Thank you sir..... just wish he would enjoy it more!
@scrapbaby68634 жыл бұрын
So what other gaskets are required for this job besides the water pump and case gaskets?
@moto4life14 жыл бұрын
Should be a coolant copper washer replaced on coolant drain/check bolt. Also should replace o-rings on the pump propeller shaft if worn or just do it anyway saves time and money
@scrapbaby68634 жыл бұрын
@@moto4life1 Thanks for the reply I do not see the o rings you are talking about on the parts diagram for my 2004 model.. Also do you recommend changing the kick start oil seal?
@moto4life14 жыл бұрын
just check for any movement/play at the water pump shaft- end by propeller-up/down-side/side movement. as far as kickstart, if did leak before probably not!, though its old and after you seen one too many its easier judge, ya know. sogo ahead and replace it, then you won't worry about it later.. And thank you I like helping as much as possible and maybe I will start some instructional videos. always easier shown! Have a great day!
@evilkin99975 жыл бұрын
What year is the bike
@moto4life15 жыл бұрын
2004 and I do believe years 1999-2005 are the same . sorry about taking forever to reply.
@robbieforster30217 жыл бұрын
what was point of that ye never showed how ro take basket off.....dohhhh
@moto4life17 жыл бұрын
because we were better at working on bikes than recording videos duhhhhh
@derrickromero70687 жыл бұрын
how did you hold the clutch from turning when removing that last big bolt
@moto4life17 жыл бұрын
Derrick Romero we used a impact gun to remove that bolt otherwise have to remove cover from opposite side and use the nut to hold you clutch from moving
@pilotmatt79405 жыл бұрын
Moto4life do you mean take off the stater cover or something on the clutch side still? Bc I cannot get mine off and I’ve used a impact and nothing happens.
@adz69737 жыл бұрын
What the difference between pop it off and pull it off?
@moto4life16 жыл бұрын
find that most of the time pulling only ensues "usually" pulling internals with, such as the water pump shaft that could easily damage the seals. just a trick i've used since doing this clutch
@JEREMY420798 жыл бұрын
Where are the other videos ?
@moto4life16 жыл бұрын
Late reply sorry. Marcus did a lot of Mx Racing that year and we just got busy . you can call me captain slacker haha