1997 Honda Accord Inner Tie Rod Boot Replacement/ пыльник рулевой тяги

[@VITOSGARAGE]

Mercedes first start in 10 years! Crazy! Must watch! kzbin.info/www/bejne/amObq6iYq6Z7Y68

[@KingTrunkzdbz]

Great video brother, bless you for making it, l need to replace both my steering boots on my 96 Honda Accord LX, this video will be playing as I'm doing it.

[@chrisramsey9144]

If you're going to use zip tie make sure you cut it and then take a small file to the rough / sharp edges because they will cut your boot over time

[@PhilSmulian]

Great video man, thanks for making it. Glad to know that it is simple enough to do myself.

[@eastac4680]

Thanks for the video Vito doing this right now man pain in the ass is too tight spot where I'm working to Jack the car up more unable to lack of Jax only one Jack stand appreciate video

[@philztheone]

Great video dude! And all of it one! handed! Bravo! Thank you! I heard grease will degrade rubber bushings.

[@VITOSGARAGE]

Thanks for watching. Grease won't harm it. If you use silicone grease that will be the best

[@philztheone]

@@VITOSGARAGECool! Horosho! Will buy some silicone grease.

[@johnnywalker3128]

You forgot to to show us the struggle of putting the boot on on the tube

[@VITOSGARAGE]

No way. Ok let me redo it and show you the struggle again lol

[@roysabanero1184]

Hey you happen to know the part number for the boot I can’t seem to find it anywhere

[@sirtubemaster]

Seemed like a lot of movement on the inner joint; since you had it apart you should have just changed that part out also

[@Shooter_POS_Mcgavin]

Is there any way to remove the inner clamp without destroying it?

[@Califormula]

Jesus Quezada no. . . one time use

[@EsenbekAliev_]

what grease you used and what cleaner you used?

[@VITOSGARAGE]

ealiev60 Wheel bearing grease and brake cleaner

[@lazaronovoa37]

Are his tie rods upside down???

[@jabbacoola1]

No

[@rookie1178]

What does the small hose on the end of the boot do? I found mine off today while doing checking my 99 civic

[@1peanut]

hose is directly connected to both left and right boots. When you steer the air pressure in the boots goes back and forth. The boots can expand and contract evenly. this helps keep them sealed in a clean environment.

[@rookie1178]

@@1peanut My hose has been snapped off for a while now, what's the danger of not replacing it

[@1peanut]

​@@rookie1178 without the hose. your boots will suck in air, dust, sand and moisture. This contamination getting on the components can cause premature seal failure of the rack.

[@rookie1178]

@@1peanut well that's not good. Thanks for the info

[@AP-oj7fl]

It looks like you need to replace your inner tie rod. You shouldn't be able to turn your inner tie rod that easy. It should be stiff. PITA un-staking the nut securing the inner tie rod to the steering rack.

[@VITOSGARAGE]

I agree. But the inner tie rod didn't have play. If it had play I'd have replaced it. But again, it's not my car. Thank you for watching. I post new videos every week. Let me know if you enjoy any of my latest videos. Cheers:)

[@DOUBLE0SEVUN]

Do I need to do an alignment if I take off the outer tire rod end to replace the boot?

[@VITOSGARAGE]

Of course

[@DOUBLE0SEVUN]

@@VITOSGARAGE I made a big mistake then lol. I replaced the inner and outer tie rods and noticed the boots were tore up but didn't replace them. I already had an alignment done. Will it damage them if I leave it without the boot?

[@VITOSGARAGE]

+DOUBLE0SEVEN Your rack will start leaking eventually and the inner tie rod will wear out depending how bad the boot is torn

[@DOUBLE0SEVUN]

@@VITOSGARAGE ok thanks!

[@Hilary-ys1gk]

DOUBLE0SEVEN Get ready to spend close to a thousand bucks replacing it....if you can’t diy

[@EsenbekAliev_]

is it ok that boot is oily?

[@VITOSGARAGE]

ealiev60 It means your steering rack is leaking

[@Manuel-sw5vb]

Were you buy the boot at

[@Manuel-sw5vb]

Were you buy the boot at?

[@leong2023]

I hope you let the customer know that you used a zip tie! If the rack is leaking, the zip tie will be dead!

[@hmayor3745]

L Gal I put a zip tie on a boot 6 years ago, no problems at all

[@leong2023]

Hermano Mayor thanks for the tip.

[@philztheone]

@@leong2023 Yeah, zip ties are commonly used, right?

[@iamasmurf1122]

painfull to watch you remove that ring , buy sidecutters and cut it all off you dont re-use them its wasting time same with the inside ring you cut them

[@debeerpaul]

Who in their right mind puts a nipple on a tie rod boot. This is such a shit job. Tx for the video.

[@eastac4680]

Oh yeah then I put in that Carter PIN on that castle nut