1998 to 2003 Mazda 626 Factory Transmitter Remote Programming How To

1.Remove key from ignition.
2.Close all doors.
3.Open driver side door and leave open.
4.Perform the following steps within 24 seconds.
a. Insert key in ignition.
b. Turn key to ON and OFF.
c. Repeat step b two more times.
d. Remove key.
e. Push driver door frame button three times (black rubber button located on driver door frame that tell the vehicle whether or not door is closed.)
5. Buzz sound, chime or doors will lock and unlock should be heard at this point signaling that the vehicle is now in
programming mode. If not, wait 40 seconds and return to step 4.
6. All transmitters need to be programmed at this time, including the old ones. Push any button on the transmitter
two times. A buzz sound, chime or doors locking and unlocking should be heard at this point signaling that the
vehicle has accepted the new transmitter code. If there is only one transmitter, repeat this step two more times
using the only transmitter. If there are two transmitters, repeat this step two more times using the second
transmitter.
7. Push driver door frame button one time. Two buzz sounds, chimes or doors locking and unlocking 2 times should
be heard at this point signaling successful programming.
1998 to 2003 Mazda 626 Factory Transmitter Remote Programming How To

[@scotttimothy64]

Worked perfectly. Thanks a bunch! The ebay dealer I bought the remote from said it would only work with a car with a certain FCC ID number. I verified my FCC ID with the local Mazda dealership and they said I had the alternate FCC ID (has to do with whether you had your remote keyless entry installed from the factory or from the dealer, allegedly). The remote still programmed fine. So that was a relief. $14 shipped and I now have a remote to lock and unlock my doors. Beats the $150-$200 you would pay from a dealership.

[@264fan]

Worked first try on my 1999 626 . Thanks for sharing your knowledge !

[@udomueller8627]

Thank you so much. Just folowed your direction on MUY mAZDA mpv "03 and it worked with my first attempt. You're awesome. Thumbs up.

[@LillianeMColdwell]

Worked like a charm, thanks!

[@acharyachandan]

Can you help me.. Mine did not work... Everything is good till step 4 except that once I press the Keyfob Unlock button twice nothing happens.. I have a 2000 Mazda 626 and the owner manual says that it has keyless entry. I bought these two key fob in ebay

[@acharyachandan]

+Chandan Acharya In fact I tried pushing the lock button as well.. still no communication

[@eboyyooo5589]

Can this happen from a car battery dieing ? Cause mine worked until the battery died now nothing