I made this for opinions on if I should adjust the pinion after I replaced the sprague.
Пікірлер: 14
@eyeorewolf26 күн бұрын
There's a gap in the case on the right side of the image.
@danreck68087 жыл бұрын
armature plate not installed into lower groves of ring gear, you put in in groves of roller cage and rested it on the higher plane of the ring gear. rotate armature to where it is in the lowest position on the ring gear.
@jeepunfool12 жыл бұрын
No, it was the armature plate. It was supposed to sit in grooves and some notches in the ring gear. I wasnt putting it in the notches.
@chrisbradley5092 жыл бұрын
i had to turn the bearing cage over to get the notches to line up and allow the sprague to drop into the lower notches
@danreck68087 жыл бұрын
line up the groves on your roller cage for armature plate with the lower notches on ring gear face.
@JamesNixon-ec5ob11 ай бұрын
Did you ever figure this out
@FJ80Coop12 жыл бұрын
Does it have side shims??If it does,I would swap them side to side,or if it has thrust washers,check them for thicknesses n see if swapping them around helps loosen it up as the mesh is too tight once you bolt the halves together...
@kevinbrown603710 жыл бұрын
I have to change the front diff bearings have not seen a video on how to do that wish I could find one
@timhill37406 жыл бұрын
How can I check that it is being energized when I apply voltage?
@jeepunfool6 жыл бұрын
James Hill use a volt meter at the plug and see if you are getting power when you flip the switch.
@hess40010 жыл бұрын
Is it possible to slide the prop shaft out and replace it ?