Just a quick video to show you how to remove the rear bumper on a gen 2 Honda CR-V.
Пікірлер: 19
@MaximumDIYGarage3 жыл бұрын
Excellent video! Thanks! I was just thinking about pulling the bumper off last week to inspect the rear fender for rust. I have spotted the very beginning of paint bubbling where the rear part of the fender meets the bumper. I want to jump on it ahead of time to prevent having issue in the future. This is an area where dirt and gravel builds up on the inner lip of the fender well and collects moisture that eventually causes corrosion.
@HeartSoulLeake3 жыл бұрын
Rear Bumper Cover For 2005 Honda Crv Ex body shop wanted to charge $95 to do this. I believe that this simple enough to do myself. Especially since you provided these instructions. I may need a few of the bumper clips. There is a screw that secures the little red bumper cover reflectors. The screws on our were rusted to the point where the head was degraded. it took some WD-40 and a pair of needle nose wire clippers to grab the head and slowly unscrew them without damaging reflector frame.
@JackofAllMasterofNone3 жыл бұрын
It's super easy
@MrMadlionsmith2 жыл бұрын
Just the vid I was looking for thanks.
@jcorpus2093 ай бұрын
Thank you Sir!
@alvarovenegas54262 ай бұрын
I was really hoping to see you take it off all the way. I wanted to see what's under there. I bought mine salvaged and there is nothing under the rear bumper to cushion a rear impact. No rear bumper reinforcement bar or anything, just a fragile bumper cover which would do nothing in case of an accident! That scares me a bit!
@JackofAllMasterofNone2 ай бұрын
Yeah they're supposed to be a bumper under there
@jonathanthoj89622 жыл бұрын
I need a video on "how to take out the fender liner" for 2006 CR-V so I can install rock light LED RBG on my CR-V.
@Disproving3 жыл бұрын
Thank you I just replaced my font couldn’t find a video on the back so this is wonderful. 😁
@davedowning22 жыл бұрын
Do you have any video with the bumper cover completely removed? Wanting to see how it is designed back there. Can't find anything about bumper rebar or impact rail. Thanks
@JackofAllMasterofNone2 жыл бұрын
No I don't.. sorry
@davedowning22 жыл бұрын
@@JackofAllMasterofNone thanks for responding
@8754roberto2 жыл бұрын
Thank you 😊
@pitwoman13 жыл бұрын
You didn't by any chance make a video about how you got the dent out of the bumper cover did you? I have almost the exact same dent in mine. If not, could you tell me if/how you did it? Thanks! Getting the old one off is a good start. Thanks for that!
@JackofAllMasterofNone3 жыл бұрын
I heated it up slightly with a heat gun and then gave it one good whack with a rubber mallet from the inside and it popped right out.
@pitwoman13 жыл бұрын
@@JackofAllMasterofNone thanks! Will give it a try with a whack