2006 Sprinter Window Regulator Repair - No More Plastic Slides

Rather than replace another window regulator with the same weak plastic slide, I decided to order these brass replacements. This video shows the steps to perform the repair. Here is my affiliate link to purchase these parts. If this video helped you please consider subscribing and using this link to purchase! Thanks for watching! Here is the revised link to the devices I ordered:
amzn.to/3RSKRkK

[@deezynar]

Thank you very much, sir. I took my door apart and could not believe what a substandard piece of junk Mercedes passed on to their customers. My gut tells me that the engine and tranny on this van will outlive me, but everything is falling apart. I will try to get this repair done in the near future, and I'll let you know how it goes. I have read all of the comments here, and see that there is some issue with some of the replacement parts not fitting right. I will be careful about checking the size of the part i get before I put it on. But most of all, I won't complain to you if the part isn't right. That's not your fault.

[@photowhit177]

Incredible help. Thank you so much for making this video. ❤

[@JIMENHEN]

Hi Scott I try your link with amazon to try to purchase the replacement parts but amazon says they could not find the page, do you have the part number by any chance?

[@Elnamech]

Hi Henry. Thanks for letting me know. I changed the link to a newer listing as that old one was taken down. This one is less money and should not require trimming the bolt. amzn.to/3pzo918

[@michellemcmenamin9676]

Hi Scott, We ordered 2 of the parts from the new link and they are too small. The actuator arm gets detached as the window is raised and lowered 2005 sprinter van drivers door Any hints of where to find the other part that fits?

[@brianasamuels]

I simply drilled out the post and used a 1 inch carriage bolt with a nylon washer and two nuts.

[@Alex-pd4xw]

Can you tell me the diameter of the nylon washer you used?

[@brianasamuels]

@@Alex-pd4xw It was slightly larger than the carriage bolt head. Unfortunately I did not measure either.