Installing crankshaft and checking gap between bearing surface and crankshaft.
Пікірлер: 8
@Masseyferguson653 жыл бұрын
I just found your videos from your Ford major projekt and I Really like it so much .. Will you allso make a video off the first start after rebuild 😊👍Thanks so much . I injoy so much to watch you. Nice tractor you have . I rebuild a massey ferguson 65 reighte now here in Norway . Keep up the good work to your old girl 😊😊👍👍Michell. NORWAY
@MarshallSmart3 жыл бұрын
Thanks for that a few more videos to come M 😀
@rokybalboa46252 жыл бұрын
Eu estou aprendendo muito com o senhor mesmo não entendendo o que o senhor está falando, porém compreendo tudo
@MarshallSmart2 жыл бұрын
Na metade do tempo também não sei do que estou falando :-)
@rokybalboa46252 жыл бұрын
@@MarshallSmart que legal 😂 😂
@cg79753 жыл бұрын
Front bearing cap should be aligned with the machined front of the block using a straight edge prior to tightening. Failure to do so may result in an oil leak between the bearing cap and the front mounting plate.
@MarshallSmart3 жыл бұрын
I did know that. I measured the distances both sides with verniers to check the alignment and both sides were the same. It is in the manual to check it. Thanks for the info M 😎
@cg79753 жыл бұрын
@@MarshallSmart Well done, (a lot of work to put it right afterwards).