#105

[@thomaskirkpatrick4031]

Nice to see someone packing bearings the old fashioned way.

[@TatroMachine]

it worked than and it works now too. tatro

[@Believebible]

It’s good to see you Tatro your like an old friend. You should start a annual bike run

[@davidcortez5614]

You're a master and great teacher Tatro.. You losing that seal though, cracks me up every time.. I saw a video where you had long sleeve T's, with your logo on the sleeves. Can't find them on the website. Are you out of them?

[@TatroMachine]

thats because very little of the apparel i have is listed. just email me what you want and i will see what i have. tatro

[@ahill7099]

Just like you were never missing glad to see your back at it. Now I need to get at it. Have a 74 needs all kinds of work. Have a cheap rectifier or regulator but has red, green and black wires. No instructions....do you know which wires go to generator. Thanks a million.

[@TatroMachine]

i am not sure but i would go with, armature -red field-green battery positive-black tatro

[@ahill7099]

@@TatroMachine thanks tatro for help means alot time aint cheap

[@izzynutz2000]

The picture of my trike in the front of my page here I had that Halcraft Springer front end on it I went through and rebuilt all the rockers to make them greasable somebody had gone through and all the pretty acorn had them cross threaded they had to be cleaned up in the front 21 inch tire and wheel that I had on there it had radial bearings in it and I'd get about a thousand miles out of those radio bearings before they'd start giving me a problem until I finally made a sleeve carefully measured on the inside to put the proper tension on those bearings I always wanted to change it over to a timken bearing but never got to it..

[@TatroMachine]

good job, you found the problem and fixed it. the balls are fine for your aplication. tatro

[@kthesaint5247]

Hi! Is it important to replace it by original or get an aftermarket (As both are made in China) can you advise me Please, Thanks again

[@TatroMachine]

i like timken bearings and cheap ass old seals. they work better than this new crap they make now. tatro

[@benderbender1233]

🤘