2001-2011 Crown Vic Gas Tank Replacement

[@0rnery]

Really nice presentation. Greatly appreciated. Hoping my '06 Town Car isn't far different.

[@miguelmaldonado9881]

They still have those lines with the valves available at Ford, checked couple days ago

[@kph419]

Wouldn't happen to have a part # would you?

[@brendasprague4136]

😮😂😂😂😂😂😮😂😂

[@quintongill9685]

Getting that damn friction fit valve out of my 2011 cvpi was hell, i snapped the plastic twice but it still works fine

[@TN1337X]

Great video, Thank you

[@ke8150]

I have a 2007 crown vic and i have to do a tank replacement but my gas gauge needle is all over the place not reading correctly

[@thebiggerman6975]

My grandsons 2011 cvpi needs a fuel tank but I'm confused about the tank pressure sender, it seems to be installed in the tank ,not in the hose set up as shown every where, Its hard to see but I put a fuel pump in it a while ago and it definitely does not have that large connector you show, have you run into this Thanks

[@CuttyBoy85]

What you used to take the clamps off the fuel lines

[@gastankrenuersoninc9540]

Fuel line release tool

[@Quanie156]

What is the length of the bolt. What millimeter. Thank you

[@MrScott426]

I've got a real gem here. The one I have the straps rotted and the tank fell off. The tank was crushed damaging the pump assembly and the large vent valve. Can anyone tell me where I can find a replacement valve for the 42E tank?

[@victormiesner7804]

Salvage yard, maybe

[@richardloach610]

Can i do this with floor jacks, stands? Is there enough clearance?

[@gastankrenuersoninc9540]

Maybe, it would be tough.

[@billyd2780]

Where can I get a grommet for the pressure regulator?

[@ralphybingham8986]

have you figured this out? looking dor the grommet myself ordered the 42E accidentaly.

[@jerryjenkins7508]

What the name of that hoses on top of the gas tank been trying to order it

[@gastankrenuersoninc9540]

The big one is the fuel / air valve and the small one is the roll valve

[@bunnyhall116]

He doesnt know aparently...

[@abramherrera1362]

What can I do if the quick connect on the passenger side breaks of

[@user-sw2jk3vo3y]

About how much is a job like this?

[@thebiggerman6975]

Whatever it is If I was closer, I would pay it, no worse job than a fuel tank in my opinion

[@napier1741]

My tank is leaking got a new one ordered

[@durdeydolla1]

How did you air test it?

[@gastankrenuersoninc9540]

cap off all holes and use a blow gun thru the main vent line. Use some soapy water around the fuel pump and fittings and use 3-5 psi to check for leaks. Don't use too much air or you may end up getting the fuel / air valve stuck in the up position and then it won't take gas.

[@JohnSmith-xx1lx]

@@gastankrenuersoninc9540 Could use a bike pump instead for lower psi?

[@jodyrobinson5122]

They make it as difficult as possable