1995 Mercury 115 Water Pressure Gauge Installation

[@plwaldelap123]

An excellent video explaining a PSI water pressure gauge installation.

[@sick66caddy]

I have a commander with a 250hp outboard- and I actually use both a temp gauge and a water pressure gauge. This video was what I actually used to learn how to install the pressure gauge

[@liemh9290]

Ted us my new hero

[@GibsoLesPaulStandard]

Great video!

[@albradley5527]

Question: Does the water pressure gauge you installed use water to make the needle on the gauge move up or does it use air pressure ti make it move?

[@striker1211]

Amazing video! I've been contemplating replacing my "water temperature sender" with a pressure gauge but have always thought it too complicated... your video makes it seem so easy. I love that it uses the same hole and it'll likely even fit my dash. Do you have to drain the hose before the winter?

[@Honda1k]

No it works off air there is no water should go into that line at all

[@albradley5527]

It gets more complicated if you have to run the hose through a tunnel to get to the gauge.

[@richshadwell5561]

There is no video on a stuck all the way open on my bass boat water gauge

[@edwardplaia3254]

question: Do you need it? my hose has a few pinholes. Do I need to replace it? Can I just let it spit out the back and not have the gauge set up?

[@philldownes8685]

replace the hose you greedy sod......... you can easy look at gauge and see if everything is ok, cant keep turning your head round and see tell tale....