2002 Ford Focus ST 2.0L Petrol Clutch Replacement

[@antn8387]

You're a champion doing this in one go...I'm on day 3 for mine.

[@opexo]

very nice, i wish this video came out like a month earlier than end of Feb'19. Dropping the subframe really helps very much otherwise its a big struggle to wiggle the box out and especially in. The only concern after that, and its real, is that the subframe can be misaligned after that so its better to mark its original position with paint, preferably spray in appropriate color.

[@malcolmgray.5913]

I’ve got my ST170 up and ready to change it’s clutch. Going from the Ford Australia factory workshop manual they are saying to drop the whole subframe, drain and disconnect the power steering. I like this method and had watched this before I looked at the manual. I’ll still drop my sub for cleaning/painting and to look for a cause of a steering knock, but this will be great for my other low k car (who’s clutch I also blew) I’m Installing the RTS/Turbosport single mass fly/clutch kit.The ARP flywheel bolts I got are have a flat head and fasten with a socket. I’ve never done a clutch this helps a whole lot, thanks!

[@DanielPerez-ln4vu]

Rare video. All videos are for TDCI , not for Petrol 2.0 . Thank you

[@kylejulies1692]

Awesome video dude

[@jjmmjj9999]

very impressed. Subscribed.

[@WMCS]

Jake S thanks

[@walleyman9915]

Best !!!

[@anthonymartinez1533]

Cuanto tiempo tardaste en cambiarlo?

[@sem23200]

Wish you had a video for the st225 clutch your video are quality and cant find a decent video for the st225

[@WMCS]

There’s the mondeo version of it on channels playlist if I’m not mistaken.

[@sem23200]

​@WMCS I can't find it mate I know you've done the diesel mondeo st just looking at doing my 2.5 st clutch (done a few clutches myself before) but the st 2.5 clutch looks a nightmare

[@carlosbenes7880]

Where are all the screws that hold the Manuel transmission for a Ford Focus SE 2.0 2006

[@duanewhitmore3175]

Hi mate how long did it take you to do all of that???

[@baggedranger93]

Do you remember what size torx was used to Remove the flywheel

[@WMCS]

Bryan Wagner it’s a T55... but on the later model it’s a female torx 45... hope that helps.

[@parsifal3552]

Thanks for the video. I've never fixed any cars myself. I want to ask you. How much torque should be applied to the clutch screw to tighten it? And I saw the whole demolition process was very complicated. For a rookie. How to put them back after they've been taken apart? I feel like even though I'm familiar with the demolition process. I might get confused when I reverse-install it.

[@WMCS]

Hi Xi Chen ... The process is not too bad if tackled with much patience... On this particular model a lot of bits are in the way of the two top bolts only. Once they are out. You should be fine.

[@divljacina1]

when will you change the rest of the car :)

[@WMCS]

Soon

[@divljacina1]

@@WMCS 😁😁😁😁😁

[@WMCS]

✨🍻😁

[@anthonymartinez1533]

Estoy por empezar a cambiar el de mi carro por eso estoy buscando como a serlo gracias 🙏🏼