Hi, I would like to open the valve cover to check the timing chain and change the gasket as I am also leaking a little oil. I have already changed the oil and the oil filter. If I open the valve cover will the oil flow? I don't know what to expect. The oil should still be in the sump, right?
@Papane12 ай бұрын
I have a 2014 Hyundai Tucson 2.4L Limited. with an oil leak coming from the valve cover gasket. I could smell burning oil from it running down onto the exhaust manifold heat shield. A few posts suggest that the high pressure fuel line and fuel pump installation bolts should be replaced at the same time as their one time use. Others suggest that since the fuel pump isn't being replaced, that torqued to spec is more then suffice. Are these parts necessary to be replaced for a simple valve cover gasket replacement? Or should I continue to top up engine oil and hold off til I can source parts?
@SEsGarage2 ай бұрын
You’re referring to the high pressure fuel pipe that goes from the pump to the injector rail. That is technically a one time use pipe and “should” be replaced.
@jesusnoperi258410 ай бұрын
Good video
@MrSparkums7 ай бұрын
Great vid.. Do you prefer the Fel Pro over Mahle? Thanks
@SEsGarage7 ай бұрын
I’d use either or! Which ever is cheaper!
@edman1015 Жыл бұрын
Good Job and I like those side lift jacks for changing oil.
@SEsGarage Жыл бұрын
Our newest edition to the garage! Makes working on cars in the garage a total breeze!
@danielnolley68723 ай бұрын
Where can I get them at I want a set @@SEsGarage
@lrncephil804 ай бұрын
Its probably too late, but can you do a video show your method of cleaning the old oil off?
@airquad19296 ай бұрын
How are you going to pinch the gasket by putting it in cover???What do you mean by this comment?
@LarryIsbell-bu8tz6 ай бұрын
Hypothetically let’s say the bolt by the #3 coil broke off. How effed am I?
@SEsGarage6 ай бұрын
Hypothetically if it’s the bolt that holds the coil down I’d attempt to drill it out and extract with an extractor
@LarryIsbell-bu8tz6 ай бұрын
It’s the bolt that holds the valve cover down. It’s just one of the center bolts by the coils. Can i still drill it?
@SEsGarage6 ай бұрын
@@LarryIsbell-bu8tz pull the valve cover back off and see how it broke. If it’s flush drilling is your only option. If it’s sticking out a bit you may be able to grab it with a turbo socket or vice grips
@JoséBracamontes-z5n22 күн бұрын
No c ve lo q estas aciendo
@jmcnallyua6 ай бұрын
I have a question I have a 2012 Kia forte with that same motor but I was wondering what is the torque rating should I set the bolts at on the valve cover cuz I'm going to be replacing my valve cover gasket because mine is leaking into the spark plug Wells anyway keep up the amazing KZbin video