1991 Toyota MR2 Turbo 5SGTE 3" Exhaust Rev + flames

Just a clip of my 3" exhaust on the MR2 turbo and how it sounds. Spark plugs are starting to fail, have 15k miles on these plugs which is the reason the idle is at 500rpm lol
10psi on the factory gen3 ecu... Honda p28 ecu coming soon!
4" cold air intake
Built 2.2L 5sgte.
3rd gen 3sgte topend
94 5sfe block
JE 9.5:1 forged pistons
H-beam rods
ARP headstuds
Cometic MLS 1.2mm headgasket
Top mount setup GT3076 turbo with 38mm external wastgate
Fidanza 10lb flywheel
Spec stage 3 clutch
custom 3" downpipe
Aem wideband
Walbro 255lph fuel pump
1.5" screamer pipe

[@LakeBuilt]

A Ebay sidemount with a fan attached to it... On a hot day the IAT is about 100-110 degrees

[@ForcefulPlatypus]

Would building a 5S-GE be worth it? (N/A, not turbo.) Also, what revision block and head did you use? Did they bolt right up or did you have to adapt the oil and coolant passages?

[@tevinm14]

awesome, Im looking for a sidemount to replace my stock one, I was looking at the one ATS has but the ebay ones are pretty cheap compared to ATS, is it a good investment?

[@LakeBuilt]

I am running 255/40/17s street tires in the rear and I do have traction problems from 1st-3rd gear under full acceleration

[@nickadkins7765]

Chris Lesmerises u hear compressor stall...real compressor sure is that fluttering noise u hear while UNDER boost, not after the throttle body has been closed (letting off the gas)

[@LakeBuilt]

Will do that sometime soon

[@robodinoPSN]

Or do you have slicks?

[@Tesstickles43]

Proper sounding toyota

[@iFeaturing]

post a walk around

[@ChrisLesmerises]

I hear compressor surge

[@robodinoPSN]

Hows it run in 4th? And i know it depends on your tires, but, do they trip when you accelerate?

[@tevinm14]

What kind of intercooler you running?

[@RGBLackson]

So did the gen 3 head bolt right up to that 94 block?

[@LakeBuilt]

lmao ok dude

[@drbos]

Really.. lol