05 gm blower resistor keeps melting fix!!

This is my way of how i fixed the problem of the ground wire constantly melting the wire harness ,which then leads to constantly frying your blower resistor

[@chrisrector7903]

Best advice I've found yet. I'm going to definitely try this fix

[@wadeparker8695]

This works excellent!! Thank you so much! You’re a genius 👍🏼

[@scottm.3362]

I did this it worked great.

[@devinaube8685]

just did what you did works mint, thanks bud

[@mikeyvlado7665]

Was it hard do i have to plug in the connector after or leave it open

[@jpoppiejaun35]

Mines doing the same thing. Thanks for the fix

[@AngelAlfaro-lf2ze]

How’s it working?

[@jackofalltradeswithmatt9965]

Best fix

[@southbay281]

Same thing with my 2000 Jeep Cherokee. I replaced 3 heat resistors already

[@davidm9214]

Fuse would have been good but awesome. Was wondering why they wanted a new harness with the resistor

[@timrobbins36]

Did the fix last? Thanks so much! Sucks Chevy won’t correct this issue.

[@firstandlast8674]

I am about to do the same thing with my Avalanche. How has this been working long term? Thanks for the vid👍

[@CTUBS-sh5ww]

Were you getting water inside where the resistor mounts? I'm having the same issue but water coming in and frying it. You can smell the wires burning

[@codyfore2460]

What wires can I hook to bypass the resistor

[@jbnap3549]

Is it still working as it should? Been thru this about 11 times also!

[@estebanrexach5422]

Hi did it give any problems after that

[@roltyd22]

It still working good?

[@mikeyvlado7665]

You couldn’t show us where is the other end of the black ground wire so i dont get it just run a wire to the plug and the fram thats it ?

[@Carol-xz6vq]

That black wire goes on up & grounds (gm didn't do a reliable ground) so he cut it & extended the wire to ground it up front right side using a screw to the frame to get a better ground. In turn it stopped the over heating. The old ground he just left, it's useless.

[@mikeyvlado7665]

Dos it matter what color wire i use i only have red ??

[@fredomonmon6091]

Color doesn’t matter, you could always wrap it in black electrical tape if you want

[@wickedlokz1849]

I did that and my blower wont tirn off

[@FatherhoodAndFitness]

Sounds like the ON/OFF switch is wired into the ground rather than the positive 🤔. What is the make and model of your vehicle?

[@wickedlokz1849]

@@FatherhoodAndFitness it's a 2004 tahoe