1996 FORD F350 TIMING ADJUSTMENT

[@perryjacobs4093]

TDC is when your #1 cylinder, Rt. first cylinder is at the top of stroke. Put your timing (light) pick up on #1 plug wire. Use soap stone to make two marks, TDC and 14* advanced of TDC. Time with spout removed, which takes the EEC off line. Firing controlled by engine mechanically. Tighten distributor down turn truck off, return spout to plug reconnecting EEC. Start vehical, the computer will make any fine adjustments to timing necessary. Drive vehical on a varied route for 20 minutes, computer will learn and adjust engine control sensors and function properly…

[@TPProtege]

The black clamp on the timing gun goes on cylinder 1, not the ignition wire

[@malcomflot2288]

There's lots of question, as for the induction wire clamp, and the amount of degrees to advance; However, this video helped me to verify the SPOUT connector on my "97". So thank you, for putting this out.

[@rickywells4205]

Supposed to be set at 12 degrees before top dead center after the timing is adjusting your supposed to put the spout back in and you're supposed to put the timing gun on number one spark plug

[@charliedefilippis3442]

Don't you put the lead on the #1 plug wire and mark 10° ?

[@ethan5989]

Do u know if u mark on 10

[@pepitofeliz7862]

Yes why on the coil and not on plug 1 wire?????

[@jimenezomar7855]

Try your neutral safety switch I was having that problem as well

[@hendricks177]

Can a bad spout connector cause engine timing to be off and also cause really bad rough idle?

[@kylerdriscoll687]

If your timing still isn’t right but a spout module for your truck

[@cmb3664]

Can you possibly send link to purchase that bbk fuel pressure regulator you have can’t seem to find it

[@sivakumarloganathan112]

Damper pulley Timing Mark how much degree?

[@davidboston4574]

This is how you DONT do this

[@strokinbaby965]

Thats my old truck, I lost the spout one day when i was timing it lol, never did find another one for it.

[@toddinfl]

You can buy it online

[@racerx5379]

I Found one at the junkyard 😂😂

[@josephcervantes6872]

More on the project prerunner ranger.

[@BostonsWhitey]

thanks needed that info

[@bobbyheffley4955]

Is this a 351W or 460?

[@ryanduemmel9033]

0:08

[@Greg-pb9gc]

Your check engine light is on!

[@racerx5379]

😂😂😂😂😂

[@Junkyardog]

Bring back the ranger!

[@josephcervantes6872]

Yes!

[@bobsmith1101]

You could sell the guy an exhaust system. Sounds awful.

[@hendricks177]

Can a bad spout connector cause engine timing to be off and also cause really bad rough idle?