2 Step Truck Wash

[@paulbrown8370]

I never had to turn anything, and i carried about 750 gallons of water all the time, and i used the two cleaners also, but i didn't have to turn any nozzles in order to get the other chemical to come out, i just let go of the trigger on the gun and the squeeze again , and the i had the other chemical comin g out and do the same thing for the clean water, and i used a four foot wand not a 6 foot. I spent much time on cleaning the alumin um wheels to get them nice and clean. Yes, you do have to watch the acid because the HF acid would hurt the glass if it dried on there and some of the anodized aluminum would turn white if you weren't careful. My equipment was all mounted inside my van and i had about 30,000 dollars worth of stuff in there and four different chemicals ad wax as well.

[@Locdwithwill]

Can I pick your brain boss ?

[@BigJim_909]

Okayyyyyy

[@TheRealHistoryBuff]

Wow good knowledge. Thanks

[@donmelton3289]

Years ago EPA was cracking down because of runoff with grease and spilt fuel running into the ground. Is there anything changed on their outlook at this? Thanks

[@Cougardifference]

Never let oil or fuel run off. The cleaning detergents used here are phosphate free and when used together, they neutralize each other so the impact is low but many municipalities require all run off water to be captured and recycled. If you want to capture and recycle, we can outfit a mobile system with a reclaim system like this one: kzbin.info/www/bejne/p5acZpmgoMh7h9k We can also offer a dedicated mobile reclaim system from Landa, the ECOS trailer: kzbin.info/www/bejne/aXy9l62Ygth6ldk

[@deepsouthdiggers580]

Did I understand you correctly when you said that the 2nd step process (soap) is run through the pump?

[@michaelfields9084]

That is correct. The high pressure (upstream) injector runs through the pump and the burner.

[@deepsouthdiggers580]

@@michaelfields9084 Thanks. I was under the impression that you should never run any type of chemical through the pump.

[@michaelfields9084]

@@deepsouthdiggers580 gotta be a bit careful. As long as the chemical is not very corrosive and you flush with clean water, I'll effects are pretty minimal

[@sharonmartins4356]

After doing the 2 step process, is there water spots left behind and is buffing going to be necessary?

[@Cougardifference]

The 2 step process, when done correctly, will not cause water spots. Here in Memphis, we have really good water so water spots are not much of a problem. If you are using hard water with a high level of dissolved solids, you may need to either treat the water or add drying to your process.

[@jiffyclean9429]

Use a spot free rinse water tank. They are not expensive.

[@joseprata4159]

I would like to know if do you have a office or representative in Brazil!

[@jamesknox4850]

Do you downstream your chemical straight or do you dilute it

[@Cougardifference]

I typically dilute 50/50 and adjust the injector to the lowest chemical flow.

[@randslites]

Great info , thanks.

[@blakeengland7784]

I'm interested in pricing and shipping, also if these chemicals are polish safe

[@jorgepineda8043]

How do you get your soap come out with a lot of pressure

[@Cougardifference]

You have to have a machine with a high pressure chemical injector. Be careful, what ever detergent you run high pressure is going through your pump. High caustic or acid detergents can cause damage to a pump. Our #2 Transpo wash was specifically blended to run in high pressure applications. Not a detergents are.

[@landybonet7527]

How much per truck..?? Or at least average

[@abrahamdiaz9376]

Im really new into fleet washing. I want a setup like this one, how much will it cost and where can I get all the stuff to begin. Will I need a Cube van or truck and trailer to move the tools. Please help me out

[@Cougardifference]

Abraham, a unit like that would sell for $20k - $25k. We do have options for about budget. Give us a call at the shop, 901-362-8373 or email [e-mail]. We can discuss your needs and options to get you going.

[@texaspremierpressure3274]

How can I get some of that chemical you are using in the 2 step porcess?

[@Cougardifference]

Give us a call at the shop, 901-362-8373. We can freight it to you.

[@Hadden_gunSlinger]

I'm 16, and Im looking into doing this. Context: my dad works for a small trucking business. His boss was saying that something happened to his truck washer (or he did a half ass job) and suggested I try it. What equipment will I need to invest in, and what do I need to know going in to it. If you could make a video on that or reply giving me info, I'd greatly appreciate it

[@Cougardifference]

Hey Xi, you the video covers the kind of equipment, supplies and accessories you need. Any of the hot water units can get this done. You can see our mobile units here: cougarchemical.com/collections/trailer-mounted-pressure-washers We have a pretty good gallery of mobile units that we have done that you can take a look at here: cougarchemical.com/pages/equipment-photo-gallery If you have any questions, don't hesitate to give us a call at 800-467-3270

[@jhonvelazques1829]

how can i get all that work equipment?

[@Cougardifference]

Call us at 901-362-8373 or visit www.cougarchemical.com

[@erickevin7711]

Can you send me a link to get that little twister peace

[@Cougardifference]

cougarchemical.com/products/roll-over-nozzle?_pos=1&_sid=57093e8e9&_ss=r

[@jeremyparmely4246]

Do you have to use hot water

[@Cougardifference]

It does help. Without the heat, you may have to brush a little. Imagine doing dishes with cold water. It just does not work as well.

[@davidmunoz6845]

What would be best for washing away the butter fat that spills over and sticks to the exterior of the tank trailers?? #MilkHaulers#CreamHaulers

[@Cougardifference]

The hot water power washer will do most of the work. I'd recommend a stout degreaser like our Formula #10, Heavy Duty Degreaser.

[@andreharris3118]

Not practical for a large fleet wash, how do you get in between the truck using the long wand, do you have to switch wands each time the washer comes from in between? also if you use 35 gallons of fresh water per tractor and half gallon of chemical per tractor, it wouldnt be cost affective for a fleet of say 200 units. Considering the extremily high cost of your chemical. you would have to charge $100 per unit. What about Trailors, School busses ect? and as slow as your demo guy is moving, it would take a month to wash a fleet. Please clarify

[@daftnord4957]

a commercial washing place charges $120 to acid wash aluminum livestock trailers

[@arthurmabry6167]

where can i buy the chem. at?

[@Bubbagump89]

How can get some products from y’all?

[@Cougardifference]

Email us at [e-mail]

[@JD-dw1dr]

How long does the 55 Gallon of soap chemical last?

[@Cougardifference]

That depends a lot on your water quality, your skill and how dirty the truck is. With experience, you should be able to complete a tractor with less than a gallon of acid and a gallon of detergent.

[@ffdoingwork7845]

Is there an optimal water temp?

[@Cougardifference]

Great question! 140° is a sweet spot that is effective and fuel efficient.

[@ffdoingwork7845]

@@Cougardifference Awesome thank you for your reply. Any suggestions on a add on heater for existing pressure washer setup.

[@rickheer8895]

How much is investment I am looking to start in Hamilton ontario and how to find customer...

[@samiullahahmed5498]

Literally go to truck yards on a sunny weekend, and you’ll 100% find someone who wants to get their truck washed

[@andrewhal9720]

Did you open your business in Hamilton ?

[@surenderjuneja58]

Hi , how can i strat mobile truck wash business

[@sukhdeepsingh81820]

How much wash pump?

[@Cougardifference]

We can put a rig together a system to fit most budgets. You can see what we offer here: cougarchemical.com/collections/start-your-own-business

[@gusbiesecker8677]

I have two questions for you! So you said the acid cleaner should be low pressure and only through the hose. But what if I just increase the pressure for the alkaline cleaner, but make it inject through the hose and not the pump, will that still work? Also, what ratios are the two cleaners coming out at. Thanks!

[@kleenkarzautodetailingllc3733]

When I first started 2 step washing, I used foam canons to apply each step and then high pressured off. My business started growing so I plumbed my acid and citrus thru my machine to be more efficient. I downstream the acid because it will damage your pump. I upstream the citrus with high pressure hot water only if the truck is bad because it just increases the cleaning power. If it isn't bad, I apply both and cold rinse 15 minutes I'm done. I hope this helped you out my friend.

[@FIERRON381]

Awesome

[@Champion5150]

So you guys don't use DI water I believe you cannot run DI water on a hot pressure washer

[@mikejohnson699]

The truck will never really get cleaned this way. Lazy wash.

[@Cougardifference]

Come to Memphis and we will let you give it a try just to prove how wrong you are. Our equipment, chemical and process work.