2.2. Sling TSi Wing - Skins

[@Finder245]

How would you replace the control box and/or pitot tube with this setup? It seems that it would be very difficult to do so through the inspection hole.

[@flexairz]

Tip: do not use the airframe for any return ground. It will induce electrical issues later on.

[@chriskroeker1889]

What do you do for slack in the tubing if you have to replace the pitot assembly? Isn’t it typically pulled down to work on?

[@antoniog9814]

2:02 Hi Evan, do you know if TAF has remedied this situation or is this workaround still required?

[@ibgarrett]

I am quite literally at this phase of the build and was in the process of cleco-ing the skins on. I added the panel reinforcement plate on before I put the skin in place just to make it easier. When I checked today the rivets are in place and well clear of any obstruction. The wing I’m on is the right wing. I expect to have the left wing on the bench and start working on it this week. I’ll report back if I find the left wing being any different. But from what I can tell, this issue has been resolved (kit #277).

[@miragechaser]

It's been fixed, they shortened the bracket to remove the interference.

[@feidelsol]

👍

[@ipanzerschrecku4732]

You should learn how to add chapters to your video with explanations in order for builders to quickly reference a segment of interest. You're going over so much information that a lot of the good pointers gets lost.