10R80 part 2/5 disassembly

[@sageteichert6706]

So i just attempted a rebuild on my own 10r80 with 230k miles. Thanks for the video it was very helpful. I got everything done and reinstalled on the tight end of clearances. It had a bad CDF Drum. I took it for a test drive, and it was working fine for several miles. Shifting gears like it should nice and smooth, then it threw a maintenance wrench code saying sensors D, and C and friction F were not happy P0766, P0762, P2705. Could hardly drive it, stuck in 4th gear, motor would rev but very little transmission engagement. I pulled the valve body and rebuilt it and found a stuck valve. Reinstalled, reset the shift logic with Forscan, cleared shift tables and codes again and went for a drive. It drove beautifully for 10 miles up a gentle hill temps up to 180 degrees then back down the hill. Pulling back into the shop to top off fluid at temps the same symptoms happened. This time showing shift solenoid E stuck open. With little to no response in any gear. Any idea what could be going on? Talking to local shops they are thinking it needs a new valve body. One said to get clutch clearance more towards the sloppy side.

[@danielclawson2099]

Did you ever figure this out?

[@kfrench201]

Had one of these come into my shop a month ago with a P0733(gear 3 incorrect ratio). After checking pressures and electronics I determined the 3rd gear clutch pack was slipping. Rebuilt transmission and now is driving like new. Disappointing at only 65,000 miles. Transmission never abused(I know the owners), never even towed. Would of liked to figure out cause but couldn’t determine. Just appeared to be random.

[@larryhensch2280]

Thank you for your time so very impressive

[@mejiamedina240880]

Good video I love but how is the transmission know when is on park or reverse or any one

[@Samraheem]

Thank you, I swear I connect in the same boat was make sure if I do anything wrong, but I connect them correct thank you

[@Benz4880B]

What brand of blocks do you use?

[@RagnarNomad]

Thanks for sharing, but I wish this video were in 1080p resolution.

[@juniors9699]

Do you have reprogram after reinstalling 10r80 transmission

[@fabrikjack]

❤❤❤❤❤

[@noeltrujillo6154]

Question. The line pressure port bolt that is pointed out. Can a transmission temperature sensor be installed there with out damaging anything internal? If so what size thread is that bolt? Thanks

[@mazharahmad3741]

Hello sir

[@Samraheem]

Actually منتخ بصلاة جنو عدل تركيبي 🤣🤣🤣🤣🤣