08 Lancer Coolant Flush

[@ragacore]

I would highly recommend not to do what this guy is doing. Not only poisoning the environment but introducing hose water to the cooling system is likely to build rust in it over time. Do not do what this guy is doing!

[@maungnge1225]

Pp

[@LancerXShare]

so what do u suggest?

[@chevy66driver]

@@LancerXShare distilled water

[@centycents]

Its okay to use hose water, as long as you flush everything after with distilled water, then put on the coolant finally.

[@DamoclesMedia]

It’s not very responsible to just drain your fluid onto the ground. Bottle it up and recycle it.

[@AZ-wq8pk]

@Lord Humungous thats not how the "rest of the world" does it u probably mean americans 👎

[@DennnnnnnY]

This guy has no idea what he is doing 😂 dude popped off the lines.. there is a simple drain valve on the bottom driver side . Running that tap water through the system is going to corrode the inside with all those minerals. That poor car…

[@kamilmhpet]

Yup. Use the drain pipe !!!!

[@olegpokotilov2613]

Why are you running antifreeze on the ground???

[@MtzClan]

Just like other comments, I'm pretty shocked you just drained the coolant onto the ground. Not very responsible of you, hope you don't do that with your motor oil changes.

[@michaelbrennan8294]

It's a big ocean.

[@DazeOverMatter97]

All I was looking was how to change the Antifreeze and you did some other shit that you don't have to do when changing coolant

[@jagm44]

Good video thanks from México 👌🏻👍🏻

[@gafurrzogaj7090]

Should use distilled water tap water will erode the radiator

[@uittyman]

Engine looks like the same as the 2012 mitsubishi rvr. Not my vehicle of choice. Great video

[@Driving4bangers]

Dude what’s your problem letting it just fall on the ground

[@nhellyp4113]

Hahauravirgin laziness bud!

[@jonahiuskemboi919]

Hey, where is the coolant temp sensor located ?

[@ronanrogers4127]

Poison on the ground...great advice

[@sydneyNemesis101]

Awesome vid!, is there a bleeder screw down the bottom of the radiator to drain the coolant? or is removing the bottom hose the only way?.....

[@tntsr1]

I wish I knew

[@nivas8634]

There is a bleeder screw available at the bottom of radiator. No need to remove hoses

[@oof578]

For a flush like that I would of suggested distilled water. Not sure if hose water would have any long term affect as far as corrosion goes but i'd assume if it were all cleared and only the new coolant remained I don't see a problem. Also reverse the heater core hoses and push water through it to clean it well but with low pressure. A water hoses pressure could damage it. As far as pouring coolant onto the ground I wouldn't recommend it due to its toxicity. I've got an 08 Lancer GTS and just serviced all my fluids.

[@robertmedina3195]

You really think the pressure from a water hose is going to be stronger or as strong as the pressure from a water pump?

[@oof578]

@@robertmedina3195 doubt that but reversing the hoses on the heater core and then sticking a water hose to the exit and flushing it out of the inlet isnt good

[@yemyesil28]

there is a problem, 09:10. jingle valve position of thermostat must be up, you see 06:00. you will have air bouble problem on your coolant.

[@boostxrabbit87]

Few things I’d recommend. 1. You should really drain the radiator using the peacock on the passenger side of the radiator. 2. Please catch all the coolant and recycle. Please stop being lazy. 3. You coolant color from 08+ should be blue, not green. The formula changed to help with rust inhibitors. 4. Exactly what you’ve done in this video is THE REASON why manufacturers make their systems more complicated to keep back yard hack mechanics like you from working on them. Please stop and hang up your tools.

[@jonathanconway]

Exactly! So lazy, didn't even use a funnel to pour the new coolant in lol, just free pour and let it splash everywhere

[@anlatanokuz217]

Where is the engine temperature sensor on Lancer 2008 and above?

[@Richard-mq3sm]

You don’t need the RTB with a that thermostat. It has the rubber seal on the thermostat already.

[@Ironace-wb9sx]

I should've stopped watching after you drained coolant to the ground!!! Instead I stopped watching when you introduce tap water to cooling system! Smh!! YOU should've watched a video on this before you made a video on this!!

[@igl9273]

I have a 2009 Lancer ES and had a problem after replacing the thermostat. I didn't put the gasket maker and it leaks all the time. Where should I put that on? I'm afraid I put it in the wrong spot, and it will damage the thermostat. Also, should I change the temperature sender sensor as well?

[@BJteBEAR]

did u clean the coolant reservoir Ray ? If yes and u did empty it, do u fill it up with coolant u just let the coolant that was poured in the radiator flow thru ?

[@gafurrzogaj7090]

You should definitely have a catch can for that coolant so it doesn't go into the water stream 😒

[@1793xman]

Why you engine room so dirty?

[@GrandstandVideo]

flush fail in so many ways.

[@AlienMonkeyDXB]

Why remove the hose? The other side of the radiator has a petcock valve to drain it... Oh and also, shame on you for draining it onto the ground.

[@chupacabbra5606]

fkn moron

[@tariktarik5202]

Thank you man

[@najamshafi8041]

THANKS

[@ntamichael9343]

Can I remove the stamostar completely?

[@Raysgarage90]

Yes you can. :)

[@jeffersontamor9888]

How many liters of coolant is needed? And how many liters for distilled water?

[@jamesmuthiani5680]

7.5 liters for, 50/50 water and coolant. Check owners manual for capacities.

[@spookymonkey810]

Do your rad fans turn on half way on your temp gauge?

[@anlatanokuz217]

Where is the engine temperature sensor on Lancer 2008 and above?

[@Raysgarage90]

Hey bud. I believe it’s located under the intake hose. Remove the air hose and you should see the housing and on it the black connector!

[@anlatanokuz217]

@@Raysgarage90 thank you

[@DailySends]

What kind of anti freez did you use

[@fixitfelix718]

My 2017 Outlander has the same exact engine wtf

[@osomdn]

Fix it Felix Appliance Repair i dont think so... the 2017 engine isn't noisy

[@DaDaDo661]

A lot of the Mitsu models use the 4b11. Even the Evo X uses the 4b11 as a base. It's just turbocharged and a few other fancy internals . It's a good engine mine is currently at 280,000km

[@paulmartinez4150]

Irresponsible for just letting antifreeze drain on the ground, its poisonous to animals and just lazy. If ur gonna do a how to, at least "try" and be responsible. Now ur just breaking the law and putting it on the internet with ur name attached to it.

[@Driving4bangers]

No wonder your car sounds the way it does

[@najamshafi8041]

is it necessary to change thermostat ?

[@osomdn]

najam shafi yes

[@dappa211]

once you buying either genuine or from a high quality manufacturer.

[@warriorxtman2]

Over doing it

[@lt3880]

Not even that, he still has mineral water in it so it still needs a proper flush. Awful video

[@kikofromtro5882]

That engine sounds like shit tho 😂

[@musicwiz40]

That's how lancer engines sound. Nothing wrong with it. Just something wrong with the guy working on it.

[@osomdn]

you engine is too noisy, all ok?

[@lt3880]

I dont know what to say, just about everything here is a terrible idea