughts on the Lucas green X-Tra Heavy Duty grease?

awesome. Don

11:45a thank you young man your mission's are Blessing.

I just want to know how to get an RV Tech to reply to my emails and quote update requests for resealing my roof.

Great video with one exception. The blue wire is NOT board input power. The blue wire is the fault output voltage that goes to the fault LED light after 3 failed attempts to light the burner flame.

As a technician I disagree with your statement that they do not prevent water damage. Slides are notorious for leaking because of all the seams, potential entry points and the fact that they are flat. With proper maintenance a slide topper can prevent water damage. Looked at one the other day. All the rail seals were compromised and if not for the slide topper they would have water going right in. It’s a lot easier to keep an eye on 40 screws and a fabric for preventative maintenance then it is on a whole slide. Had another case where the slide roof was bowed in the center causing water damage. Owner couldn’t afford the quote to fix- and slide topper it was, worked great no more water entry. They have their purpose for preventing water damage. Thanks for posting

What psi are you blowing the lines out?

Im having a hard time finding your electric side? Do you have a link to that? Your amazing btw thank you for all that you do!!

How do you know they prepped it right? They probably didnt.

I use Flexseal paint on my trailer roof. It goes right over the original seals and covers well. My trailer is 10 years old and has never had a leak. It never cracks and stays somewhat flexible. I really don't care what the roof looks like.

Interesting Legos are more expensive than wire nuts if it’s about a dollar, but I agree do not use that garbage on anything

Aren’t they only 15 amp?

awesome, YES after watching this Video, Thank you Sir. for the detailed

Wago is not push in.

I would argue to say wagos are actually more expensive than wire nuts so im not sure they are saving any money with that

The push in style receptacles are more of a concern than the wagos. Europe uses wago connectors for most tasks and in practice are far safer than wire nuts. There are plenty of comparison videos all over KZbin between the two showing standard wire nuts safety faults. If you’d like more information check out videos from the likes of bigclive. Improper installation is a manufacturer issue but it’s just as easy to have a loose connection with a wire nut.

Very concise procedure. Many thanks for sharing.

You check the topper each time before bringing it in. Look for debris and removing if necessary. That is the only issue we have had in 6 years. You also do the same for the awning. Also, check the mechanisms that there is no sticks or pinecones, etc.

Installed Eternabond on my fifth wheel over 10 years ago! It looks great and still doing great. This is a fulltime fifth wheel with over 100,000 miles on it. Mostly hot, hot weather as we follow the sun being retired!! Go Eternabond!!

just because a guy makes $20 an hour working somewhere doesn't mean you should listen to all their advice. All it usually means is they were taught this by some other idiot. This is awful inexperienced advice. Dicor is a garbage RV industry invention for faster mass production. period. ANYTHING installed improperly is a bad idea.

I came across a guy that says, If you ever want your RV checked for free. Put it up for sale and have people inspect it while you listen to what they say and how they act then always ask too high of a price.

The original mini car had its seals the wrong way around.

Gets rid of the notorious Dometic CT. Finally!

That’s good to know! I’m sure a lot of people don’t even realize it’s worth checking. You have a way bigger option now and are not limited. I don’t have a RV, but I love your channel someday!

you know how you save money on an RV? don't buy one, rent one or know somebody that has one and borrow theirs. same with a boat.

My Dometic WH6GEA works fine on propane but not with electric heating element. Could it be the relay? Where is the relay?

Thank you for the information. Great stuff.

Good video RV Tech, may I suggest less motion with your camera or use of a pedestal and better editing. It would make it easier for newbies to follow your recommendations and your chain-of-thought. I know it takes time but some of your viewers ask very pertinent questions that are left unanswered - at least on this video. Thank you, Ciao, L

The issue our water heater is having is that it will light perfectly fine and run for some amount of time. Sometimes it’s 20 minutes other times it’s a minute or two. Then it will shut off but immediately restart itself. Then after a some time it will shut off and then start again. The duration it runs is random. Sometimes it’s up to 20 minutes but usually it only runs for a few minutes or even as short as 30 seconds. Sometimes the reset light comes on and we have to turn it off, wait a minute and turn it back on. It stays in this on off loop until we either have hot enough water and get sick of listening to it or sometimes it will eventually decide to stop running we presume because the water temperature is hot enough. We’re not sure which of the parts you went over would be the likely issue there. It seems to run fine when using electric instead of gas but we’re not really sure since it doesn’t make the sounds with electric.

Can I leave my tankless water heater button on: I would like to keep on unless I leave out of town because I am a full timer. Thank you!

Saving us money so we can afford you for the hard stuff. Nice!

Are Timken bearings with the extra money?