1969 camaro body assembly using AMD parts

1969 camaro body assembly using amd parts, amd quarter panel issues

[@martinmoreno2597]

good work!!!

[@indman101]

I owned a few 1969 Camaro's years ago wish I would have kept one I replaced the drivers side door and partial floor pans but wasn't impressed with the thin sheet metal that was available back then has anything changed with the quality of the sheet metal or thickness?

[@1194video]

No it’s still all junk reproduction body panels

[@hollyrock911]

Alot is good and some need a bit of work. Yes, it is thicker. i built a 69 from all AMD that was available and rest from Dynacorn.

[@user-de6zl1nz9e]

Good work, where you located, and what do you charge, thanks david

[@1194video]

Tennessee, I usually just look at the job and price depending on what’s required

[@jcook69camaro]

AMD - All Metal Damaged

[@davidbrown-55]

Gd work. Those quarters suck

[@1194video]

You can say that again

[@user-ey3ph2wz7e]

70chevelle

[@1194video]

This particular car here is a 1969 Camaro

[@darylmorse]

Those quarter panels are junk. I would be very disappointed if I was basing my new build on such poor quality parts. I'm surprised you welded the body top / outside to bottom / inside. Other builds have started from the bottom and worked upwards, literally starting from the rear frame rails and then putting the floorpan on top, in a jig. That's how the factory did it.

[@1194video]

I build everything off the doors, no matter what it is, if the door is right with the pillars and rockers then everything else will start to form up

[@coydoyle2424]

What I'm a wunderin is, what part of Boston, or New York is this guy from????.....HAAAA!!!!!

[@1194video]

I’m from TN