1994 KX250 Rebuild Part 2 (New Bearings, New Seals, New Crankshaft)

Part 1 of the '94 KX250 Rebuild: • 1994 KX250 Rebuild Par...
Watch the whole series here: • '94 KX250 Rebuild
In part 2 of the '94 KX250 rebuild the crankcase is now ready to be reassembled after being vapor blasted. New bearings, new seals, and a new crankshaft were installed to help restore this bike to what it would have looked like on a showroom floor in 1994. We also show you how to install bearings, seals, gears, shift forks, and the shift drum the correct way. While our method of mating the two halves of the case worked for us we highly advise to use the correct tool, of which an example will be linked below. This video, while not meant to be an all encompassing guide, may serve as a general guide in assembling any crankcase as many of the fundamentals are constant across different brands and bikes. In regard to questions about this build drop a comment, we'd love to share our knowledge with you!
Tools:
For any business inquiries direct message us on Instagram @mppowersports.

[@DJsGarage]

Crisppp

[@therealbruss9946]

Been looking for a channel like this for a while, I came over from Braydon, Christian, and Garret. Learning a lot too, thank you!

[@barnabyjones7823]

Man this is the way to make a video,wish more videos were this informal .

[@antera007]

The best instructional video I found after going threw a few others ..when i found this one watched it and I'm wrapped cheers mate

[@tensionteamoutdoors5159]

so informational, keep it up brother🤟🏼🤟🏼 patience is key

[@doodlebob069]

Heat the cases in the oven and freeze your bearings. They’ll drop all the way in no problem

[@ToonedInn]

Bro my crank tight after I heated bearings and slid on. I did use the screws to tighten it crank in

[@CarlosJuarez-du1cp]

Hey man i have the same bike and I’ve been having some trouble finding which expansion chamber to use would you by any chance know which one I can use

[@Dulanjaaravinda]

I am a Sri Lankan youth. I have a kawasaki kdx 250 type bike. Year of manufacture 1994. I need your help

[@shanehutchinson785]

Have never had to yse a puller crank just falls in crank bearings

[@Spataman9]

Throw them bearings in the freezer

[@petermerz9433]

Im that guy that who was like why aint the tranny spinnin🤣

[@keydogd]

Are you not right. I hope this isn't your day job