1999 Chevy Suburban K1500 - Door Hinge Pins

Door Hinge Pins in a 1999 Chevy Suburban K1500. Also installed a new Door Detent/Roller Pin & Spring

[@ctjanney]

This video was my guide to replacing the pins on my 1999 Suburban c1500. Your view of where the copper washers go was key to this working beautifully. Thank you.

[@limited50scla]

Did you have any issues replacing them??? I have a 2000 tahoe limited OBS. I took out the factory bushings which which were make of thin metal and used some Autozone pin kits. They are made of brass they were a bit too big and I grounded them and they failed fast. Then I purchased ac delco bushings which I saw your truck had. And they were also too big. Will I have to bore out the whole a bit to accommodate the bushings?? Thank you

[@jimdandy6472]

You shouldn't have to bore out the holes. Using a small hammer and some 3/8" extensions, the bushings should tap in without too much effort. I've only done this one job and it went pretty well. GM has a bad design with these and they just don't last very long. If you get two years you are probably doing pretty good. There are a couple other pretty good videos out there.

[@tigernick6819]

Im having dame issue were do you get the smaller bushings 1999 truck

[@limited50scla]

Tiger Nick GM PART NUMBER 15994345

[@tigernick6819]

@@limited50scla ill check it out thank you

[@limited50scla]

Tiger Nick or DORMAN 38488 you get a PAir For $15 or so.